Having problems with your Proview PL913S 19" Flat Panel LCD Monitor ?

TV Backlight turns off after a sec

\015 Hey, I got the proview pa-19dk5 900t tv. I recently started having a problem with the backlight. It turns on for 2 seconds then turns off. I know everything else works because I had my cable plugged in and I could still hear the channels and my xbox in the vga plugs. My brother was an electrician back in the day so I got him all the caps and got new ones installed but it still has the same issues. The only cap I couldnt replace was 3- 680uF 25V caps because I couldnt find them in stores. Any idea of what it could be?\015

Answers :

How did you open it? I have one, but there are 4 recesses that look like they should be for screws, but now screw. And the back is held at those points.
Check the backlights somtimes the wires come lose and need to be resodered back or the backlights need to be replaced. Try shinging a flashlight on the screen to see if you can see anything
Repair Help & Product Troubleshooting for Proview PL913S 19" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Proview Pl926wbi I have a 19' Proview LCD display. Recently it started turning off by itself after working for 4-5 sec.We connected it to another pc and the display acted the same way - it worked for 4-5 sec, then it turns off. We have to press the on/off button to turn it on, works for 4-5 sec and then goes black again. Is there A fix?

This is an inverter board problem. The inverter supplies the high voltage and frequency to run the CCFL backlights. The board has a sensing circuit to shut down the output if too much current is going to the backlights or it will shut down if the t ... Proview PL926WBi 19" LCD Monitor

Screen goes black but still can see the desktop??

It sounds like you are losing the backlight....the backlight is what lights up the panel. The inverter takes the signal from the motherboard and sends it to the backlight. I would change both out. The inverter is usually a seperate component....the b ... HP w2207 Monitor

When turned on, it immediately turns off after about 5 secs. can u help me find solution regarding this? thanks

When turned on, it immediately turns off after about 5 secs. can u help me find solution regarding this? \012 This trouble maybe power supply or inverter boards is defective.\012 first you can test the voltage of the multr,and then check which pa ... AOC LM742 17" LCD Monitor

TV Backlight turns off after a sec

How did you open it? I have one, but there are 4 recesses that look like they should be for screws, but now screw. And the back is held at those points. ... Proview PL913S 19" Flat Panel LCD Monitor

My siemens LCD monitor back light turns off after 1 sec

You need to check out caps in the power supply section first, then check the backlight inverter circuits for bad fuse, transistors. It can also be bad lamps. See example of failed monitors due to bad caps: ... Fujitsu Siemens Siemens Basic Line B15-1 15" LCD Monitor

Backlight goes off after 2 sec on LG L1710S LCD monitor

Just took mine apart for the same issue, looks like mine is shutting down as only three of the four back lights are working ... LG Flatron L1710S 17" LCD Monitor

Lg l1710 inverter board fault

May i know the model and the make of the product in details so that it can help me resolving the issue is a more prompt manner ... PC Desktops

BenQ FP71G+ power supply problem

I checked all what is explained here but, first, all the components are ok, then my problem is a little bit different from this.My monitor (Benq FP71G+) turns on perfectly but after about 1 hour or less the LCD panel turns off (so backlight and ... BenQ FP71G 17" LCD Monitor

Dell lcd monitor, turns on but only stays on for about 30sec

The problem is your backlight lamp is bad. Your description is of very classic symptoms for the backlight. You can either replace the LCD assembly or monitor or try replacing the backlight bulb itself. You'd have to call around to some repair shops t ... Dell UltraSharp 1905FP LCD Monitor

IBM LCD Screen turn deem

If my research effort is accurate, _dim_ LCD screens are typically caused by problems with:-- The inverter-- The backlight-- The screen itself.Apparently it tends to be a pick-and-chose effort to diagnose the problem. ... Daewoo L700C 17" Flat Panel LCD Monitor

Screen working and after 2 sec screen black

On your power board you will have a faulty surface mount fet with 8 legs that controls the backlights.\015\012There are 4 of these, but if any of them fail the protection circuit turns them all off.\015\012Best best is to get it to a loca ... BenQ FP92W LCD Monitor

I have a NC6000 that will turn on the screen for about 2 seconds during boot-up. everything else seems to work ok-- it aquires a wireless link but the screen is dead. If I turn it off and back on rhe same 2 sec. turn off happens. Is it the Power Supply, Inverter or Motherboard? All help is greatly appreaciated. Scott

Usually it's in this order. Inverter, lcd / backlight, gpuA local repair shop would be able to confirm which one. Or you can just order a replacement from ebay for about 10-15 and try replacing it yourself. It's not hard. ... Compaq NC6000 Notebook

Hp pavilion f1930 shows pic for 2 secs. then blank

Rather than guessing, or blaming the computer, I fix the F1903 backlight problem. Power the monitor and using a bright flashlight check the screen to ensure there's an image, or the menu when you press the menu button. Nearly every one of the F1703 a ... HP Pavilion F1903 19" Flat Panel LCD Monitor

Laptop monitor problem

Sounds like the inverter has gone out or backlight of the laptop has gone out.\015\012\015\012you would normally see a logo or something when you removed the TV from it, you can boot dual lcd with laptop on and TV. so i doubt something is ... Toshiba Tecra 8200 Notebook

Nov 21, 2008 - I have a proview 19" LCD TV PA-19DK5. In the last few days when I turn on the tv the picture appears and disappears after 1 sec. audio is fine, when I use my xbox 360 through the component video, the picture will last about 1 min with a buzzing/humming sound then disappear. I read some of the posts and decided to take apart the TV and inspect the capacitors, I found NO bulging, leaking or damage on any of them. Here is a list of the capacitors on each board The power supply boar

Please post the pictures, that will help. Do find any fuse in the inverter circuits, if you do have 5v (for logic) and 12v (for backlights), then may be the power supply is OK but I am not sure that the inverter is using 12vdc since you have some cap ... Proview PL913S 19" Flat Panel LCD Monitor


Bios does one long and two short beepsThis is the code for Video Failure.Replace the Vid Card. ... PC Laptops

Envision LCD monitor

Most likely the 2 470uF capactitors in the power supply have leaked and partially shorted. If you have those replaced it should power up fine. The symptoms will be the green power light will come on and the backlight tubes will light up for about 1 s ... Relisys RLT1720 17" LCD Monitor

Sony sdm hs73 finding the LHS73K V1.3 chip

Hi...there guys,\015\012No, no, no.... It's not the chipset....what you guys had are a busted backlight inverter, get that replaced or repaired it. Replaced a couple of over-heated capacitors...and it will come back as good as new... ... Sony SDM-HS73P 17" LCD Monitor

Philips 190S monitor - Urgent!

The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Philips 190P6EB 19" LCD Monitor

Screen goes dark after a few seconds

I think you need new backlights, if it was the inverter or power supply (the same in this case), it would not come on for that long, even 4 or 5 seconds. This unit has four 2mm x 405mm ccfl bulbs (cold cathode fluorescent light) two on top and two on ... Proview PL926WBi 19" LCD Monitor

Complete failure after modifying RAM

If you know how to remove the cmos battery, I would suggest that you do so. Leave it out for 20 secs. Restore the battery (if possible use a battery tester to verify the charge in the battery). Restart the computer and press whatever key (delete, F2, ... PC Laptops

I have three Toshiba Satellites, 2455-s305 (an older model with desktop P4, 1G Ram, XP pro, etc.)They boot and run, but have problems: (1) When turning this one on, I must press the power button, then press another button within a few seconds, or it won't come on. Power off works fine. The LCD backlight also will not come on, even though the inverter is known good (runs fine on another computer). Power is present, the fuses are good, and the inverter works fine in another identical laptop, so I

Turn off- unplug power- remove battery 1minute replace batt power cord press and hold zero restart while continuing to hold zero 30 to 45 sec screen will flash when you see cursor blinking let go... now you will have option to restore to (out of box ... Toshiba Satellite 2455-S305 Notebook

Screen dims 15 sec after turning on - Acer AL1916W 19" LCD Monitor

Hello,\015\012\015\012It sounds like you have a monitor with a common problem. After a few years some LCD monitors will\015\012blow a power supply. The problem is caused by parts called capacitors\015\012overheating in the confined space ... Acer AL1916W 19" LCD Monitor

Gives picture for 10 secs then goes blank,although i can still see graphics on the screen slightly,turn on and off gives picture again then goes blank

There is a problem with the LCD Panel backlight - Check to see if your monitor is still covered under warranty and get it replaced under that.... ... Xerox Computer Monitors

Viewsonic problem Viewsonic VX922 its about about 1.5 years. Recently started blinking upon boot up. when I boot up the orange light turns green and blinks continuously while featuring a blank screen. the computer boots okay;, but nothing shows on screen. i unplug monitor for 5-10 secs and everything is ok... could it be backlight inverter or capacitors or inverter board... Any help would be greatly appreciate as calling Viewsonic is a dead end..thanks

The problem gets progressively worse until the monitor completely dies. I solved my problem by returning (Ask for an RMA) the monitor to Viewsonic. Warranty is 3 years. I shipped it out and they returned a refurbished one. Warning: They didn't return ... ViewSonic VX922 19" Monitor Flat Panel
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3702 seconds