Having problems with your X2Gen MW22U Monitor ?

I have an x2 gen 22 inch monitor and the screen went black. When I jiggle the the cord it flickers on for a second and goes black again


Answers :

Make sure the connector is fastened tightly at the cord end(s).
Repair Help & Product Troubleshooting for X2Gen MW22U Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have an x2 gen 22 inch monitor and the screen went black. When I jiggle the the cord it flickers on for a second and goes black again


Make sure the connector is fastened tightly at the cord end(s). ... X2Gen MW22U Monitor

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Philips 190S monitor - Urgent!


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Philips 190P6EB 19" LCD Monitor

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Monitor Goes black, or flickers on and off


The high pitch sound is coming from the inverter. It is faulty and needs to be repaired or replaced. The inverter supplies high voltage to the CCFL lamp, this lamp gives the backlight to the LCD so you can see the LCD images.\015\012Check out L ... ViewSonic OptiQuest Monitor

Monitor goes blank less than a second after turning on.


If you put bright light at an angle close to lcd can you see a windows shadow, text icons etc, ie still logic power passing,then .... (from a.n. other) after two weeks searching I finally find doctor living stone http://www.aplusperfect.com/articles/ ... Dell E176FP 17" LCD Monitor

My monitor shuts off(goes blank for a few seconds


The monitor is doing a self test a finding an error.The lcd has three parts, the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, ... LG L1915S 19" LCD Monitor

RE:monitor goes black


Monitor going black after a few seconds can be causd by a faulty power supply or inverter. Some monitors have both as one unit.\015\012Sometimes it is basic failed capacitors, After that then I would look at transistors.\015\012The averag ... Acer AL2017 20" LCD Monitor

My screen goes black after a few seconds


Sounds like a bad solder joint on the printed circuit board. Once it heats up then it no longer makes good contact and the monitor goes black until it cools down and makes contact again. You could resolder it if you knew where it was but monitors a ... Gateway FPD 1750 17" Flat Panel LCD Monitor

My Samsung 943N LCD monitor will work for 1 second and then goes black. When I choose the extended desktop option, for example, it will flash my desktop on the monitor for a second and then go black. I have 2 cords that I have tried this with and it happens with both...and I have 2 computers I have tried it with and it hasn't worked with either...so it definitely appears to be a monitor issue. Because it works for a second I am really confused with what it could be (it's not the graphic card obv


Becky_bitz, Do this first! It is only a "rude&crude" evaluation of the state of the monitor's "switch-mode-power-supply" Reconnect 943N to a fully booted KNOWN GOOD pc that has WIN-desktop showing. Then and only then, turn on the 943N and note w ... Samsung 943N LCD Monitor

Monitor comes on, I can see everything perfect then goes black


"Most" newer monitors will let you know if the are no longer receiving a signal. Sounds like the backlight is burnt out. Try getting a bright (LED works best) flashlight and shining it at the screen at all angles to see if you can see any of what you ... Westinghouse L2046NV Monitor

Monitor going black


Be sure that the unit doesn't go into overheating, try to put the the monitor into a hibernate mode when it was no in use, a screen saver will do... ... HP Pavilion F1903 19" Flat Panel LCD Monitor

MAG Innovision LT1919WDb flat screen goes black


When a monitor works for a few seconds or more and goes black it is a problem with the power inverter board over heating because of a bad capacitor or capacitors that are not the right size. There is no problem with the VGA controller since it shows ... Computer Monitors

Monitor Screen goes black seconds after turn on-


I ended up fixing my problem, but I'm not sure what the solution is. I had some faulty electrical equipment that I was using to power the monitor (220V to 110V converter and a bad power strip) and I got rid of them. I was using the converter becaus ... Dell E173FP 17" LCD Flat Panel Monitor

X191w blank screen after 2 seconds


Just got off the phone with Acer Suppport. This was after I sent an email to them, that suggested that I call. 8-/ annoying. So the guy on the phone says there is one thing that we can do before sending it in. Unplug it completely for the wall and co ... Acer X191WSD Monitor

Monitor cold start issue only as #2 monitor


The start up problem is common and will only get worse. Call Samsung as these monitors have a 3-year warranty. No receipt? They will accept your word regarding your purchase. I have\015\012two that failed exactly the same way. I called 1-800-SAM ... Samsung SyncMaster 931B 19" LCD Monitor

Acer 22" AL2223W monitor display goes black after a second


Look at the capacitors in the power supply. Replace them if they look bulged on wither side or leaking. Most likely it is the inverter (the flat object with copper coils about 2 inches long, 1 inch wide). Check the resistance with a multimeter to be ... Acer AL2223W 22" LCD Monitor

HP monitor vs17 goes black with power light flashing


I have repaired an HP 1702 monitor that had similar symptoms by replacing the capacitors on the power supply board but you have to have some electronic knowledge and do some soldering if you can buy the replacement capacitors($10+/-) from a supply st ... HP Vs17 17" LCD Flat Panel Monitor

Gateway FPD1830 Monitor Flickers then goes black


Hello,\015\012\015\012It sounds like you have a monitor with a common problem. After a few years some LCD monitors\015\012will blow a power supply. The problem is caused by parts called\015\012capacitors overheating in the confined space ... Gateway FPD 1830 18.1" Flat Panel LCD Monitor

Xerox XG-91D 19 in. Flat Panel LCD Monitor


Hey rg213 I had a similar problem with my screen over the past week. This is "solution" is annoying but has been 100% effective every time I wish to use the monitor. After your computer has started to boot and the Xerox logo flashes conti ... Xerox XG-91D 19" LCD Monitor

Monitor Issue: 5 seconds of picture the monitor goes black.


I had this similar problem. I found out that there was a bad 1000uf, 16V cap on the power supply board. The cap is too close to a heat sink and over heated. I bought the cap at radio shack for $2, installed it so that it is far away from the heat ... Computer Monitors

Good picture for 30 seconds then screen goes black with a faint ghost of the image


The 12V is for speakers.. the 245bw takes regular 120V AC (same cord as your computer)the buzzing is annoying, though. i don't know if it's a "feature" or just a side effect.. ie, if i could take the case off and poke around, i would. 4 t ... Mag Innovision LT576s 15" Flat Panel LCD Monitor

AL1916W displays for a second and turns black


This is because the backlight is going out, and without it you can't see the image on the display. (If you look closely you can sometimes still make out faintly what's on the screen.)The trouble is frequently because of capacitors in the ... Acer AL1916W 19" LCD Monitor

My monitor will not stay on and goes black after a few seconds when I reboot it. I'll turn the monitor on and it stays on only for a few seconds but I can see all of my programs for those few seconds.


Maryfoldesi1, Your monitor power supply is going into shutdown mode becauce it has detected a fault within the unit. A technician will need to evaluate it. Before doing anything visit YOUTUBE to view vid clips of "LCD monitor disassembly" and "LCD mo ... BenQ FP731 17" LCD Monitor

I just bought a used Mitsubishi-NEC V71LCD monitor. After connecting the power cord, and the video cord, I powered the monitor up. It had a video display for about two seconds, and then went black. I reset the power, and get the same results: video for about two seconds, then screen goes black. Please help! Thanks...Dan


Dhowie, Monitor will need work done to internal "switch-mode-power-supply"/"CCFL inverter supply board. possible bad electrolytic filter capacitors or thermally intermittant component soldering on printed citcuit board. Your CCFL back-lit LCD display ... Dell E152FPb 15" TFT LCD Flat Panel Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6665 seconds