Having problems with your Gateway FPD1975W 19" LCD Monitor ?

My home computer screen wont turn on its goes straight to analog power saving mode


Answers :

Open it up and look for bad caps with bulging top for monitor this old (released in 2001), replace all 9 at the same time. See example of failed monitor due to bad caps: http://s807.photobucket.com/home/budm/allalbums
Repair Help & Product Troubleshooting for Gateway FPD1975W 19" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

LG 2542T goes dark after showing "analog power saving mode" message


If it is saying analog signal power saving... I am wondering do you have it hooked into you computer with the white DVI cable?Is there an option on your monitor to switch modes? Analog-Digital? If you are using the white DVI cable to hoo ... LG L1717S-BN 17" LCD Monitor

When I turn my computer on the monitor stays off. I press the monitor's power button and the orange light above it goes off, obviously turning it off. I press it again and the light turns blue, the words "Analog Power Saving Mode" coming up on the screen. A few seconds after, the screen goes black and the light turns orange again.


Or just plug the video lead into the onboard connection (vga) if that doesnt work try hitting f1 when your pc is loading as sometimes the bios may be set to run in pci (graphics card) but will tell you at startup to press f1 to continue but you wont ... LG Flatron L1750S 17" LCD Monitor

Computer monitor comes on for 1 seconds, flashes "analog power save mode" and then goes black.


Most monitors will say "Power save mode" when they can tell through residual voltage that the signal lead is plugged into a machine, but there's no picture being transmitted. The four states of a monitor are:* Off entirely.* Switch ... PC Desktops

Laptop wont start up


At this point your Operating System is Corrupt and has to be reinstalled\015\012\015\012The only fix is to install your factory restore disk to Restore the System unless the notebook comes with a full system restore; you can call the com ... PC Laptops

Wont boot up to bios


I have had TWO recent model NEC laptops with the same symptom in the past 5 months. I was quite surprised, since NEC is a quality product. But the problem was the DVD/CD-Rom, which is made by Philips (mine were Philips SCB5265 models, but there are o ... NEC Versa SX Notebook

LG screen goes in stand by. I was using two monitors for several months, everything OK, now I decided to get a new LG Flatron instead of one of the monitors... and only this one goes in safe mode!! Two screens plugged in: Philips analogical working fine no problems. New LG Flatron digital goes in power save mode after few minutes Tried to plug in ONLY the LG, same problem after few minutes. Philips monitor no problems. So it HAS to be a screen function or problem of the LG? Computer: AMD + 3Ghz


Oke having a similar problem atm, this is what i have found so far. was trying to help a friend who has bought the same 19" LG monitor. When i connected the monitor to her PC i noticed that it was not the same connection as the previous one but it ha ... LG 19" Widescreen Flat Panel LCD Monitor

Computer screen goes into "digital power saving mode"


You should be able to adjust the settings on the monitor to prevent it from going into power save mode, or at least to delay how long it takes before it goes into power save mode. Press the menu button and look for settings that might disable or chan ... LG L1915S 19" LCD Monitor

Out of the blue one day, monitor started displaying "anaolog power saving mode." This is a stand-alone computer which has never been hooked up to internet.Took tower unit to PC World to see if it was a computer fault. It wasn't. Ended up sending monitor back to manufacturers, LG. Now have a brand new monitor, connected it to computer tonight with brand new leads, but all you get is LG logo on screen and before you can do anything, it goes to "analog power saving mode", so I dont get as far as de


You go to control panel starting your pc ,, then display settings,, from there,, screen saver tab, then make screen saver to none, and click on button power,, there you make everything to never,, and then see. it should work good ... LG Flatron L1951S-SN 19" LCD Flat Panel Monitor

E153fp goes dark into power save mode after Windows start up


May be your power saving option have small time .\015\012check in control panel power option check power shemes.set it to 20 minutes. ... Dell E153FP 15" LCD Monitor

My computer wont open windows


Step 1: Removing recently added hardware\015\012Use the steps in this section to disconnect any recently added hardware and test for the error. \015\012NOTE: If a new internal device (sound card, hard drive, or other) was ad ... Compaq Presario 5000 PC Desktop

Dell228wfp on start up pwr on is green screen


Either the cable is not connected to the proper port or the display-source is not configured properly.Here's what you can try.\012\012Ensure that you have connected the VGA/DVI cable in the correct port. If you ... Dell E228WFP LCD Monitor

Dell monitor dialog box says monitor is in the power save mode


Actually, it most likely is not the monitor which is in "power save mode", it is the computer itself.\015\012\015\012When you cannot get a computer out of "power save mode" by any other means, typically the cause is that ... Dell Dimension 2400 PC Desktop

Message: analog power saving mode (nothing happens after)


... LG Flatron L1511SK (Black) 15 in. Flat Panel LCD Monitor

White screen. Faint vertical lines


Check capacitors that filter the signal from de character generator ic. Unsolder it or them if there are more than one (usually are of 220 micro and test it with an analog tester. If ok, look for the datasheet fo the IC and check if the vcc pin keeps ... Dell E171FPb 17" TFT LCD Flat Panel Monitor

External monitor says laptop is in power save mode and goes blank


Hey jkepthis has nothing to do with power, here is what to do right click your desktop-> properties-> click the settings tab->click the advance button->click the display tab->depend ... Acer Aspire 5610 Notebook

My LG flatiron W1943TB turns on, says analog power saving mode, goes black and then the power button flashes.. but the monitor is hooked up to my dell notebook bc my LCD died


Hi erin mckinle,\015\012\015\012That is probably it's, uh, analog power saving mode. When the screen goes black and the power button flashes, make some mouse gestures or hit some keys that would not affect anything (try spacebar). That should b ... LG W1934S-BN 19" Monitor

Dell SP2208WFP Flat Panel Monitor goes straight to power save mode


If the monitor is not turning blue that means it isn't picking up on the signal that is coming to it.\015\012Pushing the power button on the monitor should make the monitor work and give you a no signal note if it isn't getting signal.\01 ... Computer Monitors

My home computer screen wont turn on its goes straight to analog power saving mode


Open it up and look for bad caps with bulging top for monitor this old (released in 2001), replace all 9 at the same time. See example of failed monitor due to bad caps: ... Gateway FPD1975W 19" LCD Monitor

Computer restarts on own and thats all it does.


I have a similar situation, only worse. \015\012\015\012Same brand, Toshiba M1. I also get the loop at the begining but this is during the install process (windows vista). It goes half way and needed to reboot (that is correct). But when ... Toshiba Tecra M1 PC Laptops

I have a HP Pavilion tx 1000. Blank screen, LED lights on.


Hello, seems like your sleep mode doesent work as it should. Try to download all windows updates and look for a fix on microsoft sites. But the best solution is to inactive the sleep mode setting and use the Hibernate options(if you want a fast ... HP Pavilion dv2000t 14.1" Notebook Laptop PC (Intel Core 2 Duo T5500 1.66 GHz, 1GB RAM, 100GB HDD, D... PC Notebook

Toshiba Satellite Goes completley off! Black screen, NO POWER!


This problem is likely caused by overheating. The CPU reaches a temp to high and shuts the system down. When you try to turn it on the system is still to hot and it will not let the computer power on. You can try blowing out the fans and heat sink wi ... Toshiba Satellite A200-0ET00X Notebook

My main home computer whener turned on goes to analog powersaving


LG does not show the 1750 monitor on their web site. It did show some discontinued monitors including a 1752, but there was no information available about them.Another LG site said to use the far right bottom to auto adjust....for another ... LG Flatron L1750S 17" LCD Monitor

Problem w/Dell E176FPf monitor stuck in power save mode


Ok if it the monitor works fine on another unit discount it out of the equation as a monitor problem.I would suspect the driver on the PC that delivers the problem, especially the video card.. Check that the cable is also on tightly. remo ... Dell E153FP 15" LCD Monitor

Analog power save mode


I had the same problem with the same screen as you.i connected the usual blue plug on my pc, and i got the same message as you did.i finally realised that i connected it on the on-board graphics card(VGA?)i added a new plug(adaptor) ... LG Flatron L1951S-SN 19" LCD Flat Panel Monitor

Cannot get new Motherboard to boot up in Normal Mode


What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0237 seconds