Having problems with your Dell UltraSharp 1702FP 17" Flat Panel LCD Monitor ?

LCD causes self-test to fail

\015 Got a pair of Dell 1702FP monitors. \302\240Was able to fix one. \302\240Second one is more difficult.\015\012\015\012\015\012\015\012Monitor lights flash, inverter does not power up. \302\240I went inside, did some part swapping between the monitors. \302\240Can confirm that inverter is good. \302\240\015\012When I disconnect the upper right bundle of wires that goes to the LCD itself, the monitor's power lights behave normally, backlight comes on OK.\015\012\015\012When I reconnect the LCD panel (pixel control, not inverter), the monitor seems to fail a self-diagnostic and the lights blink, no backlight.\015\012\015\012What are typical problems for the LCD panel itself? \302\240Are they fixable?\015

Answers :

Hello,

If the 3 lights are flashing then the problem is afew blow capacitors on the video driver board. We have a step by steprepair guide posted on our web site at: www.ccl-la.comIf you can solder then you should be able to do the repair. If youdon't want to do it we do offer a repair service for $30 plus returnshipping. let us know if you have any questions about the repair, youcan contact us at the address below.

I hope this helps, if so please rate our solution.

Buddy
Corporate Computer
www.ccl-la.com
[email protected]
Looks like you have a shorted IC ot transistor on the LCD layer of the panel.

If you remove the screws from the back of the panel and look underneath, you will see the circuit the main board plugs into. Usually there are a few components on this pcb that can go bad. Replacing them is a little hit and miss. If you can identify the component, you might stand a chance. I had a unit do this, and when I looked at the lcd pcb there was a shorted smt transistor. It was burnt, but I was able to remove it without damaging the board.
I managed to replace it twice with two similar transistors, but the panel still caused the power circuit to cycle when I plugged it in. Although I couldn't find any other shorted parts, the small smt ICs on the board could have had internal shorts, or the transistors I used to substitute were completely wrong for the circuit. Since the original transistor was burned, I could not identify it in any way.

The only hope for your monitor is to identify and replace the bad smt component on the LCD board, or replace the lcd layer itself. I've done this a few times, but it requires another of the same panels, one with a bad backlight perhaps. If you are careful enough, you can remove the metal frame assembly from the panel (there are usually four screws, two on each side). You will have to "unsnap" the outer frame from the inner frame all the way around the outside.
Do this to both panels, and place them face up on a desk or bench. Carefully unwrap the ribbon cable and remove the entire lcd layer. Do this a second time, only place the working lcd layer over the working backlight assembly. Make sure the lcd layer seats snugly in the frame and wrap the ribbon cable over the top. Reinstall the outer frame. You have to make sure everything stays aligned as you snap the outer frame back into place. Reinstall the screws. Now you should have one perfectly good lcd panel. Keep an eye out for a panel with a bad backlight.
Repair Help & Product Troubleshooting for Dell UltraSharp 1702FP 17" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No display lights


Run the PSA Diagnostics and Obtain the PSA Error Code \015\012To run the PSA diagnostics and obtain the PSA error code, perform the following steps:\015\012Shutdown the computer.\015\012Press and hold the <Fn> key, ... Dell Inspiron 9100 Notebook

17 inch monitor goes blank - X2Gen MG19MY 19" LCD Monitor


\015\012Prepare to diagnose the computer .\015\012\015\012\015\012\015\012Disconnect all peripheral devices.\015\012\015\012Perform a Hard Reset.\015\012\015\012Disable th ... X2Gen MG19MY 19" LCD Monitor

LCD causes self-test to fail


Hello,If the 3 lights are flashing then the problem is afew blow capacitors on the video driver board. We have a step by steprepair guide posted on our web site at: www.ccl-l ... Dell UltraSharp 1702FP 17" Flat Panel LCD Monitor

I have a red vertical line on my dell inspiron laptop.How do I remove it?,please


Try connecting an external monitor to the Dell Inspiron 9300and see if the vertical line is also present on the monitor. If themonitor display is fine, then your laptop’s LCD display panel isdefective. If the monitor also displays the ver ... Dell PC Laptops

Envision LCD monitor keeps cycling on and off


Davagain, Your stated symptom leads me to believe that L17LCD2 has a problem in it's power supply/electronic CCFT ballast circuit. The primary cause of the on/off, on/off, being that the SMPS is detecting a fault and then going into SHUTDOWN, trying ... Liquid Video L17LCD2 17" Flat Panel LCD Monitor

I have a toshiba satellite p305d-s8828 laptop and have 19dc @ plug going into main board and 19dc on motherboard. Is the motherboard fired? And no power on computer.


Since you have measured the voltage on the motherboard I must presume you are saying there is no power "indicator light" on computer. If this is not the case please clarify. If the light is absent please test the battery as these laptops are not de ... Toshiba Satellite P305D-S8828 Notebook PC

Monitor powers on for approx 8 secs then standby.Series of vertical stripes on panel but no image.Guessing the lcd is at fault?


When I applied the solution below, I go stripes when poorly reconnecting the logic board to the plate, and the plate ability to do it job can be effect by bits going on the inverter, wavely screen output etc. The lcd is an assembly kit inside have a ... iiyama ProLite E434S 17" LCD Monitor

Screen shuts off after 1 hour


I have a similar problem on an HP VS17C LCD. After running for an hour, the backlight drops off and I hear a high pitched whine from the power supply.I looked for cold solder joints, and I see a DIP damaged by heat. I am suspecting that ... Computer Monitors

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Computer has frozen on windows logo


1) Which version of Windows ? For the following discussion I am assuming it is 2000, XP or higher. You may also want to print this, it's long.2) Is this this the low resolution Windows logo on the black scre ... Fujitsu Siemens SCALEO 600 (FSP:83C005617) PC Desktop

My monitor shuts off(goes blank for a few seconds


The monitor is doing a self test a finding an error.The lcd has three parts, the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, ... LG L1915S 19" LCD Monitor

I have a proview PA-19DKS MONITOR. It hasn't been hooked into a computer yet. But it has been hooked up to cable so my daughter can watch cartoons.Recently, when it is turned on it shows the blue screen for a few seconds and then goes completely black. What could be the cause?


The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inverter, ie capacitors, all three take a\015\012bit of power from th ... Proview PL913S 19" Flat Panel LCD Monitor

Laptop shuts off every ten minutes


Hi.\015\012\015\012As you have mentioned that your notebook is overheating. I suspect that the issue is with the Fan of your notebook . However, to isolate the issue please try to install BIOS update and perform the Hard Drive self test. ... HP Compaq Presario V2000 Notebook

I get one long beep and one extra long beep on startup. Computer just beeps and nothing else.


The computer POST (Power On Self Test) tests the computer, insuring that it meets the necessary system requirements and that all hardware is working properly before starting the remainder of the boot process. If the computer passes the POST th ... HP PC Desktops

Harddrive self test


I did a google search to see what results I would get for your request "failed #1-07 none of them who enquired to this problem spoke of the number that came up for you?. But they spoke about not being able to BOOT up to Windows in fact all of them s ... HP Compaq Presario V2555US Notebook

Philips 190S monitor - Urgent!


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Philips 190P6EB 19" LCD Monitor

When it powers up the screen is fine then it goes black with no signal box, then if you turn it off and on again screens comes back for few seconds and then off again, sying no signal. Viewsonic LCD monitor VP720b


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... ViewSonic VA720 17" LCD Flat Panel Monitor

Bios Beep code


Beep Code Manual, Better Than Gold Techies, American Megatrends Int. & Phoenix\015\012\015\012(I'm IT, I use these codes to trouble shoot hardware issues at my job. Enjoy) cold.gif\015\012\015\012BIOS Beep Codes\015\012\015\012W ... PC Desktops

My Samsung Syncmaster 245bw LCD displays a blank screen.


Wardysbiz, I should think SAMSUNG would ship you a replacement unit. It might be what is called a REFURBISHED unit of same model.\015\012In future try not to use the word BROKEN. I thought an elephant stepped on it, or it fell from a great he ... Samsung SyncMaster 245BW Monitor

Gateway monitor FPD1975W-UK screen fuzzy lines for a few seconds blue on & off light flashes on and off then screen goes blank also a small current coming through the pc connector cable.


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Gateway FPD1975W 19" LCD Monitor

Gateway 450sx4 has very dim lcd, almost invisible. otherwise it (the computer) is ok


Hello and thank you for using Fixya's services. I have a couple of questions and some troubleshooting tips for you:Questions: Is the splash screen coming on at all? Any picture or text right when you boot up? What Window ... Gateway 450SX4 Notebook

Dell 173FP - black screen - green flashing power LED


Nofun846, Software won't help you. All the fixya lcd monitor tech's already know what the problem is. Monitor 's "switch-mode-power-supply"/"ccfl inverter supply" not working properly or has failed and gone into partial or full shutdown mode to try ... Computer Monitors

My dell vostro 1000 laptop's display ain


If i read this right, when you power up the laptop you get fan spin but no display ?, if you just get fan spin and the green power light and nothing else the you have a motherboard failure, if you get LED activity and it seems to be working but you o ... Dell Vostro 1000 Mobile AMD Sempron Processor 3500+ 60GB/1000MB PC Notebook

When i turn it on a black screen comes up w/DOS-type writing on it saying "we apologize for the invonvenience but windows did not start successfully. A recent hardware or software change might have caused this" and it gives me choices: safe mode, safe mode w/networking, last known configuration, or to start windows normailly... but it freezes up and doesn't let me choose...


Dear Customer,\015\012Do the following Steps:\015\0121.)Run the Hard Drive Self Test from BIOS.Turn On the Notebook and kepp on tapping F10 key and go to the Diagnostics and Select the Primary Hard Drive Self Test and Press Enter and Run ... HP Compaq Presario V3000T Notebook

Hi we have a ctx monitor PV720A that stays on for a couple of seconds then goes black


Glenn659, possible cause is bad internal switch-mode-power-supply" failure or SMPS is detecting something wrong with lcd cold-cathode-fluorescent-tube backlighting circuit, (INVERTER) and it goes into SHUTDOWN mode to try and prevent a catastrophic f ... CTX Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3780 seconds