Having problems with your ViewSonic VX924 19" LCD Monitor ?

Need help with Viewsonic VX924

\015 I have picked up a faulty VX924 that doesn't power up because the internal cable between the control panel and the logic PCB is missing. Why ? I have no idea. Somebody took it out.\015\012If any of you who have opened it up to replace the notoriously bad electrolitic caps could describe the wiring of the cable, I might have a chance to get this to work. It only takes 4 screws to remove the back cover. Please !?\015\012The logic PCB side has a 10-pin connector and the control panel has only an 8-pin connector, so this rules out "straight-through" as an answer. \015\012Any help would be appreciated.\015

Answers :

The connector is *almost straight* thru'
square pan being considered 1 on both boards.
1 - 1
2 - 2
3 - 3
4 and 5 are not connected on the logic board
4 - 6
5 - 7
6 - 8
7 - 9
8 - 10
9 - 11
10 - 12

I have the same problem - The power supply is providing 12 VDC
I'm assuming that the backlight isn't a problem
The capacitors do look a little fatter!

On the PSU there are 2 large 470uF/25VDC that may be suspect. (C660 and C664)
I can read 12VDC but I think the logic board is the problem - There are 2 330uF/16VDC - Maybe 16VDC is too marginal??
Hope this helps

10 pin top to bottom connecting at right hand side; colours = bla,bro,red, X X ora,yel,gre,blu,purple
\015\0128 pin left to right connecting at top ; purple, blu, gre,yel,ora,red,bro,bla
Repair Help & Product Troubleshooting for ViewSonic VX924 19" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need help with Viewsonic VX924

The connector is *almost straight* thru'square pan being considered 1 on both boards.1 - 12 - 23 - 34 and 5 are not connected on the logic board4 - 65 - 76 - 87 - 98 - 109 - 1110 ... ViewSonic VX924 19" LCD Monitor

My VX924 Green Led Blinks until fully booted to windows

Ok if what im understanding is you tried on another computer and it worked great \015\012the monitor is not your problem the problem lies with your video card\015\012the video card could be outdated\015\012the video card could need ... ViewSonic VX924 19" LCD Monitor

TURNS ON AN OFF CONSISTANLY FOR 20-30 MINS - ViewSonic VX924 19" LCD Monitor

Hello,The issues you are having are caused by capacitors on the power board. They are in the process of failing and that is why it turns on and off until they stabilize. If you check out this page on our web site: ... ViewSonic VX924 19" LCD Monitor

Custom Building Gaming Question

7900 nvidia gt video card is could be overheating, no warranty anymore. It is causing blue and red random spots, and alot of big polygons and cylinders during game play. Updated drivers for everything twice and not luck...? anyone? ... Dynex (DX-500CC) ATX Mid-Tower Case

Lenovo system - Viewsonic display CONFLICTt

Yup. possibly a SW conflict. what you can do is to uninstall your video card driver and see if it runs properly under vga.sys driver (microsoft default) if it doesn't run, then you have a hardware problem.you can come back to me anytime ... IBM ThinkCentre A50p PC Desktop

I need help setting up the DVI input.

Hi,\015\012\015\012There are two ways to do this.\015\012\015\012First and simplest is to simply shutdown the pc, disconnect the analog from the back of your PC and connect the DVI cable to the PC and monitor. When you turn i ... ViewSonic VX924 19" LCD Monitor

ViewSonic VX924 problems

Remove the four screw (one in each corner) and then using a fine wide flat blade you need to prise open the case at each side mid-point. The case is clippe together with plastic lugs that retains the rear cover. I started on the right side side and ... ViewSonic VX924 19" LCD Monitor

Need help i have viewsonic monitor model E70F i need part no. of Q407 My mail : [email protected] thank you

Engm_azazy, Viewsonic has a lost of parts that they can give you. I would recommend to call their parts team to help out. 1-877-BIRDS4Upiolo2,Im sorry man but your monitor is shot. If it works on ... ViewSonic E70f 17" CRT Monitor

Hello viewsonic vx2235wm no power

Hello,The Viewsonic VX2235WM has a known issue with the power supply going out. The flashing power light or not turning on is the classic symptoms of this issue. Check out our web site at: ... ViewSonic VX2235wm LCD Monitor

Viewsonic ve150m problem white screen

Are you still using the same computer that was set to 200Hz? If so,\015\012start Windoze in safe mode and reset the display properties to 1024 x\015\012768 60Hz. Reboot the computer and everything should be OK.\015\012\015\012Does this mo ... Epson Viewsonic ViewPanel VE150M Monitor

My ViewSonic computer monitor keeps displaying a Vga Not Support Message upon booting then the message Out Of Range comes up on a completely dark screen. Need Help

It sounds like the computer is trying to use a resolution that the monitor cannot handle. Boot into safe mode by pressing the f8 key during boot up and select safe mode. Once booted, right click on the desktop and select properties. In settings lower ... ViewSonic VA721 17" LCD Monitor

I have a ViewSonic VA703B, I need to get it working but I cannot get the back of. How can I get the back of.?

I have a ViewSonic VA703B, I need to get it working but I cannot get the back of. How can I get the back of.?\012 This trouble maybe power supply or inverter boards is defective.\012 first you can test the voltage of the multr,and then check whic ... ViewSonic VA703B LCD Monitor

I have a viewsonic VX910 and the picture goes off and on. Picture lasts less than a second. I replaced the 3 caps but no good. I measured some power points on the PSU and see the drop, even the A/C drops but I ruled the A/C out. I need a solution. This my favorite monitor.

Hello,This could be caused by a few things. First, be sure the capacitors you used are low ESR. You can't use capacitors from Radio Shack, they can damage the electronics. Second, on the bottom of the power supply board you will find 4 tr ... ViewSonic VX910 19" LCD Monitor

ViewSonic VG500 wiring configuration?

It is pretty difficult to solder on a new DB-15 connector, the easiest way to do it would be to take apart the back of the monitor and de-solder it off the video controller in there. Each contact will be labeled and a replacement DB-15 cable with co ... ViewSonic VG500b (Black) 15" LCD Monitor

I want to repair my dead monitor. Can somebody help me and explain how to remove the back cover to access the electronic board of Viewsonic LCD Monitor Model VG 700. Thanks

First take the speaker cover off the front by working it from the top of the cover on both sides with your fingers. It should snap out top first. Then unplug the cable that connects from the main board to the cover. After that take out the 2 screws f ... ViewSonic VG700 17" Flat Panel LCD Monitor

Viewsonic Tablet PC keyboard issue.

Try reseating the cable that connects the keyboard first. \015\012\015\012If that doesnt help there may be liquid around the connector and it needs to be cleaned off to keep the circuit from shorting out. You will need to find someone wit ... HP Pavilion dv4000 Notebook

Viewsonic VX2265wm 12o Hz monitor

Hello ... PC Desktops


Hello, To disassemble your monitor follow these steps.1. Remove the\015\012stand, usually 2 to 4 screws 2. Now there will be screws in each corner\015\012on the back of the monitor. 3. Take a small flat blade screw driver and\ ... ViewSonic Pro VP2130b 21.3" LCD Monitor

Bad pcb power board on viewsonic vx924 (VS10162)

Try http://www.lcdparts.net/LIPSInverterDetail.aspx?InverterOriginal=FSP035-1PI01 ... ViewSonic VX924 19" LCD Monitor

Viewsonic VP2030b LCD monitor - No power

There should be one fuse in the power supply inside. You can check and replace that if its dead. now if its not dead and you got power to that point you do need to rule out any capcitors at that time but if the fuse is gone it will not hurt to check ... ViewSonic VP2000s 20.1" Flat Panel LCD Monitor

How do you remove the outer case on Viewsonic VG930M-3 LCD

Kauffman014, As far as opening the monitor up you may want to visit YOUTUBE and search for lcd monitor repair/ disassembling monitor/ or something like that. I did see a 9-11 min video there that was fairly good on un-snapping the rear cover from th ... ViewSonic VA1930WM LCD Monitor

ViewSonic Vx924 No power

Hello,If youcan take a picture or two of the boards in your system as close and clear as you can and go to our web page and email them to me I will check and see if we can help you find the problem.Buddy Corporate Comput ... ViewSonic VX924 19" LCD Monitor

Viewsonic 21", P817 won't stay on.

Try hooking up a known good working monitor to the computer and see if the monitor turns on and stays on with video.If it does then you know there is a definite problem with the Sony monitor. Next step would be to open up the monitor and ... Sony GDM-W900 24" CRT Monitor

VX922 19" Monitor -Terrible customer service by ViewSonic

The only advice that I have on this issue would be to call ViewSonic again and as soon as you get a Rep on the phone you need to ask for a supervisor. In the event that the supervisor is not helping you ask to speak to his supervisor. Make a point to ... ViewSonic VX922 19" Monitor Flat Panel

Viewsonic VX922 19" Green Light Blinks when booted, no picture

I have the same problem with my VX922 as do MANY others. The problem seems to be caused by leaking/bulging capacitors on the circuit board. The only solution is to replace the faulty capacitors either on your own (which is fairly easy if you're good ... ViewSonic VX922 19" Monitor Flat Panel
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6892 seconds