Having problems with your Mag Innovision LT776s 17" LCD Monitor ?

Monitor went blank

\015 My monitor started going blank,but if I powered off then booted on,it would stay on for awile it kept doing this then one day the color got distorted and went blank again and now it won't come on at all....my hubby unplugged the monitor power cord and it came on again,but then the color faded an got distorted and then goes blank again...What can I do to fix this?....Thanks in advance,Maryfran\015

Answers :

This is a generic symptom that could happen to any LCD\015\012monitor.
\015\012\015\012The following is a generic answer applicable to most.
\015\012\015\012
\015\012\015\012Two possible causes are bad capacitors or a bad light inside\015\012the LCD panel.
\015\012
\015\012Open the unit and check to see if any of the capacitors in the power supply or\015\012other boards look domed or vented on the top.
\015\012
\015\012Replace any capacitors accordingly. Use the same value capacitors. Most often,\015\0121000uF 16V or 25V, 470uF at 16 or 25V, 220uF at 16V or 25V.
\015\012
\015\012If this doesn’t solve the problem, try checking the surface-mount transistors\015\012on the inverter board that run the lights. Some times these transistors go bad.\015\012Check the area for any cracked or overheated ceramic or mylar capacitors.
\015\012\015\012Also, you may have a bad light inside the panel. This is\015\012tough to test without a spare light to use for troubleshooting.
\015\012
\015\012You can take the panel apart and inspect the lamps but it is very tedious. It's\015\012tough enough to get them apart and back together again never mind keeping the\015\012layers clean. You have to try not to get any dust between the layers or you\015\012will see it in the picture.
\015\012
\015\012There are usually two light fixtures each of which holds two lamps. One fixture\015\012is at the top and one at the bottom. Remove them one at a time and inspect the\015\012lamps to see if any are broken or very dark on the ends. If one looks out of\015\012place, it could be bad.
\015\012
\015\012You'll have to find replacement lights on the net. It's not easy to replace\015\012them, but if you've gone this far, good luck. You should be able to get generic\015\012instructions off of the site that sells the lamps.
Repair Help & Product Troubleshooting for Mag Innovision LT776s 17" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

One of two monitors went blank. When I turned it


The problem can be the inverter board or worst case will be the lamps, you need to have spare lamps for testing, that is how I narrow down the problem to find out if the inverter is bad or bad lamps. see example here: ... MegaVision MV220 Monitor

Monitor is blank!!!!


I had the same problem with my Toshiba laptop. I found that by opening or closing the screen slightly (with the computer on), the display suddenly returned and stayed on. I assume there is a problem with the contacts or connection. ... Toshiba Satellite A105 Notebook

Monitor displays breifly then goes to blank screen


Well my Acer AL1711 finally gave up in as much as the screen flashed briefly at switch-on then went blank, regardless of brilliance setting so I decided to take it apart and try to fix it. The good news is that IT WAS NOT THE LAMPS that I feared in m ... Relisys RLT1720 17" LCD Monitor

Dell 24'' Ultrasharp went blank


I suspect the invertor supplying power to the Xenon backlight tubes has failed.\015\012This can be reapired but may not be cost effective.\015\012Ask for a quote from your local computer specialist but keep in mind the cost of a new monit ... Dell Computer Monitors

Blank ACer X221W Monitor


Hi this is the way how to examine what's wrong with your LCD\015\012monitors. Power on both CPU and monitor. After it went dim and blank, you have to\015\012check if you can see the image on the screen or not by shining a flashlight into the\015\012s ... Acer X221WSD Monitor

My monitor went black, and the power switch just flashes.


Is your CPU working properly? if that the case, your monitor is in need of a service.\015\012reasons for why a monitor goes blank?\015\012Reason 1: Wetness \015\012The number one reason why computer monitors go blank is - wet ... Dell E152FP 15" Flat Panel LCD Monitor

Whilst using my computer the monitor went blank. I turned the monitor off and back on. It stayed on for less than a second before going blank again. There was power to the monitor. I left it for a few minutes and tried again. It worked for a few minutes then went blank again. What is happening please? What should I do about it?


Can u boot into the safe mode and see if the monitor will work cause it sounds like to me that you either have a driver that is failing or the monitor is failing ... HP PC Desktops

Monitor Display Problem.


The first Polyview has a power supply problem (a short) and locks out the power until it is unplugged. You need to check the voltages inside the Monitor to determine which component/s are faulty. I hope you know electronics if not leave it to the r ... Polyview V17E 17" LCD Flat Panel Monitor

Screen comes on briefly then blanks out.


Check inverter, memory, and powersupply. ... HP w1907 LCD Monitor

Monitor went blank


This is a generic symptom that could happen to any LCD\015\012monitor.\015\012\015\012The following is a generic answer applicable to most.\015\012\015\012\015\012\015\012Two possible causes are bad capacitors or a bad light inside\ ... Mag Innovision LT776s 17" LCD Monitor

Dell 1800fp dead


If you have friend maybe you can borrow for a while to check either your monitor having problem or the video card. If your power of the monitor still OK possible the problem is came from your video card.Please let me know any update. I am ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Monitor is Blank and Power Light Blinks


You try to check and replace the transistor 5707, two of them are shorted ... Dell E173FP 17" LCD Monitor

MAG Innovision LT1919WDb flat screen goes black


When a monitor works for a few seconds or more and goes black it is a problem with the power inverter board over heating because of a bad capacitor or capacitors that are not the right size. There is no problem with the VGA controller since it shows ... Computer Monitors

Blank Laptop Screen


Unplug everything from your laptop unplug the power from the laptop close it and turn it over remover the battery open and hold the on button(battery is still removed) for a 10 count, replace the battery\015\012turn on you can plug the power co ... Gateway MX6956 Notebook

Screen Goes Blank


Ive seen this on other monitors. Look for a 1 and 2. Some monitors do NOT auto detect a signal, and this one might not. Look for a way to set the monitor from Digital input to VGA input. Try that and see. ... Dell E173FP 17" LCD Monitor

Blank HP w1907


If the power light does not turn color and stay's green on startup, it is not a power problem. It is most likely the inverter. If the unit is in warranty, send it out ASAP. Contact HP customer care by email and have the issue logged in.\015\012 ... HP w1907 LCD Monitor

"BLANK SCREEN, CLICKING SOUND, & NO LED INDICATED".


Some electronic components on the circuit was shorted.clicking indicates this type of problems. ... Compaq FS7600 17" Flat Glass Monitor

Laptop won't boot up properly


Connect your computers to an external monitor and press the appropriate F key combination (Shift + F7) to switch video output to the monitor. If you see an image on your monitor you have a bad LCD screen or back light inverter. If not you need a ne ... Acer Aspire 9300 Notebook

Monitor went blank


Let's try to isolate the problem:\015\012\015\012-If possible try both monitors on a different computer.\015\012\015\012-does the computer makes any sound when you turn it on?... do you get any image at all when you turn it on ... Gateway 310S (2900621) PC Desktop

My monitor shuts off(goes blank for a few seconds


The monitor is doing a self test a finding an error.The lcd has three parts, the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, ... LG L1915S 19" LCD Monitor

My monitor just went completely blank. There is a


Hello,The ticking sound you hear is from the power supply trying to power up. If you can solder you should be able to repair the monitor yourself. The problem is caused by blown capacitors on the power board. Go to our web site at : ... Computer Monitors

Possibly Video Card problem?


Mikolan,That is so crazy.You say you previously was able to see the POST screen and now you can't?You say you switched monitors and card outputs to no avail? Is the card an ATI with an aux Molex power connector?Is the pu ... PC Desktops

LCD monitor went blank


Which model is it?Does power led remain on?\015\012Samir ... BenQ FP737S-D 17" LCD Monitor

Blank (dark) notebook screen after hooking up digital ext monitor


I notice a difference in the setup of the two monitors, have you installed the correct driver for the new screen?\012\012Try F8 on startup to get into safe mode, this should allow you to use the default VGA screen, and to reset the correct mo ... Sony VAIO VGN-A790 Notebook

I've fried my monitor - Won't power on


It will be almost impossible to find these components unless you are in Taiwan. ... LG Flatron 795FT Plus Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4214 seconds