Having problems with your eMachines Computer Monitors ?

My emachines says cpu is missimg when turned on


Answers :

Try unplugging and re plugging the tower from the monitor on both ends
Repair Help & Product Troubleshooting for eMachines Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Monitor reads: PC entering power saving mode then shuts off;PC on


First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

My emachines says cpu is missimg when turned on


Try unplugging and re plugging the tower from the monitor on both ends ... eMachines Computer Monitors

The yellow power led light blinks on front of the emachine w2646. The CPU Fan works. The power button will not turn the PC on or off, you just have to plug in the power cord to turn it on. The monitor just stays at a black screen. the Cpu Fan spins. i have replaced CPU, Ram, Power Supply. With no change to the system.


Did you flash the main board ??1.) remove battery2.) press and hold the power button for 10 - 30 seconds3.) replace battery.4.) when the system boots it will say press XX (e.g F2) to load defaults and continue ,, press t ... E-Machines eMachines Desktop PC

This is the same problem on the T6420 I am not sure how to add.


Your problem is the motherboard, it has blown. See my emachine support pages at:\015\012\015\012http://www.motherboardsrus.net \015\012\015\012and click on the text that says "emachine support" \015\012You can contact me by email on the website or by ... E-Machines eMachines Desktop PC

Have emachines T6528 graphics problem


If it doesn't boot at all .( this is the reason that you see that message on the screen it means that no video signal came out from the computer ) ..try to change the cable that leads from the pc to the monitor first ...and if the problem its still o ... E-Machines T6528 PC Desktop

???HARD DRIVE CRASH??? ON DESKTOP EMACHINE


Hi!\015\012we'll do some basic troubleshooting here!\015\012okay, try to relax dont panic stay calm and stay focus we'll do it step by step.\015\0121. open your CPU (be sure to unplug it and loose it from any power connections) ... E-Machines eMachines Desktop PC

PC won't boot after changed BIOS memory settings


With all that you've done, you might have worsened your PC mobo's condition. Now try to remove the processor and memory then PLUG it normally to the power outlet and see if the led in the mobo lights. After 3 minutes, unplug it and reseat the rams an ... Toshiba Satellite A135 Notebook

Has no picture,computer makes a noise when turned on etc...


If you tried with 3 different monitor, then the kid has done a bad job and eventually messed up with some critical system component.(CPU-RAM-Power Supply Unit-Video Card)check if the CPU fan is spinning, if not this can prevent the system from ... Dell Dimension 4600 PC Desktop

System is saying that CPU fan has failed and shuts system down. I just replaced the fan and heat sync it is still saying this.


When you turn the computer watch the cpu fan. Does it turn at all? If it is not turning then there could be a power problem to the power connector on the motherboard. The thermal paste comes in a tube and looks like silicone. It usually comes with th ... HP Pavilion Media Center a1330n - AMD Athlon 64 2.4GHz Desktop Computer (Open Box Product, Limited Avai... (EL466AAABAOB)

Acer t135 pc desktop will not get to bios page or startup at all


1 Did you unplug the PC prior to opening it, and turn off the switch on the back?\015\0122 Did you wear a wrist strap or ground yourself to bare metal on the case before you touched it each time?\015\0123 Did you remove the motherboard fr ... Acer Aspire T135 PC Desktop

My hp compaq nc6400 doesn't turn on. the green


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... HP Compaq nc6400 Notebook

Cant get it to turn on/ panasonic CF-51 toughbook laptop.


Here are some troubleshooting hints, see if these will work for you. It is hard to knnow what to do in these situations because there is no way of telling what key combinations etc. were hit.\015\012\015\012 ... Panasonic Toughbook CF-51 Notebook

My on button just blinks on and off but when I push it to turn it on..nothing happens..its like it isnt getting any connection


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... Acer Aspire 5520-5908 Notebook

Friend has a Emachine T1862 that won't start


May be the CPU fan is going bad. I hope it is that simple. ... E-Machines PC Desktops

Problem with my emachine T6420


This problem comes due to problem with RAM and CMOS.first you get RAM outside the CPU and clean properly by brush,and put into the RAM SLOT.it work.otherwise ,you have to change RAM. ... eMachines T6420 PC Desktop

I changed the fsb from 166mhz to 200mhz on my computer


You will need to clear the coms 0n the motherboard to do this shut it down and unplug it then look for a 3post/pin on the motherboard that says clear coms and has a jumper on it>move the jumper over one post/pin unplug it from the 2pins on the rig ... E-Machines W3052 PC Desktop

Emachines T2482 hit the power button to turn cpu on and everything sounded right but on monitor got a red green blue box flashing says somthing about check pc and some cable. I cant get a picture


Could be a video card failure or a cable problem. This could also happen because the motherboard failed if you have integrated video. Unfortunately your going to have a tech onsite to repair the issue. That is, unless you want to install your own vid ... E-Machines eMachines Refurbished EMA eMachines PC Desktop

I have a 2003 or 2004 emachine that I am trying to start up to get my old info from, however I have two issues. 1. no signal from monitor and I have checked all cables. 2. when I turn on the CPU, there is a repeated beep noise. Any suggestions? What I was hoping to do was to just restart it to a previous date?


One of your ports is not working or your ram is not seated. thus beeping. On mine once I seated my ram the beeping stopped and I could continue.. If you say there is no signal to the monitor maybe the video card is bad. do you have a spare to throw i ... E-Machines eMachines Desktop PC

Whilst in use went completly dead canot resart


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... HP Pavilion dv6000z Notebook

Turns on, cd light comes on but cpu does not boot and light does not come on, the monitor says "no signal" . Cpu dpes not shut off at the button anymore. I have to unplug it to turn it off. HELP! By the way I read to unplug and hold power button for 30 sec then plug it back in, did'nt work. Just want to know if theres something I can do myself or do I have to give in and take it to get repaired.


You should get it repaired. That is likely a power supply failure. Yes, I see you have power, but I still say power supply, because there are 2 types of power: There is Motherboard power and there is CPU power. If CPU power is not correctly flowing, ... Acer Aspire M1100-U1402A Refurbished AMD Desktop PC - AMD Athlon X2 4400+ , 2GB DDR2, 320 SATA II, D

My acer travel mate 5710 just blipped and closed down. NOw will not even switch on. any advice how to fix? The green power light does show for one half second when I press the button but does not function to 'on' mode.


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... PC Laptops

The screen is not going on all that shows up is a black screen with a white slash mark flasing


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... Dell Inspiron 2200 Notebook

Dell latitude d500 had a power socket problem, but now resolved pc will not boot-up, drive spins-up, then nothing, completely dead display i think most likely scenario is mobo is fried, but open to suggestions how tio get this working again


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... Dell Latitude D500 Notebook

No' it's not powering up at all now, can you help' after changinng ac-adapter & battery


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... PC Laptops

My loptop is an Averatec 7100. How can I test the motherboard? I took it to a computer repair shop and they said is the motherboard, I want to know how can I test it on my own.


This is more of a system diagnosis that an actual motherboard testing procedure, but since all components attach to the motherboard in one way or another it could count as a prcess of elimination......\015\012\015\012 ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4886 seconds