Having problems with your HP Compaq ProLiant 800 Server ?

System halt while booting - HP Compaq ProLiant 800 Server


Answers :

Repair Help & Product Troubleshooting for HP Compaq ProLiant 800 Server

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Compaq Proliant server... sort of... died


What has happened the main board system battery is old and when you moved this server has lost setup first step is clean the system check the voltage without power applied you will find low voltage replace the battery rest you setup setting If this n ... HP Compaq ProLiant 6000 Server

Run Compaq Array Configuration Utility


Hi Foambob,\015\012\015\012Try all means to get a smartstart CD.\015\012Normally new version will be able to use on older hardware , but no guarantees.\015\012I have always found it easier to use smartstart CD auto mode. ... Compaq ProLiant 5500 Server

HP Proliant ML110 Server RAID setting


If you have the RAID 0+1 or 1 ,beacause of the mirroring ,2 disk will be the same.you should be attention ,if you transfer data on the first disk,you must boot your server with that disk.when the system boot completely then you put the second disk ,b ... HP ProLiant ML110 Server

Harddrive array sequence causing system in booting


If the only drive you changed was the drive that failed and all the others are in the correct sequence, then that's a good thing. \015\012\015\012The next question is, did you have this system setup in a RAID Array and if so, what RAID co ... HP ProLiant ML370 G4 Server

System halt while booting - HP Compaq ProLiant 800 Server


... HP Compaq ProLiant 800 Server

New HDD Install Prob


Basic Troubleshooting Tips after Installing a New Hard DriveBased on Seagate IDE hard drives.If you have installed your drive and it does not function properly, perform the following basic checks:Additional Troubleshooting Tip ... PC Desktops

I can re boot boot my compaq persario V6000


Only a HDD with a properly installed OS, a valid boot sector and an active partition will 'Boot' Did\015\012it ever work? Are you sure the POWER is there. Are you sure the cables\015\012are on right and the HDD is identified in the BIOS o ... HP Compaq Presario V6000T PC Notebook

RAM error - HP Compaq ProLiant ML350 G3 Server


Populating the memory according to the following guidelines resolves this POST error:\015\012\015\012\015\012 DIMMs must be configured in identical pairs. \015\012 The system will not boot pro ... HP Compaq ProLiant ML350 G3 Server

Compaq proliant 5500 server P2 dual xeon processors. Will not power on. green lights on both powers supplies are on - green lights on Mother board and LCD on front are on but absolutely nothing happens when pushing power button


I am wondering if you had been doing some work to this when this problem started. Did you take the wires off for the power switch? I have noticed that sometimes if you pull the wires off of the motherboard and put them back on and you put the connect ... Compaq ProLiant 3000/5500 Redundant (306558B21) Fan Assembly

Dell Poweredge 4300 Bootup problem after cmos battery replacement


Check the version for the Raid Controller. This may need to have the firmware to be upgraded. If the controller is removable, take the controller out and then see if the computer will continue past the bios. If the controller is built-in, then disabl ... PC Desktops

When booting the ds20 compaq server from system disk it brings an error saying scsi drive at channel 1 dead, target 0 dead and goes on to say the same for all the other disks


If you are sure the disks are ok (they could have been fried by a bad power source) then the SCSI chip is probably dead.Simple test: remove all hard disks and boot from the recovery disk. If you are lucky it will report all HDD channels operational a ... Computer Utilities & Maintenance

Change CDROM on Toshiba 2805 -s 202


IDE 1 is the CDRom (or any optical device attached). IDE 0 (zero) is the Hard drive. So this message is telling you there is a problem with the DVD/CD-Rom, that has halted the boot process. Now you have no choice but to go to BIOS (read startup scree ... Toshiba Satellite 2805-S202 Notebook

No Boot on 1600sc


The easy answer is:\015\012\015\012Did you ensure the CPU fan connector is attached to the PROPER motherboard CPU fan power pins?\015\012\015\012The 2nd easy answer is:\015\012\015\012Are you sure your CPU is properly placed inside the socket? Could ... Dell PowerEdge 1600SC Server

Dell Poweredge 4300 will not boot up after cmos battery replaceme


Configure your System bios and reboot. Your Hard disk drive was not configured. Pl configure. it will work properly ... Computer Servers

Connect HP Proliant ML350 Server.


Hi,Please verify if your server power specs support 110 or 220 V. If you are in the US, eventhough you might have connected a 220V cable the line voltage can be 110.Check with your power company if they can provide you the necessary ... HP Compaq ProLiant ML350 G3 Server

Hello there, when I turn on my laptop ( toshiba satellite P305D), it shows "configuring stage 3 of 3 - 0% complete do not turn off your computer". then it shuting down itself, and went back on showing the configuring page. it happen on and on non stop. any idea why and how to fix it? thank you.


The computer has gotten hung up on the latest Windows update. There may be a recovery here, but the problem with these updates especially if your have the computer to update automatically is that some of these are service pack updates, and a service ... Toshiba Satellite P305D-S8834 Notebook

Compaq N610c is going crazy, need Help!


The ''alternate''should mean the source (than battery)not the current.Go to control panel check the settings on power options and change the small bios baterry(as you thought) If the problem continious change and the normal battery or check it with n ... Compaq Evo N610C Notebook

Just black screen with a small white dot up left corner when start up. try start up with F2 or F12, same problem. When use F12, ask for pass word, and then it says, press any key, system wil halt


Windows Start-up Errors\015\012Step one, you need a Windows XP CD. If you only have a recovery disk set like the ones from HP or Compaq they will not do what you need done. Under normal circumstances however, you can use a De ... Acer Aspire One PC Notebook

Unplugged my armada m700


This error can be caused by one or more of the below possibilities.\015\012Floppy or CD that is not bootable is cur... BIOS or CMOS setup is not setup properly... Hard disk drive does not have bootable f... The hard disk drive ... Compaq Armada M700 Notebook

Non system disk or disk error


Do you have an installation or repair disk \015\012If you don't have a Windows Restore Disk, you can create one with a friend's computer. ... Compaq Armada M700 Notebook

Processor in incorrect slot system halted error


Hello,\015\012\015\012You don't see this often but when you do it means your cpu is not in cpu slot 1. (Usually you are also running 1 processor in your server.) Just move the cpu to the other slot, power on your server and you should be ... HP Compaq ProLiant 800 Server

Laptop no boot


This could mean a number of problems but firstly enter you bios setup during startup check the boot priority order also while you are in this menu check whether the system identifies your harddrive if it does then maybe there is a problem with your o ... PC Laptops

Compaq evo d500 won't start up and won't let me access boot menu. just keeps saying keyboard fault even when another keyboard is used


Press f10 during startup , when the bios open, look for the setting "halt on" . it will have a choice of keyboard, all errors or no errors , set it on "no errors" save and reboot. that may fix it.\015\012 You could also get another keyboard (n ... Compaq Evo D500 PC Desktop

Boot problem with a ProLiant DL 380 server,


To enter the BIOS of a ProLiant DL380 you have to press "F9" ... HP Compaq ProLiant DL380 G4 Server

When I try to boot up my Compaq Presario 2500 laptop I get the following error message: PXE-E61: Media test failure, check cable Operating System not Found. I have tried changing the boot sequence in the Bios but nothing changes. I am trying to boot from the system recovery CD rom. Please advise


Boot sequence isn't enough. You have to turn OFF (disable) the boot from network. The error your seeing is result of the network boot rom not finding PXE server to boot from. Again, be sure to disable boot from network. ... Compaq PC Laptops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7563 seconds