Having problems with your Gateway GT5228 (7156) PC Desktop ?

Will not boot up...It just beeps, and no signal to monitor


Answers :

Do you know anything about maintenance
(if so and you know how to open the case try disconnecting the ide cable from the hard drive) if it comes up with a display on the screen it could be the hard drives had it or the connection is a bit jiffy on it.

another idea it could be is that its the ram on its way out..

i hope this helps you.
if not you can get hold of me ( [email protected] )
Repair Help & Product Troubleshooting for Gateway GT5228 (7156) PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Computer "turns on" i hear four to five beeps, but the monitor gets no signal. a friend gave me the computer, only once did i see it boot up fully but it froze up so i had to restart it and it wont work. everytime i try i get the same thing four or five beeps and monitor says no signal. so i dont know whats happening. its a gateway computer runing windows xp. thats all i know. i know the monitor is good cause i tested it on another computer.


Without knowing the exact frequency/length of the beeps my first guess would be a bad stick of ram or a bad video card. If there is more than one stick of ram in the computer try it with one of the sticks pulled, pulling each stick until it does boo ... Gateway GT5028 PC Desktop

My monitor is not responding to anything. what can i do aside from rebooting?


Do you see the light blinking in the monitor? I mean the POWER led light up? If so, then the monitor is ok and is working good. It is your CPU which has a problem and not sending digital signal for the monitor to display.\015\012\015\012Try to ... Computer Monitors

Monitor and keyboard won't turn on


A couple of things here:\015\012\015\0121) The flashing light and signal message indicate that the monitor is functioning but is not receiving a signal from the computer.\015\012\015\0122) The memory that you added is liklely ... PC Desktops

Can't get PC to boot up, monitor says power saving mode & beeps


Naomi, this will probably require a computer technician to fix. What you are hearing is a "beep code" that the motherboard produces when there is a problem. Your first step should be to read ... HP Pavilion a450n PC Desktop

PC beeping, monitor will not display


We have different sound we can hear in cases of hardware problem, once the video card has loose contact it also beep continously, a beep sound also occurs when the ram(memory card) loose contact, one beep sound when it boot clearly it proceeds as go ... PC Desktops

Monitor comes up shows "acer" then says no signal and goes black


The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor

I have just installed a asus p5kl-am in/gb


When the computer boots up are you getting any sound through the internal speaker at all? (nb - the internal speaker is the one inside the case, not the one connected to the sound card).When you start a computer this speaker indicates an ... PC Desktops

Beeps after booting... no signal to monitor


... Compaq Presario 5000 PC Desktop

My HP Pavilion a6300f powers up but no signal to the monitor


It could be the motherboard, try resetting the the bios first by either taking the lithium cmos battery out and then replacing after 30 secs or finding the the cmos jumber and unshort it for 30 secs, and reboot the mechine.If the same and ... HP Pavilion Desktop a6300f Intel Pentium Dual-Core E2180 Desktop, Refurbished

No signal shows on monitor


When a computer beeps on start up there is a crucial input output piece of hardware no working. If you have any experience with computers check to make sure everything is conected right. I inclued a link for support for your computer. Larry ... Computer Processors

My power supply failed. Now after replacing it


Unfortunetly the power supply can be a symptom not the actual cause.\015\012\015\012Do you get any beeps or other signs that it is actually booting up? The older AMD's are quite sensative to both heat and electrical problems. You may have ... AOpen PC Desktops

Desktop will not boot into bios No Usb power;monitor ''No Signal''


Your problem is the memory . YOu have to put off the pc and remove the memory card in the slot. Then clean the silver pins in your memory with a rubber eraser. Put it back and see if the BIOS will be prompted on the screen , if not you have to replac ... Acer Aspire T160 (AST160UA3400) PC Desktop

DELL INSPIRON 1501 won't BOOT...and LEDs flashing


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... Dell InspironTM 1501 Notebook

When i power on my pc,the monitor power indicator lights green but about 3s later it goes brown.the monitor screen remains unchanged as to when the computer was powered off.my email is [email protected] this problem?


You are not getting a video signal to the monitor. The fact that it is green initially shows it's working. When it turns orange, that's an indicator that it is getting no signal from the computer. So the next thing to check is if your computer is a ... Dell Computer Monitors

E-machine t6212 won't boot. I actually have two e-machines that are not sending a signal to the monitor. One is a t6212. It is booting up because I can shut it down using the windows key + up arrow + enter + right arrow + enter. I suspect the video card. I have an older PCI video card that is incompatible with xp. If I put that in the PCI slot will the bios send the video there? The other is a W3107. The hard drives spin, but the green light on the front stops flickering after a few sec


If you get only one BEEP at boot then the computer is working..\015\012\015\012Do you have a 2nd monitor to test with?\015\012\015\012if it BEEPS more then once...\015\012 pull out your mem chips and test,,\015\012 ... E-Machines T6212 PC Desktop

NEED ASSISTANCE w/ DELL PC


When you first turn on the system, listen closely for any beeps. If you hear any try to remember or write down the pattern of beeps. Then go to Dell's site and find the manual for your model and look up the BIOS or CMOS error codes. This will indi ... PC Desktops

Dell Dimension 8400 will not boot period


If you have any idea of opening the computer and try to tighten all the cards once and than try to reboot it. The beeps mean that there is some hardware thing which is loosen. So try to tighten all the cards ram all the wires as much as possible. ... Dell Dimension 8400 PC Desktop

Will not boot up


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... PC Laptops

Sony VAIO VGN-FZ410E does not boot up. On power the laptop seems to go through normal sequence but the display remain white. The unit stays on with no display and reboots after several minutes. CTRL-Alt-Del sequence causes the laptop to attempt to re-boot but with no display. Putting a bootable cd in the drive shows a similar behaviou ie. nod display (screen reamins white). Any idea what causing the problem?


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... Sony VAIO VGN-FZ410E/B Notebook

Won't boot up


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... HP PC Laptops

I have a Toshiba Tecra A8 and it will not boot up the only thing it does is display a J_. Can any on help? Please


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... Toshiba Tecra M2V-S330 Notebook

Signal has gone - ViewSonic VX2235WM Monitor


If the monitor comes on and displays a message like "no input signal" or something similar, it's working properly but there is nothing coming from the computer. People often think that the computer is working and the monitor is at fault, when in fact ... ViewSonic VX2235WM Monitor

I turn on the desktop and the monitor only says no input signal input2: HD15 go to power save what do i do?


Hi jiheeahn! I wiull be glad to assist you. lets isolate the issue. The reason why the monitor says no signal input2: hd15 got to power save. the connection from the monitor to the desktop computer is disconnected or its not connected to the right in ... Sony SDM-HS73P 17" LCD Monitor

Acer AM5641-U5520A will not


If you removed the memory modules and there is no change then I would start disconnecting one device at a time to see if that is causing the problem. Start by disconnecting the cd/dvd rom and then try booting the computer. Then try disconnecting any ... Acer AM5641-B5560A Desktop PC & Monitor BUNDLE

No signal on monitor - Dell Dimension 3000 PC Desktop


Check that the power is plugged into the back of the monitor and also to the power point, make sure power point is ON. If anything pull plugs out and re-connect both just to make sure.Make sure monitor cable is also plugged into the back ... Dell Dimension 3000 PC Desktop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5383 seconds