Having problems with your X2Gen MG19MY 19" LCD Monitor ?

How do I set the monitor so the menu will stay on long enough to change it?


Answers :

There should be a setting in the monitor menu listed as OSD (On Screen Display). Try increase the length of time for it to stay on longer.
Repair Help & Product Troubleshooting for X2Gen MG19MY 19" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I set the monitor so the menu will stay on long enough to change it?


There should be a setting in the monitor menu listed as OSD (On Screen Display). Try increase the length of time for it to stay on longer. ... X2Gen MG19MY 19" LCD Monitor

Monitor Cuts Off After 5 seconds


Hi...\015\012do one thing dear ....start ur comp and press F8 key for sometime...it will show u start mode ,select enable vga mode from their and start ur comp..then remove your vga driver and unplug your monitor from ur pc...then press and hol ... Dell Inspiron 8600 Notebook

Screen Not Staying On


Hi TontBrowne,\015\012\015\012I'm not sure exactly what causes this problem. However it seems that lowering the 'Brightness' and 'Contrast' fixes things. The problem is, you can't see the menu without the backlight. However, try this, as ... Dell Dimension 4600 PC Desktop

Dell E171FP Monitor goes black after 2 secs


Hi, I don't think the problem is with your monitor. Your monitor sounds like it's doing exactly what it's supposed to do. The monitor is supposed to turn off if there's no cable attached, which means there's no signal input. When the screen goes b ... Dell E171FP 17" Flat Panel LCD Monitor

The monitor turns off and on repeatedly.


There are lots of reasons why it can shutdown, but happerlly none should be serious. It may be that the B+ or Power supply is too high, look for a pot near the power supply and try turning it down a bit. Also the x-ray protection may be too high, loo ... ViewSonic VE710b 17" Flat Panel LCD Monitor

Blank Laptop Screen


The same thing began to occur on my (old as the hills) Dell Inspiron 2650 about 2 months ago. I have tried updating the BIOS to the newest Dell has for this laptop but it didn't help. I also tried to update the video drivers (no help), regressing t ... Toshiba Satellite 1410-S173 Notebook

Monitor screen turns off almost immediately


Do you connect all monitor wires on ... Do you got with screen or computer some MSI thing... the monitor blue wire must connect that thing then that MSI or whatever must connect to computer ... ViewSonic Computer Monitors

Text/picture shadow Recently I've noticed what appears to be a shadow appearing mostly with text but in some picture as well. It makes the screen look a little blurry. It's not bad but just enough to irritate me. Any suggestions?


Hi rustybob,I have a solution for ya, but there are a couple of variables that could be involved. I assume it's an LCD monitor? How many inches is the viewing area, and what model is it? When you look at an LCD monitor, you pay attention ... Gateway FPD2275W LCD Monitor

At start-up, Sceptre X7 monitor flashes on, then goes black. Must turn computer on and off numerous time before monitor will stay on. How can this be fixed?


I just found after hooking one of these Sceptres with the exact same problem up to a computer that already had a lcd hooked up and the computers settings were fine that if you go to the MONITORS menue and change the MONITORS time setting from 15 seco ... Sceptre X7G-Naga 17" LCD Monitor

Screen will only open for a couple of seconds. I think someone changed the imput settings, but I can't get the screen to stay open long enough to adjust it


Rhettpayne, When you say: "can't get screen to stay open" do you really mean to say that the SCREEN WENT TOTALLY BLACK!! If such is the case then you may have a common problem that E173FP and E173FEP units have. I think that you really need to visit ... Dell E173FP 17" LCD Monitor

How do you get a computer out of preparing to run system set up? it stays stuck there


Before you start looking at reinstalling Windows you need to back up your important data – just in case anything goes horribly wrong. \015\012\015\012\015\012Reinstallation\015\012loadTOCNode(1, 'summary');\015\012\015\012\015\012\0 ... PC Desktops

Blank Laptop Screen


... Toshiba Satellite M45-S265 Notebook

Hp 1907w monitor locking up


Go into the monitor menu and choose factory reset....Make sure the resolution is set correctly. (see ... HP w1907 LCD Monitor

Screen flickers with lines but when i move the screen it stops


Hi, \015\012\015\012A nearby device can cause stray magnetic fields that will cause the display to be affected. \015\012A problem inside the monitor will cause the display to have problems. \015\012If somebody turns on their monitor nearb ... Toshiba Satellite A105-S4004 Notebook

Acer will not run 640x480 screen res


It probably will support. It most likely gives this message because the refresh rate is too high when it switches to that resolution. An LCD monitor runs best at 60Hz. I'm currently on a mac so I can't recall clearly the PC steps, but I bel ... Acer AL1715 (Black, Silver) 17" LCD Monitor

19'' Flatscreen Envision monitor, goes to sleep


Try to positioning well the video card inside the cpu,it will help you a lot, ... Computer Monitors

THE SCREEN OF MONITOR BECOME GREEN .


I would Suggest you don't try fixing this yourself. CRT monitors are basically the same as TV's, and TV's have enough high voltage stored in them to zap and kill, if you just touch the wrong spot. It's not enough to unplug them because they will stil ... LG Studioworks 7D Monitor

Monitor shuts off after inactivity


Hi maggieis,I wouldn't worry about your monitor powering off after 30 min. It's just responding to the power management settings that are configured from within Windows. These settings can be changed so that your monitor alw ... Westinghouse LCM-19v1 Monitor

Hi guys,I have a linksys router hooked up and my desktop connection is fine. My laptop however, tells me my connectivity is limited, despite an excellent signal


Go to your desktop and login to the router, the manual should have the default ip and username/password, or google that info, once your in check the number of dhcp leases and make sure it is set to about 2 more than the number of PC's you have, I hav ... PC Desktops

Screen says mode not supported h:53.4khz v;84.ghz


You should reboot your computer. Immediately after you see the BIOS splash screen (Dell, Acer, HP, etc...) start pressing the F8 key 2 times every second. If you're quick enough, you'll get the Windows boot menu. When you see the menu, select "VGA ... HP Compaq d530 CMT Intel Desktop PC - Intel Pentium 4 2.8GHz, 512MB DDR, 40GB HDD, DVD-ROM/CD-RW, Gi

My monotor its all black but u can


HelloI got this step by step guide to reset a dell monitor i do not know if it works, but you can still try it.Hope This can help you.Instructions\015\012\011\011\011\015\012\011\011\011\015\012\011\011\011\015\012\011\0 ... Dell Computer Monitors

Monitor stays dark


Check that VGa cable is firmly connected at both ends. If you have a DVI connection try switching it to DVI. ... Dell E172FP 17" LCD Flat Panel Monitor

I have a Dell XPS 710 that I had left on for a day. When I came home the monitor was not receiving a signal from the computer, but it was on. I jiggled and tightened the cable.When I shut it off and restarted the fan stays on and nothing happens in the monitor. The light stays yellow. Help


When you power up the computer press F8 key then if you are able to see safe mode and other menu then enter in "Enable vga mode" Then go to start->control panel then display property then settings change screen resolution to 1024*768 then apply an ... PC Desktops

"OUT OF RANGE"


Hi,\015\012It is just that at the initial stage your screen resolution was a tad too high for the capacity of the monitor. As long as you retain the working resolution you should have no problem. To lower or increase, right click on any clear area o ... Soyo DYLM1798 Monitor

Display goes blank when brightness is above 70 percent


This is a generic symptom that could happen to any LCD\015\012monitor.\015\012\015\012The following is a generic answer applicable to most.\015\012\015\012\015\012\015\012Two possible causes are bad capacitors or a bad light inside\ ... Mag Innovision LT776s 17" LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0859 seconds