Having problems with your AMD Compaq Presario SR1030NX Athlon XP3000+ MiniTower w/ DVD+RW (SR1030NXRB) PC Desktop ?

No signal when turned on

\015 I turn it on there is power but not in the keyboard or cdrom drives and stuff. the monitor just goes into power saving mode. it just happened over night nothing unusual happened. i just turned it off one night and turned it on the next day and it wasnt working\015

Answers :

Hi! Odhran
\015\012Not good to mee too, may be is your motherboard problem, or, just reset the CMOS on MOBO, be carefull on that, like Furion187 say, and try to startup your PC, if not work, you may have a power supply problem, time to change, or your RAMS are bad. take out one DIMM and try to restart, or if you only have one DIMM put it in other slot.
\015\012Good luck!
Not good... sounds liek the motherboard has gone up the creek , try removing the left side of the case , remove the little round battery on the mother board , take it out for 30 seconds then put it back in and try start the computer then
Repair Help & Product Troubleshooting for AMD Compaq Presario SR1030NX Athlon XP3000+ MiniTower w/ DVD+RW (SR1030NXRB) PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

NO SIGNAL What do I do?


These messages are normal when the computer truly goes into suspend mode or loses the video signal (such as when the computer is suddenly turned off).If the monitor displays any of these messages when the computer should be displaying vid ... HP PAVILION A6230N DESKTOP PC

Monitor comes up shows "acer" then says no signal and goes black


The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor

Emachine T6410 turns on but the screen says ''No Signal''


When you get the no signal ..this is just the cable that plug into the monitor...either on the video card ..or on the monitor side...but it is sure the cable ...whenever that signal is on ...this means that it do not detects any video signal came fro ... PC Desktops

Hello Sony RB30 w/ sdm-hx93 monitor. Approx. 7


Blond and Baffled, (CD), it's okay, I believe you have a common problem.The computer sends a video signal to the monitor. The monitor is working fine. Hence - No Signal.Monitor doesn't receive a video signal within a certain s ... Sony VAIO RB30C (VGCRB30) PC Desktop

When i turn on my computer all it tells me is sva no signal input please check video signal


No Signal. No signal coming from the computer.The monitor is working, but there isn't any video signal coming from the computer.1.Could be a bad video cable. The one from the monitor to the computer. Do you have another ... SVA-USA VR 17S 17" Flat Panel LCD Monitor

Viewsonic VA712b issuses


Digital-to-Analog Converter - DAC\015\012\015\012\015\012\015\012\015\012When referring to Audio, DAC is also short for Digital-to-Analog Converter and is the pro ... ViewSonic VA712B 17" Flat Panel LCD Monitor

Fujitsu-Siemens P15 TFT power/picture problem. it take time to turn on.


It does indeed sounds like the capacitors, I had this problem last year with a Medion monitor where it would turn on and off, when I spoke to Medion they did say that it would need a repair but at the time I wasn't enclined to pay the repair fees for ... Fujitsu Siemens Premium Line P15-1 15" LCD Monitor

Dell 2407WFP Monitor losing signal and having colored line artifacts


... Dell UltraSharp 2407WFP 24" LCD Monitor

Monitor comes up shows "acer" then says no signal and goes black


This Problem is Acer(s) Monitors. Though it is a nuisance one fix That has work for many is the Unplugging after it goes back to Good (viewable) screen. I have hooked mine up to an inexpensive Power strip to make it easier for me and just turn ... Acer X241Wsd Monitor

No picture on the screen


Hi,I have this Panasonic PanaSync SL70 17'' monitor, I don't use it often. It is still in very great shape. However, I tried to turn it on yesterday, I got a black screen. The power LED is on and I can hear the relay is clicking whe ... Panasonic PanaSync SL70 (White) 17" CRT Monitor

No signal on first boot


I think is a power supply problem,, ... Nokia 445 Pro 21" CRT Monitor

My monitor not turn on when the computar turn on to . and when you try to turn on the monitor its like flash for 1 sec and tune off to black . to turn the monitor on i need to prees the botten 30 time on the monitor to turn him on.


First you sec your monitor power cable is not loos or power in properly if ok then you sec your monitor VGA cable is properly conect to your pc if ok then you disconnect your VGA cable in your pc then you power on your monitor and sec that youre mone ... PC Desktops

I get "No Signal" shortly after the computer is turned.


There is a problem by the programming chip insifde of monitor. It can be faster fixed but only by an expert. If i've help you, please rate me! Thanks ... Acer AL1916W 19" LCD Monitor

Monitor says no signal


Is this a brand new system? What is the make/model?\015\012\015\012This is a peculiar problem, as the computer was working fine for several months after you purchased the computer, then suddenly started this behavior. The fact that you ... PC Desktops

Monitor shows ''NO SIGNAL''


This is normal. The monitor is telling you it is not getting a signal from the computer, which is true because you've turned off the computer. The monitor power is still on, however. The monitor power is not controlled by the computer power switch. J ... Computer Monitors

Monitor goes to white at cpu shutdown


The problem is in the "soft switch" technology:\015\012On some of Sylvania's newer monitors they have incorporated what is called "soft switch" technology. This allows your ATX power supplied computer to turn your monitor on and off using it?s softwa ... Sylvania L181 18.1" Flat Panel LCD Monitor

No signal to monitor


Checking if anything in ur computer is plugged inor unplug the power wire from the computer, turn the computer on twice (there is no power in it so it wil run like 1 seconds then turn off again), then plug the power back in and turn ur computer ... Gateway GT5408 PC Desktop

Power button blinks - won't turn on


When the power light blinks, it indicates in PC mode that there's no PC signal (depending on the monitor, it could be the sync signals or a combination of sync and video.)You SHOULD be able to hit the source button to see if the monitor t ... Samsung SyncMaster 150MP Monitor

Wireless adapter radio


When your computer is switched on, the WiFi radio is almost always transmitting or receiving signals. In certain situations, as in an airplane, signals from the radio may cause interference. Use the following methods if you need to disable the radio ... Acer Aspire 3000 Notebook

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

AL2423W flashes 'No Signal' and turns off and on


Hi Guys,\015\012 This is a common problem with this monitor but I have a fix. Sounds simple but try it it works. Turn your monitor off, then turn it off at the wall, turn your monitor back on to drain any stored power, now turn it b ... Acer AL2423W LCD Monitor

My computer does not start up


Hi im josh in cebu phils.may i help you? Friend try to use these solutions i got this in my book.\015\012Dealing with System Startup Problems\015\012There's nothing scarier than turning on your computer and finding it doesn't start. What you d ... PC Desktops

My monitor turns of randomly


Hello cdannyxd I have the same problem as you and the one thing I found out why it dose this is because:1. The monitor is over heating. 2. The board it self has a faulty conductor.3. Or your video card (or driver) is bad. But if it ... Dell E228WFP LCD Monitor

Signal out of range


1: Signal out of range meas the monitor can't handle the input refresh rate. lcd and Tft monitors usually supports 60 and 75Hz refresh rates.2: The Resolution you are using to view the desktop is too high, this number is depending on the size o ... Kogi L7CH Monitor

AOC Monitor says "no signal" and won't wake up!


This monitor refuses to wake up because it cannot find the signal from the computer. \015\012\015\012When the light is amber, force the pc to shut down by holding the power button until all lights go off. Then, after about 10 seconds, p ... Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3825 seconds