Having problems with your Acer Aspire™ T180 PC Desktop ?

The pc does'nt send any signal

\015 We test monitor with another pc.there is'nt any problem\015

Answers :

Ok, firstly do you see the bios screen at start up before windows starts?

If you do, try repeatedly pushing F8 during the bios screen to go to the advanced boot menu and try booting to safe mode. If you can boot to this then its a driver problem.

If not is the pc booting up? Can you hear the fans and hard drive going, is the hard drive light flashing etc?

If your sure the pc is starting correctly, you need to establish if your using built in graphics or an extended graphics card. Easy way to tell is if your monitor connector on the back of the pc is fairly low in one of the horizontal slots then it's an extended graphics card.

If it is, then unplug the pc and open the side or back, lay it on its side and check that it is seated in the slot correctly, even better remove it and reseat it, push firmly but not too hard, they can be a bit fiddly. Sometimes the cards or CPU's can creep out of the slot due to repeated heating up and cooling down, or can be jogged during transit etc.

If its onboard graphics, ie your monitor connector is higher up in amongst the other connectors etc then you will have to buy an extended graphics card PCI, PCIe or VGA as its difficult to fix onboard faults without replacing the whole motherboard.

Let me know how you get on.
Repair Help & Product Troubleshooting for Acer Aspire™ T180 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

G25 wheel not responding


Hey! I had a similar problem! Only the weel tried to calibrate itself, but itjust "twitched"So I tried replacing the power cord with a similar one from an older wheel. Didn't work for me.I opened it up and voilá, same p ... Logitech G25 Wheel And Pedals Set

I have installed a netgear wireless router according to the wizard disc and it says I have completed it..however it is still connected to the computer..how do I make it wireless?? If I just disconnect it from the back of the PC I can't get on the internet!


Wireless hasnt got nothing in relation to the wired internet ports on your computer. think of it as two seperate books.\015\012\015\012if you have brought a wireless router, you SHOULD have brought a wireless card to go inside your comput ... PC Desktops

Hi,could some one walk me through setting up my Billion modem wirelessly to my Dell Desk top running XP home. I get confused with firewalls,LAN settings etc Ethernet cable is being used at the moment. Do you need drivers etc


I am not familliar with that brand, so I do not know if it is a cable/dsl modem, a router, or a combination of the 2. I will assume it is the cable or dsl modem since you said modem.The thing we need to do first is give you a basic unders ... Dell PC Desktops

Acer AL22223W Monitor have been using for about 16 mnths and now stopped working when powered on stays on for several seconds then disconnects from computer (doesnt get the signal). I tried it on two computer and didnt work other monitors worked fine. Please help.


First replace the power cable, if that dosn't work, Send it back to Acer, tell them your problem, they should replace it. If you have the recipt for it, you m ight want to send that or a copy of that aswell. ... Acer PC Desktops

Beep code 4 2 3 3


4-2-3-3 \011Extended Block Move.read this. It may help youhttp://www.cybertechhelp.com/forums/showthread.php?t=161582 ... Lenovo ThinkCentre M52 PC Desktop

Dell monitor E152fpb


The orange light means that the moitor is not seeing any signal. Make sure that the cable is in the correct position on the PC. If that is correct, try it on another PC to determine whether or not the monitor was damaged internally during moving or ... Dell UltraSharp E153FPb 15" LCD Flat Panel Monitor

Trying to get computer to display on my tv


You mean your tv doesnt recieve signals from your computer try using a monitor and a tv first at the same time then go to the graphic video to change it from monitor to lcd tv. ... PC Desktops

Monitor Powers on Blanks screen with Vertical lines


You can't always see where the solder is off . \015\012Sounds like you need to purchase a new video card.\015\012But before you do ,.. go into your control panel and reset everything in the display settings to original.\015\012Advan ... Computer Monitors

SAMSUNG SYNCMASTER 172N


Try to unplug the monitor on your pc then you if you see no signal there is no problem with your monitor maybe the problem is the graphics card or the driver installed ... Samsung SyncMaster 172N 17" LCD Monitor

Cant hook up


Ok... so im guessing your using sat for internet, so you would set one plug with zyxel PL-100 and it sending signal in, while adding zyxel PL-100 a computer works, and another craps out... Solution: use a router insert satalite into wan port, s ... PC Desktops

Blink screen the computer turns on but the screen is blink


Do the lights on the laptop come on (does it have power?) \015\012if they do connect the laptop to an external monitor if you get a normal display thats good its sending a signal\015\012\015\012try pressing FN + F4 it should toggle between normal and ... Compaq Armada 7400 Notebook

I have a Toshiba Satellite A305D-S6848. Last


Connect an external monitor to your laptop. Start your laptop and use Fn+F5 buttons (or those appropiate to your model) to send the video signal out to the external monitor. If you do not get any image on the external monitor it means that most proba ... Toshiba Satellite A305D-S6848 Notebook

I AM TRYING TO TURN MY JVC TV INTO A MONITOR FORMY LAPTOP BUT I CANT SEEM TO GET THE RIGHT CHANNEL. I KNOW ITS NOTHING TO DO WITH MY LAPTOP SO ITS TO DO WITH THE T.V. I THINK I NEED SOME SORT OF CHANNEL TO PUT IT UP ON. THE JVC REMOTE MAKE IS CALLED RM-C55 BUT I DONT KNOW WHAT THE TV IS CALLED. PLEASE CAN U HELP


Hi dear\015\012Laptop Multimedia \015\012Ports Info \015\012\015\012\015\012\015\012 ... PC Desktops

I keep losing the internet signal and going offline. LAN indicates pending??? How do I perform a system reset with Linux??


Power cycle the system by shutting it down and switching it on after at least thirty seconds. Check network settings to verify the IP address and other related information. Determine if the network card is working adequately. Identify the malfunction ... ASUS Eee PC 2G Surf Notebook

How do send monitor signal to my tv


Not familiar with this particular model but a lot of factors are involved here and it may not be possible depending on both the television capability, and the video hardware on that model of computer. However your question about how to SEND the signa ... Compaq Armada M700 Notebook

Screen comes on says Acer then No Signal, and goes out. if shut power off and then back on get same result.


This means the monitor believes it's not connected to the computer. Verify the cables first of all. Then try booting in safe mode (F8 key at PC startup) in order to verify that the PC is sending data to the proper video port (you might have a dual VG ... Acer AL2223W 22" LCD Monitor

HP Pavilion ZX8000 in constant reboot cycle


If you start tapping F8 after you turn the machine on, will it give you a boot preference? If so, boot to safe mode, then take the computer back in time. ... HP Pavilion zd8000 Notebook

My tower wont turn off and monitor says no input signal and keyboard doesnt work


Do you have two video outputs on your PC ie. one on the motherboard adn a separately installed card maybe? If you do you need to set the BIOS so that it uses the AGP/PCIE video card and not the 'onboard'. Try the onbopard vodeo card first to see if y ... HP Pavilion a1610n PC Desktop

Power is on(green) but no picture or (no signal)


The sound from relay due to failure start this failure caused by short circut in horizontal sweep transistor beside the high voltage transformer ... LG Studioworks 563N 15" CRT Monitor

No display the stand by light goes from orange to green the no signal dispay comes on then goes...but the display does not turn on. Tried a different monitor with the same video card and it works. What's the problem


Normal\015\012 0\015\012 \015\012 \015\012 false\015\012 false\015\012 false\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 MicrosoftInternetExplorer4\015\012 \015\012\015\012 \015\012 \015\012\015\012\015\0 ... Neovo E-19A 19" LCD Monitor

I have recently moved house from a virgin broadband connection taking my router and lap top with me. My new home has existing virgin broadband. Having plugged everything in as should be my laptop finds the router, connects with an excellent signal, however it fails to connect to the internet as previously. Does it require recoding, resetting or ? pls help


Try reseating te broadband connection to the router. \015\012\015\012It soundslike your router works if it connects to your laptop with a great signal. But its not sending any information through.\015\012\015\012Try reseating. ... Belkin PC Desktops

Monitor says no signal


This could be a multitude of things. Firstly, check the connections from your computer to your monitor, unplug them and plug them back in, make sure the thumb screws that connect your monitor to your computer and nice and tight but dont use a tool to ... Northgate (STAX2517C2) PC Desktop

Router problem. Time Warner had a internet problem last Sunday, April 26 here in the Northeast. They fixed it, but our internet still didn't function properly as it did before the TWC problem. Very slow connections and timing out most of the time. Talked to TWC tech person, and found out that internet was fine to my main computer, but when the router was hooked up the problem came back. Netgear WGR614 v4. Only thing TWC said was to try and change channel. We tried but problem still exists.


Wireless Connection Drops with Windows XP Service Pack 1\015\012 \015\012 Problem:\015\012 \015\012var js_3;function initPsDisplay(){js_3 = new PsDisplay({"info":{"controller_name":"PsDisplay","name":"PsDisplay ... PC Desktops

Bad connection between laptop and lcd projector


I am using an LCD projector Epson and keeps on breaking down. supplier will insist that PC is causing the damage. Is there a posbility that incomplete connections in the cabling will cause breakdown, missing grounding maybe in Hor-vert sync? Or can i ... Compaq Presario 2140US Notebook

Sleep mode when my pc sends the display to sleep the monitor doesn't power down but displays a blue screen


Does the monitor go to sleep when you unplug the video cable? If so, then the computer is still sending a signal, if not, check the monitor menu settings for no signal settings. ... ViewSonic VX2435wm (Silver, Black) Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1719 seconds