Having problems with your Sceptre X20G-Naga II 20.1" Flat Panel LCD Monitor ?

MONITOR SCEPTRE X76 NAGA VI

\015 THE POWER SUPPLI NOT WORKING. THE 5 VOLTS NOT ARE PRESENT IN TOTALITY ONLY HAVE 3 AND 4.5 VOLTS I WANT NOW WHERE I QUENT FIND ANOTHER POWER SUPPLI\015

Answers :

Repair Help & Product Troubleshooting for Sceptre X20G-Naga II 20.1" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

MONITOR SCEPTRE X76 NAGA VI


... Sceptre X20G-Naga II 20.1" Flat Panel LCD Monitor

X20G-Naga III screen goes blank after 1-2 secs


FIXED!Device : Spectra X20WG-NagaProblem : monitor comes on then flickers then goes offsolution: Replace Capacitor C101 (150uf, 35V) and Fets U101 and U102 (4511GM)Comments: This is a common problem with this monitor. ... Sceptre X20g-Naga III 20.1" LCD Monitor

Sceptre X20G Naga II 20.1" Widescreen monitor


I am working on one of these for a customer. Found leaky cap on 5 volt power supply. replaced it, still no backlight. Looked at the inverter with an o-scope and it runs for a few seconds then shuts off. I hooked a ccfl across each of the transformer ... Sceptre X20G-Naga II 20.1" Flat Panel LCD Monitor

Need Sceptre X20g-Naga III 20.1" LCD Monitor Driver


... Sceptre X20g-Naga III 20.1" LCD Monitor

Screen goes blank


Yes, its not the bulbs, its the inverters that are build right into the power module and all that is wrong with that is one or more bad capacitors (bulging or burst) so don't waste $100 getting a new module from Sceptre, fix it yourself (if you have ... Sceptre 17" LCD Monitor

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Sceptre X22 Naga Will not power up. - Sceptre X20g-Naga III 20.1" LCD Monitor


Start looking at the power supply for bad caps, see some example of a couple yeras old monitors that failed due to cheap caps being used: http://s807.photobucke ... Sceptre X20g-Naga III 20.1" LCD Monitor

Does the sceptre x20wg-naga have a fuse? - Sceptre X20g-Naga III 20.1" LCD Monitor


... Sceptre X20g-Naga III 20.1" LCD Monitor

X20G-Naga III screen goes blank after 1-2 secs


Most common lcd monitor break down, check all electrolytic capacitors for leakage and loose board solder specially on the ccfl inverter section. ... Sceptre X20g-Naga III 20.1" LCD Monitor

My Sceptre X7S-Naga LCD monitor keeps shutting down...


... Sceptre X7s-Naga II Monitor

Montior Repeatedly Shuts Off/Goes Black


I have the same problem .already know what it is .its the cfl power inverters which are build into the power supplyeasy way to see is let the computer start up hold a flashlight up to the screen you should see your desktop .if so it ... Sceptre X9G-NagaIV 19" LCD Monitor

Monitor stays black until boot up to Desktop


You use a graphics card as your main output?and you have onboard graphics output too that you dont use?if so then you will have to plug your monitor lead into the onboard output socket to see bios. i think you need to go into bios and cha ... Sceptre X9G-NagaIV 19" LCD Monitor

Monitor turned black


Check some of the other posts as it is probably just a bad capacitor or two and very easy to fix if you can do that sort of thing. I did and mine is back up and running. ... Sceptre 17" LCD Monitor

NEED DRIVERS FOR THIS SCEPTREX9W MONITOR - Sceptre X9WG-Naga V / 19" / 8ms / 700:1 / WXGA+ 1440 x 900 / DVI-VGA / Black / Wide LCD Monitor


Http://www.sceptre.com/Support/index.htm\015\012\015\012click on the link near the top right of the page or try this one.\015\012\015\012 ... Sceptre X9WG-Naga V / 19" / 8ms / 700:1 / WXGA+ 1440 x 900 / DVI-VGA / Black / Wide LCD Monitor

Sceptre monitor x7g-nagaVI


Problem is 2 Capacitors on the power inverter board, at 1000 uf 16 volt. This one was on the model xg7-naga V 17 inch monitor. ... Sceptre 17" LCD Monitor

Lcd monitor repair or service manual


... Sceptre X20G-Naga II 20.1" Flat Panel LCD Monitor

X7G-Naga Sceptre 17" LCD Monitor


Try your monitor on a different computer and see if you get the same result, if not, there is a problem with your pc operating system and or video card. If you get the same result, get a new lcd if it is not under warranty. ... Sceptre 17" LCD Monitor

Sceptre X7G-Naga VI


My problem sounds equivelant: The problem is that it will power down after 15 minutes, then take 1/2 hour or more to power back up!I believe I have solved my problem with my X7G! I remember seeing a direction on the only direction papaer I got with ... Sceptre 17" LCD Monitor

Need a driver for monitor - Sceptre X7s-Naga II Monitor


Http://www.sceptre.com/Support/FTP/monitors.htm ... Sceptre X7s-Naga II Monitor

32" Sceptre LCD No POwer


\015\012This is the same problem I am having with my Speptre X20WG Naga Monitor.\015\012The power LEDS are usually red in standby and blue in opp; but now ... Sceptre X20g-Naga III 20.1" LCD Monitor

I have a sceptre x9g-naga III


Not an expert, but from what Ive read, this is a cfl inverter issue. I had the same problem on my Sceptre. Good luck finding parts. My solution: get another monitor. ... Sceptre X9G-NagaIV 19" LCD Monitor

Need video driver - Sceptre X20g-Naga III 20.1" LCD Monitor


Hi,\015\012 \015\012Just go to this link for the same.\015\012http://www.opendrivers.com/search.php ... Sceptre X20g-Naga III 20.1" LCD Monitor

X20 Naga II 20.1" Widescreen


... Sceptre X20G-Naga II 20.1" Flat Panel LCD Monitor

Sceptre X7g Monitor Flashing Red & Blue Lights. Blank Screen


I fixed this problem by unplugging the monitor, unplugging the video cables. Then hold down the power button while plugging it back in. Release power button and then press power button for on. It worked then. I got the icon for no signal, i plug ... Sceptre X7GNAGAV 17" LCD Monitor

Sceptre X9G Komodo IV


I have a 19" Sceptre Comodo display. After 3 years it got the problem everybody complains about. Took it apart yesterday.There are 4 capacitors in a row on the power supply board (it has a socket for the power cord and is covered by a me ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3502 seconds