Having problems with your Dell PowerEdge 1600SC Server ?

Ubuntu Server won't see scsi hard drives - Dell PowerEdge 1600SC Server


Answers :

You will need to load the drivers for the scsi controller assuming someone has written one for a dell server
Repair Help & Product Troubleshooting for Dell PowerEdge 1600SC Server

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ubuntu Server won't see scsi hard drives - Dell PowerEdge 1600SC Server


You will need to load the drivers for the scsi controller assuming someone has written one for a dell server ... Dell PowerEdge 1600SC Server

Poweredge 1800 server


Hey,I looked over the spesifications for the poweredge 1800 servers, go ahead, it will work perfectly but there is one problem in the windows XP setup, you will need to insert / load SCSI or SATA drivers for the hard drive With a floppy d ... Dell PowerEdge 1800 Server

Dell Poweredge 4300 Bootup problem after cmos battery replacement


Check the version for the Raid Controller. This may need to have the firmware to be upgraded. If the controller is removable, take the controller out and then see if the computer will continue past the bios. If the controller is built-in, then disabl ... PC Desktops

No SCSI Chips found on the adapter


You might want to update the firmware for the scsi controler,plus upbate the esm ,and the backplain for the server ,you should be able to locate this on the support.dell.com website.failing that if you are using a raid card this might be bad,however ... Dell PowerEdge 6400 Server

Dell PowerEdge 2450 Server issues


Power down thy system,pull the hard drive half way out remove all cards from the slots power up see if you go pass the processor etc,if not go into the system setup f2,integrated devices turn them all.see if you go further if you do go back in turn ... Dell PowerEdge 2450 Server

Boot from CD is not recognizing the Windows 2003 Server CD


Hv u tried booting from other CDs .\015\012if u can boot from other CDs , then this 2003 CD is botched , change it. ... Dell PowerEdge 1600SC Server

Dell poweredge 1800 scsi drive not found


Hi,check if the drive is showing in the bios of the server, shut down the server, take out the power cable, press and hold the power button so as to realease flea power, open the server, and reseat the data cable at both ends and if there ... Dell PowerEdge 1800 Server

I have a dell poweredge 6400/700 I have 2 scsi hard drive install I WOULD LIKE TO SETup the server to install windows 2003 when i start the server I get a error no boot device avalaible.What can I do


You will need the Dell installation disks to install the appropriate drivers and configure your SCSI controller to recognize the new drives. Do you have the Dell Server utilities and drivers discs? ... Dell PowerEdge 6400 Server

Beeping PowerEdge 1300


When a Dell server beeps in every 3-5 second that mean it comes from Raid controller.Dell calls PERC Controller.It usually reason of a disk failure.Install open manage server administrator on your server.See which disks ... Dell PowerEdge 1300 Server

Dell poweredge 1650 and norton ghost


Okay, hate to answer my own question. Where I got confused was with the protocol.ini file that is used in Norton Ghost on a boot disk to load the network information, including the network protocol to be used (netbeui in this case) and what network ... Computer Servers

My operating system will not load


Try removing all of the hdds or just leave one that you think it works. See what happens. ... Dell PowerEdge 2500 Server

I have lost the scsi drive on a dell 1600sc and would like to convert to sata. During boot up the sata controller is reconizing the 2 hard drives but, come but with "no primary drive found"


The best thing to do is reinstalling SCSI, SATA can only manage two disk per channel on this server, and the data transfer time is longer.If you set SATA, check jumper settings, that is probably reason why you get no primary drive.A ... Dell PowerEdge 1600SC Server

How many hard frives can be installed


You can put as many drives as you can fit as long as you have the cables and connection. Usually 4 is the max in a computer, but you can by a SCSI IDE card and add even more. The biggest problem is to make sure that the jumpers are set to slave on ... Dell Dimension 4600 PC Desktop

Problem I have dell server poweredge 830 and install the window xp server 2003 a problem has occured. When i try to reinstall the server 2003 then the disk is formated automatically. data is lost. the system is not booted from server 2003 CD. Plz tell me solution. i shall be thankful to you. Abdul Razzaq


This server direct not boot by windows cd....and u any time install window u lose the all data....because they have scsi hard drive and configuring bydefault Raid 5 ......so plz make backup before u start this prosiger.......Dell providing u lo ... Dell 2.8 GHz Second Processor for PowerEdge 830 Server Pentium 4 (DF904) Processor Upgrade

Drive Options with a Dell Poweredge 2600


I would definitively not recommend to remove the backplates, unless you want to ask for serious trouble with your system.I would install a PCI SATA adapter card (one like ... Dell PowerEdge 2600 Server

Constant beep on poweredge 840 appears to work alright


Hi\015\012\015\012Besides standard beeps codes indicating Processor, CPU, Memory or Systemboard failures, \015\012Dell PERC (PowerEdge Expandable Raid Controller) or SAS Controllers (Serial Attached SCSI) generate beeps to alert fai ... Dell PowerEdge 700 Server

Boot from non Dell raid controller


Check the Boot Sequence again -- if there are any "SCSI" devices listed, enable them, and make your CD-ROM the "primary" boot-device (so that you can install Windows) and make this "SCSI" device the SECONDARY boot-device, and disable the internal har ... Dell PC Desktops

Our 1600sc dell server is beeping continuosly.


Check the PowerEdge Raid Controller for parity problems. Sounds like the status on the physical volumes participating in a RAID array has been degraded.Loud beeping from a drive is usually an indication that an invalid drive array member ... Dell PowerEdge 1600SC Server

Poweredge 1600sc cant see other 4 drives


You may have a raid 5 setup. you should be able to confirm this within the raid bios (ctrl+m). if all disks are part of the raid 5 array i believe you will only see this as one virtual disk. a raid 5 array will put the data across all the disks along ... Dell PowerEdge 1600SC Server

DELL PowerEdge 1600sc - New motherboard no joy


Are you sure the new motherboard was of the same revision as the old one? Dell shipped 400FSB boards during the beginning of the 1600SC line and shipped 533Mhz boards during the end of the run. I would check the revision level of the motherboard to ... Dell PowerEdge 1600SC Server

Dell Vostro 200 desktop with Windows XP is not able to handle two


Go to BIOS set up and change the Primary Hard drive as the 1.5 Tbsecondary hard drive will be the 500Gb then save the setting and restart.second optionconnect only the 1.5 Tb and try to turn on the computer . ... Dell Vostro 200 Desktop Computer Intel Pentium Dual-Core Processor E2160 1.80GHz, 1MB L

Dell PowerEdge 1400SC Can not locate hard drives or partition


You need to download Dell's Storage Managment ISO file, create a CD, boot the system with this CD and set up the array. This will also give you the option to install the O/S with no user input. ... Dell PowerEdge 1400 ( pe1400/210 ) Server

Ntldr is missing


I work For Comapq and Hp computers and can understand your issue...\015\012when ever we get the issue like Ntldr is missing ..\015\012we perform the recovery on the computer, in all HP and Compaq computers we have a recovery partition on ... Compaq Presario sr1111nx 2.53GHz Celeron Computer (SR1111NXRB) PC Desktop

While Booting My Desk top Precision 360 of DELL.I have SeagateST373453LW SCSI Hard disk.At start up disk is recognised but capacity is not. If I am Verifying or Formatting my drive throug Ctrl/A for configuration utility, It go on formatting till 5 hrs it does not end. And the problem persists.


There are a couple of things here..First I am going to assume this is the LSI card that came with the Dell.1. Since it is a RAID card, the formatting you are seeing may be referring to the RAID structure. Does the configurat ... Dell Precision 360 PC Desktop

Cannot find OS, wont let me reinstall OS, possible missing drive?


Why not try to install and use Linux Ubuntu, great and always free support, fantastic community forum board, free OS and free updates. Works great for me live (from CD) and installed. Give it a try before you refuse. \012www.ubuntu,com ... Alienware PC Systems Area-51 m17x Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8380 seconds