Having problems with your StarTech.com CCTUBEGN 12.5''TUBE Fluorescent Lamp Kit ?

How to replace a tube holder or ballast

\015 How do I replace a tube holder or ballast in a florescent light?\015

Answers :

You can replace a ballast or tube holder if you're fairly familiar with wiring.\015\012\015\0121) Turn off the power to the circuit.\015\012\015\0122) Remove the tube and the cover plate that conceals the workings.\015\012\015\0123) Disconnect or cut the wires to the tube holder or ballast and remove.\015\012\015\0124) Strip 1/2" of insulation from the ends of the wires.\015\012\015\0125) Mount the component and connect the wires with wire nuts.\015\012\015\0126) Replace the cover and tube.\015\012\015\0127) Turn the circuit back on.\015\012\015\0128) Turn the switch on.
Repair Help & Product Troubleshooting for StarTech.com CCTUBEGN 12.5''TUBE Fluorescent Lamp Kit

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When to replace


Inside a fluorescent light, electricity is delivered to a ballast, which sends a spark through the mercury-vapor-filled tube (or bulb), creating light by activating phosphors that coat the inside of the tube. If any of the components are faulty, the ... StarTech.com CCTUBEGN 12.5''TUBE Fluorescent Lamp Kit

How to replace a tube holder or ballast


You can replace a ballast or tube holder if you're fairly familiar with wiring.\015\012\015\0121) Turn off the power to the circuit.\015\012\015\0122) Remove the tube and the cover plate that conceals the workings.\015\012\015\0123) Disconnect or cut ... StarTech.com CCTUBEGN 12.5''TUBE Fluorescent Lamp Kit

How to replace a fluorescent starter


Although newer fluorescent fixtures have built-in starters or no starters at all, most older lights have an easy-to-change, visible starter. It is a small, silvery cylinder that plugs into one of the tube holders.\015\012\015\0121) Shut off the switc ... StarTech.com CCTUBEGN 12.5''TUBE Fluorescent Lamp Kit

Screen flashes - samsung 215tw LCD monitor


Walkstex, I will answer the last ? first. All LCD monitors WILL NEED to have their "cold-cathode-fluorescent-tubes" replaced!!! As long as your display had a Bright, Crisp image displayed on it before this "FLASHING" symptom occured, then you don't n ... Samsung SyncMaster 215TW 21" LCD Monitor

Computer brightness just dissapeared randomly and brightness and contrast is at 100% can still see the screen but just barely


If you have a laptop or, flat screen monitor; as, opposed to a CRT monitor[. your screen brightness is provided by one or, two tiny fluorescent tubes commonly known as a "cold cathode" these are powered by a circuit board known as an inverter board ... PC Desktops

Gateway monitor, black screen with blinking power button


Wjfarm48, Sure sounds like a power supply problem. How old is it? How many hours of use? Do you understand what a switch-mode-power-supply and an inverter supply is? If not, then here are your options. Check with Gateway to see if there is a swapou ... Gateway FPD1960 19" Flat Panel LCD Monitor

I what order do I remove the screws to remove the back cover to replace the power jack???


No, not even!You have to completely disassemble the laptop, down to the bare motherboard in your hand!Involves removing all electrical sources first. Battery and AC adapter, (Charger) You should buy a cheap ESD wrist strap, an ... PC Laptops

After 5 minutes monitor screen dims--can faintly see the windows screen and then it flickers out and there is nothing. Any ideas?


The monitor may be going into power save mode which it should come out of when you press a key or move the mouse but it sounds like you have tube inverter issues.\015\012Your screen has light tubes behind it to illuminate the screen, if the tubes or ... ViewSonic VG900b 19" LCD Monitor

My X2gen MW19R monitor goes to black while I am working. I have checked the connections and they seem to be tight. What is causing this to happen? When it happens I turn the screen off, then back on to see the information again, only to have it turn to black in anywhere from 2 to 30 minutes.


It is most likley the cfl tubes - and - or - the inverter is bad. This will happen sooner or later with all lcd monitors that do not have the L.E.D. back lights. It is very frustrating and timely to replace the items yourself unles you absolutly know ... X2Gen MW22U Monitor

Replacing CCFL Tube


I've repaired 1000+ Toshiba and replacing the FL tube is something I would never attempt to do because of how hard they make it to do. Generally there is a FL Inverter below the LCD that goes bad which causes the backlight not to light up correctly. ... Toshiba Satellite A135 Notebook

No display lights


There are two possibilities, neither is really for a novice. TURN OFF LAPTOP, REMOVE AC PSU AND BATTERYOpen the laptop lid and check the thin ribbon cable (looks like dirty yellow or orange scotch tape with several small thin ... Gateway SL9550-30165318 Notebook

Dell monitor keeps turning off...


Hello,The problem you are experiencing is quite common, however the solution can be expensive and frustrating if you are not sure what you are doing. The problem is due to usually 1 of 2 things but the result is the same. The result is that the ... Computer Monitors

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Toshiba A200 Notebook Computer Screen Black Out


LCD monitor work based on backlight illumination, they have a fluorescent tube of high intensity usually located at the bottom ot top of the monitor sometimes they may even have two of these one on each side or on top and on the bottom of the screen, ... Toshiba Satellite A200-0ET00X Notebook

Screen got a quick white flash the goes blank everytime you press power button _ What caused that problem ?


Sounds like the cfl tubes are bad - they are\015\012like a shop florescent tubes very small that could be 2 to 4 tubes but most\015\012have just 2 - one on the top and one on the bottom that should also be replaced\015\012with the inverte ... Dell UltraSharp 1703FP Flat panel TFT 17" Monitor

Got two 5610 s power supply socket pins have broken off in both units no one wants to repair them


Reasoning?1.The DC Power Jack, (DC-IN), is located on the corner of the motherboard. The motherboard is a circuit board. Circuit boards for laptops are not of good quality, compared to a desktop computer motherboard. They crack easily. ... Acer Aspire 5610-4648 Notebook

My Dell Inspiron E1705 screen went blank. I can hook it up to a PC monitor and it works fine....just bulky as hell.....Help


Sounds like your CFL tube or the inverter than powers the CFL tube have died. It is something that a standard dell warranty would cover, first go to www.support.dell.com click ... Dell Inspiron 1501 Notebook

Black screen on acer 242lc lights come on power up


You indicate that the lamp for Power On comes on? (Light bulb icon) What about the harddrive activity lamp? (Media Activity icon. Looks like a book. Third icon going right, from Light bulb icon) Is this lamp lit up? (May flash ... Acer TravelMate 242LC Notebook

Subwoofer fuse 'holder' missing.


Tape or solder a piece of metal across where the fuze and holder would go.ORgo to radio shack, pick up a small cartridge style fuze holder and an appropriate replacement fuze. (if you dont have the original fuze, dont bother with this met ... Altec Lansing ADA 885 Computer Speakers

I can not boot into safe mode on my toshiba satellite laptop. HELP!! the processor was "fixed" by our local pc shop, and now i cant get windows vista to load at all.. it keeps going into startup repair mode, and cant not fix the problem. and i cant get into safe mode


Fixed??The only two things you can do for a Processor is to,A.Replace itB.Clean the top of the Processor case, and the bottom of the heatsink that sits on it. Then apply new thermal paste.I suggest you take this ba ... Toshiba Satellite A135-S2246 Notebook

My lcd backlight has burned out


There are four options. One is to replace the entire LCD Panel. Not cost effective but probably the easiest. Two is to replace the flourescent tube, but this requires unmounting the panel from the laptop, disassembling it, desoldering and soldering t ... Compaq Presario M2000 Notebook

No Display, monitor won't come on.


Hi try this or the site below\015\012Monitor Problems:\015\012\015\012THE COMPUTERS SEEMS TO BE WORKING, BUT THE SCREEN IS BLANK.\015\012- Check the monitor if turned on.\015\012- ... Dell Inspiron 1501 Notebook

Red tint on Viewsonic P930b


Hello,We do a lot of LCD monitor repairs and usually when you get the red tinted display it means the backlight tube is going out. This part is like a very small fluorescent tube just like in you office lamps. The tube is part of the disp ... ViewSonic VX924 19" LCD Monitor

Need a replacement LCD


Yes you can go to any tv engineer tell him to replace crt (picture tube) if he agree then purchase new picture tube and replace it if only cabinate is brocken then replace cabinate take care that the reparing cost will not exceed monitors cost if yo ... iiyama E-yama 17NE1 (Silver) Monitor

No color red displays.


If you think that electronic repair is very difficult to learn then you have to read this article where only by using a solder gun could solve a Monitor color problem. Of course there were many tough dog cases (very difficult to find out the fault) i ... ViewSonic G70fmb (Black) 17" CRT Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3582 seconds