Having problems with your PC Desktops ?

Hooking up a Kworld SA240 Wirless AV/PC to TV. Everything is working except the picture on the TV is continuously scrolling like the vertical hold is out. I"m thinking this has something to do with the refreash rate but not sure. I've tried the other refresh rates available on the pc in control panel but that's not helping.


Answers :

Hi and welcome to FixYa,

Initially and depending where you are, the color system has to match (PAL or NTSC). To my understanding the KWorld SA240 is set to PAL by firmware default and must be changed to NTSC. This could only be accomplished by the OSD (on screen display) settings through the remote.

Good luck and Thank you for using FixYa. Happy Holidays.
Try switching the input channel on tv until you get the right input.

If the TV is connected using a cable, try a different cable, and test the connection.
Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

ViewSonic VX922 monitor - black screen - green power light flashes


PLEASE read Carefully so here is a fix for the green blinking light ...the monitor is going into shutdown....protect mode......THIS is ...Only for the seasoned electronic service tech ......YOU NEED TO BE into Electronics ..or have electronic backgro ... ViewSonic VX922 19" Monitor Flat Panel

Screen shrinks monentarily then zooms in untill screen is blank, then turns off.


OK PEOPLE I GOT THE SOLUTION TO THE MAG INNOVISION LT916S GOING BLACK AFTER ANY LENGTH OF TIME BEING ON!!! I JUST REPAIRED MINE TODAY! THE PROBLEM IS THE CAPACITOR BANK IN THE POWER SUPPLY PART THERE ARE 6 CAPACITORS I HAD A FEW LEAKY ONES "NOT GOOD" ... LG Flatron 915FT 19" CRT Monitor

Hooking up HD computer with HD TV


Ye sounds like your pixles settings may be to high you said you had 2 dvi connections on your video card to clarify do you have another monitor on the other connection or do you just have one dvi hooked up on your Video card you can try and fix the ... PC Desktops

Hooking up a Kworld SA240 Wirless AV/PC to TV. Everything is working except the picture on the TV is continuously scrolling like the vertical hold is out. I"m thinking this has something to do with the refreash rate but not sure. I've tried the other refresh rates available on the pc in control panel but that's not helping.


Hi and welcome to FixYa, Initially and depending where you are, the color system has to match (PAL or NTSC). To my understanding the KWorld SA240 is set to PAL by firmware default and must be changed to NTSC. This could only be accompli ... PC Desktops

Emachine cant find operating system


Hello,\015\012\015\012If it doesn't show a HD in bios, that means that either the HD isn't connected properly ie you have 2 devices set as slave or master on same ide cable and it cant detect the HD. ... PC Desktops

Problem with my LG monitor L194WT


You will have to increase the referesh rate first and then go into the game and reset the resolution. The resolution bit is secondary. If increasing the refresh rate works, then you dont have to change the resolution :) ... Computer Monitors

Screen shows different colour grids when starting then goes black with message in right corner "out of range"


Hello ssi1,This happens when your screen resolution is set to something higher\015\012than what your monitor can display. For example, if your monitor\015\012supports resolutions of up to 1024x768 and your video card allows you\015\012to ... PC Desktops

Compaq Presario sr1720nx has wavy video. You can see everything okay it's just that the video is wavy and kinda taxing on your eyes. It does this with every monitor I hook it up to. I've also tried a different power supply still same results. Tried disconnecting DVD drive and any other devices not needed for boot up and still doing the same thing.


Is it wavy all the time or just when windows is booted up? Try booting up in low res mode or safe mode and see if the problem continues. What is the monitor refresh rate set at? Try lowering the refersh rate. The on board video/video card may be goin ... Compaq PC Desktops

Ive got the screen hooked up to my lap top everything looks great but when i play a movie the screen flickers


Screens will flicker during movies if the monitor settings or drivers are incorrect.\015\012\015\012Check to make sure that the drivers for that model monitor are installed and up to date.\015\012\015\012Go into control panel& ... LG W2353V-PF 23' LCD Monitor

I have an HPa6700y I purchased about three months ago.  At the time of purchase I installed a high-end graphics card myself (ASUS EAH4870 DK/1G Radeon HD) and it had been running beautifully until now.  I have used it for gaming as recently as yesterday morning. Last night I installed a new game and was looking for a headphone jack somewhere on the main unit--not sure if I accidentally jostled something in the CPU or not, but seconds later my monitor (an HPw1901) went to sleep while trying to


Usually there are 2 problems: \015\0121. a vga card overheat when running 3 games the vga card heats up. try using an case fan or adn a vga fan.\015\0122. the game uses a high refresh rate in this case tri to set a default refresh rate from the vga d ... Computer Monitors

How to install winxp on cybercom fid2010


Look, the cd might not be a bootable disk..u need a bootable disk for this. if u sure its a bootable disk, then try to clean the lens and then reinsert the disk...if this does not sorts out, u need a pen drive then.. ... PC Laptops

IBM 21" frequent tick sound!


Too much refresh rate! set it to 60 hz only! you're over-stressing major components on your monitor! ... IBM P 202 21" CRT Monitor

Front usbs not working(suddenly)


Possibilities:\015\0121) One of your USB devices have faulted, or is causing a resource conflict (or similar)-- Remove all USB devices, and reboot.\015\0122) Your USB chip/ports have been damaged.-- Find a spare HardDisk or ba ... PC Desktops

I'm trying to fix a gateway MFATXNIN NMZ 500SE


Sir,\015\012\015\012\015\012\015\012Press and hold the power button down for 10 seconds.\015\012Make sure that the power and hard disk light-emitting diodes (LEDs) are on.\015\01 ... Gateway GT4024 PC Desktop

HP monitor goes black and asking for frequency settings


If you see the initial boot screen until windows boots then you may have a setting for the refresh tate too high in Windows. Try starting in VGA safe Mode by hitting F8 during boot. Once there you go to control panel, Dis ... Computer Monitors

My hp dv 9000 nvidia graphic is making the screen


Make sure you have set your screen resolution to the resolution that your monitor can display and the refresh rate is not too high. Try using default refresh rate and see if you will have the same problem, it fails try 60Hz.This one work ... PC Laptops

Cant install voodoo3


It means that the refresh rate is set too high or too low for the monitor, you can adjust this in the system BIOS, or use the onborad graphics, right click on the screen, select properties, go to settings, advanced, and change the refresh rate from t ... PC Desktops

Wavy lines, goes black during video games.


It sounds to me like the monitor's refresh rate is too low to support your current settings, and the demands of the game. Have you tried adjusting the refresh rate? If I'm right, you should be able to fix the wavy lines that way. I'm not sure how ... Proview PL926WBi 19" LCD Monitor

Monitor shaking problem but dont think its the monitor!


If both monitors are shaking,problem is with video card or motherboard,you might try loading specific drivers for your video card or try changib=ng refresh rates.\015\012Please rate the solution and provide feedback.\015\012Samir ... BenQ FP71E 17" LCD Monitor

Video card my display is divided in 4 parts


1.Make sure your video drivers are all up to date\015\0122.Make sure your screen refresh rate is set to something the screen can cope with\015\0123.Make sure you are not trying to use a screen resolution that is not supported by your scre ... ASUS PC Laptops

Viewsonic P225f CRT - clicking "short circuit" sound, shrinks and expands


Just on a whim I'd say open er up and dust it out , and look for bad solder joints.\015\012\015\012That means get out your soldering gun and have a look around the board.\015\012\015\012what you described is "intermitant failu ... ViewSonic P225f (Beige) 22" CRT Monitor

Monitor Picture is Blurry because of shadows


If you've already checked all your cable connections, to make sure they're tight, check your windows settings: Go to Start>rt click My computer, choose properties, settings on performance, and choose adjust for best performance. (This will unche ... Gateway FPD1760 17" LCD Monitor

Continuous Beep-Beep-Beep.. When I turn on T3304 E Machine


There is a faulty hardware in your PC. here the beep error code this might help to locate the faulty hardware in your pc, and which help you to isolate the problem.\015\012 \015\0121 Short beep - System is operating no ... E-Machines eMachines Desktop PC

Speakers stopped working/no audio device installed? I have always had sound until a week ago.


This is a problem with ur sound driver, which accidently got corrupted due to certain reasons... anyways its not useful to know the reason but u've to know how fix this...so now go to my computer, right click & select properties... ... HP Pavilion dv9000z Notebook

Syncmaster paower button blinking and no display


CHECK THE REFRESH RATE ON TH OLD COMPUTER MONITOR AND MOVE IT TO A HIGHER REFRASH RATE IN THE CONTROL PANAL, MONITOR, PROPERTIES, ADVANCE SETTINGS\015\012\015\012ROD ... Soyo DYLM1986 Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7567 seconds