Having problems with your Computer Monitors ?

Computer monitor keeps auto adjusting screen

\015 The monitor keeps constantly auto adjusting the screen when the computer is in use. The is no obvious way to disable this program.\015

Answers :

I have a Benq that was continually auto adjusting, I used electronic cleaner spray on all the controls (a good spray) and now there is no problem, suspect the controls were sticking, especially the on/off and the auto adjust button
Try this: Right click on your desktop. From the pop-up menu, click on your graphics display (NVIDIA etc.) and then on the monitor you have (Dell1234 etc), or if not listed, click on 'properties', then the 'settings' tab, then 'advanced', then select the graphics display tab (NVIDIA etc.) Go through all the menus and click 'restore to defaults' and 'apply'. Hope this helps.
Repair Help & Product Troubleshooting for Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Computer monitor keeps auto adjusting screen


I have a Benq that was continually auto adjusting, I used electronic cleaner spray on all the controls (a good spray) and now there is no problem, suspect the controls were sticking, especially the on/off and the auto adjust button ... Computer Monitors

My screen below the taskbar keeps on flickering


Hi nvashum,\015\012\015\012Here's what you need to do. First just to see a little more of this flickering, right click on the MS symbol or start button, then click on properties. When the window pops up, go to task-bar ... HP Pavilion a705w PC Desktop

Benq monitor keeps auto adjusting over and over. help!!!


The problem may be that the computer video is on a setting that is out of range for the monitor. To quickly test this, boot to the setup screen. If it is ok, that is your problem. If it still keeps auto adjusting, there is probably a bad component in ... Computer Monitors

AG Neovo X-17a


Hello,It sounds like you have a monitor with a common problem. After a few years some LCD monitors\015\012will blow a power supply. The problem is caused by parts called\015\012capacitors overheating in the confined space of the monitor. ... Neovo AG 17" LCD Monitor

Monitor flickering and adjustment buttons locked


If the refresh rate is not properly set the monitor may have a wavy or an appearance that lines are going down ... This may also cause a flickering affect.\015\012Distorted or skewed image on monitor.\015\012Issue:\015\012D ... Samsung SyncMaster 940N Flat panel Monitor

My desktop is not centered and the fonts are too big. Also my Start button and bottom toolbar have disappeared.


Sounds like your resolution has been set too low.\015\012\015\012Firstly, i'm going to assume you have a 17" LCD monitor, and that you are running Windows XP. (what a guess!) =-]\015\012\015\012Generally, you'd want to right-c ... PC Desktops

Monitor keeps blank even the power lLED is on green


Try replacin a new display card. If it is fine working.ok\015\012If not try fixing for cold solder in the video section.\015\012I suggest video section according your report the light green LED lighted that shows the power section is doin ... Proview PL913S 19" Flat Panel LCD Monitor

Monitor brightness contrast problem


Turn Off auto-adjustment screen ... Proview PL19Wb Monitor

I have a Dell monitor and the text is blurry and fuzzy, how do I fix this?


This is actually from dell support website.. hope it will correct your problem...\015\012\015\012\015\0121 Ensure the correct resolution is set for the monitor. Flat panel monitors display the sharpest, clearest images when set ... Gateway FPD2275W LCD Monitor

Dell E196FP TCo99 Monitor screen problems


The screen colour changing is apparently an auto test procedure on the monitor and was prompted by a fault with the monitor not automatically shutting down when the computer is shut down. The settings on the monitor have been adjusted to rectify thi ... Dell E196FP 19" LCD Monitor

Monitor keeps blank even the power lLED is on green


If it's working fine in DOS, it can only be your display drivers for your operating system. What happes when you start in SAFE MODE? When you PC starts, keep pressing the F8 key, go to Safe Mode. If it works, bring the Resolution down to 800 X 600 an ... Philips Standard 104S 14" cRT Monitor

I have a ViewSonic flat screen monitor. The images on the sign in page are fuzzy and unreadable. I have Windows XP.


I would check the connections between the monitor and computer. Also the refresh rate and/or resolution might be wrong. To correct this, you will need to boot your computer in safe mode. (restart computer, right after the computer's logo appears rapi ... PC Desktops

Auto adjust problem on dell monitor.


I can tell you it was most likely caused by the movement of the machine instead of the memory chip. I would suggest doing a few things, first unplug the monitor from the computer, then power on and through the menu in the screen hit "Factory reset" t ... Dell Computer Monitors

After first turning the computer on, the monitor screen image will sometimes display: off center vertically or horizontally, tinted off color, as lines, or not present at all. SOMETIMES pushing the monitor power on-off switch will produce the corect image. When this fails, disconnecting the power plug and reconnecting it once or sometimes several times will produce correct image so screen is fine and useable after the fussing with the tweaking proceedures described. I have tried changing the m


The screen should have a auto adjust feature. If you are using the Blue - VGA cable this may happen sometimes, it happens on my fully working asus monitors when I use a VGA cable instead of DVI.to adjust the screen or run a auto adjustmen ... Sony SDM-HS73P 17" LCD Monitor

Need to Auto Adjust Envision 20" monitor every time


Yes it may be a memory problem inside the monitor replace the memory from technical person \015\012or refer the manual with the monitor some trick may given so that push menu twotimes or operate like mobole button ... Proview PX-986 19" CRT Monitor

Colors are off after auto adjust


I seem to have found the solution (and the cause, perhaps?) for this problem!I was having the EXACT same problem with a monitor I'm repairing for a friend. The capacitors on the power supply board were blown (CapXon capacitors, who'd've g ... AOpen 19" LCD

Screen auto changes black when conecting


Try resetting the brightness control and checking to make sure that the printer cable is securely connected to the computer and the monitor. Your monitor cable may also have a crack or broken wire in it or the connection itself may have come loose. ... BenQ FP71E 17" LCD Monitor

I have a Westinghouse LCM-22W2 LCD monitor. I believe my power board is bad. I want to either replace the power board or bad capcitors, if I can find them. I do not know how to take off the back cover, however. It almost looks as if a special key is needed in the lower left corner of the back cover. Does anyone know how to remove the back cover? Ed


Have you gone through the user's guide? There are some sleep settings and automatic adjustments that this monitor makes, and other changes that users have inadvertently triggered that seem to be causing quite a bit of confusion these days. Make sur ... Westinghouse 22" Widescreen LCD Flat Panel Monitor

Menu screen appears all the time, flashes through different categories


I tried cleaning the plate as suggested but had the same problem. So I decided to see what would happen if I disconnected the button board all together. I haven't had a problem since. I don't know if this is a good idea or not but it worked for me. Y ... Neovo F-417 17" LCD Monitor

Computer monitor my viewsonic 19" monitor shuts its self off no matter what computer i plugg it into ive tried 5 different computers and all it does is display the desktop for about 3 seconds then says auto adjust then the screen sought of distorts a bit and goes black and stays off, any ideas?


If one of those 5 computers has a working monitor,\015\012set the device-resolution to 800-by-600 and the refresh-rate to 60 Hz.\015\012\015\012Then, disconnect the "working" monitor, and connect the "problem" monitor.\015\012 ... Computer Monitors

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

Computer loading/splash screen pixilated and distorted


If you can, hook the computer up to a different monitor and see if it does the same thing. It sounds like it is an issue with your monitor initalizing but the reboot can complicate things. Also if you have a cd that came with the computer you might w ... PC Desktops

Screen resolution reminder.


Go to the control panel double click DISPLAY then select setting then select 1440x900 ... E-Machines eMachines Desktop PC

After Windows has started and the setup screens show, my Kogi monitor says "out of range" and the screen goes black. How can I fix this?


When you switch from a CRT to LCD, your refresh rate will decrease. This is \015\012easily completed by changing the refresh rate on your computer. To make this \015\012adjustment please connect your old CRT monitor to your computer.1) Op ... Computer Monitors

MONITOR HP L 1940 TFT


I jammed my auto button and the screen now stays on! ... HP L1940T 19" LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8131 seconds