Having problems with your Hitachi Computer Monitors ?

How do you reset HITACHI Monitor Model: CM751ET?

\015 Hi their I am having a problem with my Hitachi monitor (model number listed above), I can\342\200\231t seem to reset the monitor for some reason their is no reset switch located any ware around the monitor and I\342\200\231m unable to correct the problem through computer display settings either. Their are all the standard controls apart from reset. \015\012 \015\012The screen seems to tilt in toward one direction and I\342\200\231m able to see sloped dark patches in the bottom right corner, almost like a small tilt where the picture disappears. I have attempted to set in right by fiddling with the controls at the front but no luck stays the same. I have also tried to find the user manual but have had no luck. \015\012 \015\012Can you help me sort this problem out?\015

Answers :

Repair Help & Product Troubleshooting for Hitachi Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you reset HITACHI Monitor Model: CM751ET?


... Hitachi Computer Monitors

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

My wifes Acer monitor suddenly went black


When you turn on the monitor, and if you see the power light blink i really doubt that the monitor is at fault. If it failed at all, it would likely fail completely.\015\012\015\012Sorry to be bearer of bad ... Acer AL1913b 19 in. Flat Panel LCD Monitor

OSD Menu on my montior is lock on a Balance CM2017 LCD monitor i cant change any of my menu opitions....HELP


The answer depends on your monitor model, of course. For some of the LCD models you may reset the monitor by pressing (and releasing) the "MENU" button (OSD menu appears) then hold the "SOURCE" button for a few seconds. When you see the monitor ... PC Desktops

17 inch monitor goes blank - X2Gen MG19MY 19" LCD Monitor


\015\012Prepare to diagnose the computer .\015\012\015\012\015\012\015\012Disconnect all peripheral devices.\015\012\015\012Perform a Hard Reset.\015\012\015\012Disable th ... X2Gen MG19MY 19" LCD Monitor

I have a LG Flatron 22", LCD monitor, model is W22345. dilemma: after sleeping the computer for the night, as I have been doing for the past 8 months that the computer and monitor has been in my owne


Check the video cable,replace them, and if didnt work, try to reset the config stored on the settings of the monitor (usually by menu).\015\012\015\012Some electronic problems could do the same simptom. check the manual for hints.\0 ... LG 22" FLATRON LCD Monitor

Display Problem I left my pc on yesterday when i went out , was only out for 30mins & when i came back i discovered that my monitor was displaying in a reddish/pink colour . I would like to know how to get the monitor back to it's normal setting please , system is less than 1 year old.


Try the following:\015\012\015\012\015\012Turn off the monitor, do this by unplugging it, keep it off for at least 1/2 hour.\015\012Check the data cable (not the power cable) attached to the bac ... Computer Monitors

To joecoolvette reguarding 2005 compaq presario SR1000 and Dell LCD TFT monitor. The dell monitor was part of my mothers comp and I wasnt given a CD with it. Im sure she dont have it now. As far as the graphics card I plugged the card in first then I ran the disk.


Jason,When a device is installed, Windows 'Breaks it's neck', to find a compatible driver, (Or drivers)If THE driver is not present, then Windows will match up one of it's thousands, of generic drivers it has on hand.The ... Compaq Presario SR1000T (568657) PC Desktop

Tower shuts down after 5-10 seconds.


I've done some reading, and it seems as though this model computer is somewhat known for this problem. \015\012\015\012Heat can absolutely destroy a computer. I think there are most likely some reoccuring issues going on if the computer ... E-Machines T5026 PC Desktop

Tower will not boot or communicate with monitor


Don't throw out that computer or replace any components just yet.After\015\012much trial-and-error, I finally figured out the solution for this\015\012common issue with certain HP Pavillion models. It turns out to be a\015\012design flaw ... HP GX612AA Pavilion Media Center M8330F Desktop PC

Its look like out of range 54.3khz/80hz, futhermore monopoly game is running on another LG monitor of same model, another cpu. i hve Ge7300le graphics card. and driver is up to date. resoulution keep


Try switching the monitors to see if it's the monitor or GFX card issue, if it's monitor, attempt to reset it on the menu to default settings, If it's GFX card issue, go in safe mode and uninstall the GFX driver and restart and reinnstall new drivers ... ViewSonic Graphic VG2021m LCD Monitor

Monitor screen picture is stretched out wide, and short verticle


If this is an incorrect display setting on the Operating system right click your desktop, choose properties then click settings under screen resolution bring the slider all the way to the left, choose apply. This will lower your resolution temporari ... PC Desktops

My LG 21.5 inch monitor model W2261V, won't seem to come off power save mode, i was wondering if there is some way to reset the monitor?


Install the ForteManager PC software and use it to reset the monitor to factory default. It sends DDC commands along the monitor cable. It works with both DSUB and DVI. That may help if simply pressing the menu button on the side of the monitor doesn ... LG W2261V 22" LCD Monitor

How do send monitor signal to my tv


Not familiar with this particular model but a lot of factors are involved here and it may not be possible depending on both the television capability, and the video hardware on that model of computer. However your question about how to SEND the signa ... Compaq Armada M700 Notebook

THE PRINTER WAS NOT WORKING WHEN PRINT WAS SELECTED. i CHECKED THE PRINTERS BLACK AND COLOR AND TOOK THEM TO THE STORE TO MAKE SURE THEY WERE GOOD AND FULL. nOW THE PRINTER FLASHES ORANGE EVERY THREE TIMES AGAINST THE GREEN. yOU TOLD ME UNHOOK THE MONITOR FROM THE PRINTER AND THEN TURN IT OFF. tHEN YOU DISAPEARED AND i AM STUCK. pLEASE FINISH THIS OR i WILL NOT BE CHARGED.....


Hi - we got disconnected (accidentally ended the chat session?)for the light pattern that you have here are the related issues:paper jams , obstructions , cover errorCanon's recommendation:Resetting the ... PC Desktops

NEED ASSISTANCE w/ DELL PC


When you first turn on the system, listen closely for any beeps. If you hear any try to remember or write down the pattern of beeps. Then go to Dell's site and find the manual for your model and look up the BIOS or CMOS error codes. This will indi ... PC Desktops

Monitor not displaying


Sounds like your video adapter settings have been wedged. If you are running Windows XP Service Pack 2, you can use the following steps.\015\012\015\0121) Boot the laptop into safe mode. Boot into safe mode with networking support if possible. This c ... Dell UltraSharp 1704FPT 17" Flat Panel LCD Monitor

HITACHI HTS541680J9SA00 my laptop was stolen a acer 5050 police recovered it but not before thief put a hard drive code on it how can i reset my hard drive hitachi and acer wont help


Never heard of a 'hard drive code' before.. You don't mean a BIOS password, do you?? If it is a bios password, there is most likely a switch or 'jumper pin' on the motherboard, that will reset the bios to default. That will get rid of the password. I ... Acer Aspire 3680 Laptop

Monitor distortion monitor has major distortion like wave across the screen..the hard drive is constantly running to hard seems like it has something to do with it


Hey edwardaaron,\015\012 \015\012If you are encountering any kind of visible distortion on your computer monitor, there are a couple of things that I would suggest.\015\012 \ ... PC Desktops

Lcd monitor powers up then shuts down.


When you turn on the monitor, and if you see the power light blink i really doubt that the monitor is at fault. If it failed at all, it would likely fail completely. Sorry to be bearer of bad news ... CTX S700B-1 (Black) 17" LCD Monitor

Relisys 17in tft monitor


Hi everyone, i have a relisys monitor and had this exact same problem where the menu screen comes on and then cycles through the various options until it gets stuck in a loop within the colours settings. - the solution i found ... Relisys TL 766 Monitor

My Hp mx70 monitor Will rendor the color green as black


Dear Killkerson,\015\012\015\012As i understand from the situation, Please do the following:\015\012\015\0121. First confirm that the problem is with the monitor. You can do this by trying this monitor on any other CPU. If the ... HP Pavilion MX70 17" CRT Monitor

Powering up problems.


Try using another monitor that you know works. Then try another video card. The fans are running because the computer is running ---but the monitor is not. Green to Amber means monitor is not on.\015\012A lot can go wrong with loose wires that ... E-Machines eMachines Desktop PC

How do i do a full reset? I would like it back to factory settings.


Click on Start, All Programs and click HP My Display, Again Click HP My Display and than you can follow the on screen display to reset it.Also you can use the front panel buttonsPower Turns the monitor on and to standby or sl ... HP w1907 LCD Monitor

Power failure for HP Pavilion A6600F


>> I might have to test an alternative power supply to rule out the existing power supply. \015\012\015\012That should be your next step. Just connect the "temporary" power-supply to the motherboard and the fan on top of the CPU. ... HP Pavilion a6600f Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4682 seconds