Having problems with your ViewSonic VG700 17" Flat Panel LCD Monitor ?

I want to repair my dead monitor. Can somebody help me and explain how to remove the back cover to access the electronic board of Viewsonic LCD Monitor Model VG 700. Thanks


Answers :

First take the speaker cover off the front by working it from the top of the cover on both sides with your fingers. It should snap out top first. Then unplug the cable that connects from the main board to the cover. After that take out the 2 screws from the bottom of the front silver cover. them you take off the silver housing on the front by pushing it towards the top from the bottom. do not pull out on it. It seemed easy if i applied the pressure using my thumbs while holding on to the black parts with my fingers.
\015\012Again. the silver front slides up about 1/2 inch and falls off. don't pull out on it.
\015\012After that take out the 4 screws that hold the screen into place.
\015\012The screen then needs to be pulled gently from its housing. Around the screen there is a metal house that holds it in. The metal houseing does nt come out. The screen needs to be gently worked out of it. I started with one corner and the rest came easily.
\015\012Pull it out slowly to make sure you don't put strain on any wires.
\015\012Hope that helps.
Repair Help & Product Troubleshooting for ViewSonic VG700 17" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I want to repair my dead monitor. Can somebody help me and explain how to remove the back cover to access the electronic board of Viewsonic LCD Monitor Model VG 700. Thanks


First take the speaker cover off the front by working it from the top of the cover on both sides with your fingers. It should snap out top first. Then unplug the cable that connects from the main board to the cover. After that take out the 2 screws f ... ViewSonic VG700 17" Flat Panel LCD Monitor

Vx800 flickers when cold


I have repaired several Viewsonic VX800 monitors. The symptoms include a power light that flickers or flashed on and off or a screen that flashes on briefly or stays off. The problem is bad electrolytic capacitors on the power supply board. These ... ViewSonic VX800 18" Flat Panel LCD Monitor

Viewsonic vx800 blinking green light..no picture.....live in los angeles.....who can repair.....is it $ worth it.thanks


I have repaired several Viewsonic VX800 monitors. The symptoms include a power light that flickers or flashed on and off or a screen that flashes on briefly or stays off. The problem is bad electrolytic capacitors on the power supply board. These ... ViewSonic VG800 18" LCD Monitor

The monitor will not power on.


Lucky you - You bought an L1906 Monitor from HP and one day all of a sudden, the Green Power LED just didn't turn on anymore. The Monitor appears to be dead!\015\012\015\012Why? \015\012\015\012Well I suspect it is because HP ... HP L1906 19" LCD Monitor

Need to remove dell e193fpc flat panel covers to repair


First remove the stand. Then at the bottom of the monitor there are two small openings an inch or two from each edge. Starting there with WIDE flat blade screw driver (or a couple of them) it IS possible to pop the catches that hold the back of th ... Dell E193FPC 19" TFT LCD Flat Panel Monitor

The power light blinks solid blue every four seconds or so (it?s off in-between). The screen is blank. None of the buttons on the side function (such as ?menu?). I have a second similar monitor from the computer in the other room I?m using to type this proving the video card and cable are fine. We?ve always (as in years) left the monitor on (w/ a screen saver) but for whatever reason turned it off for four days when we went away recently. The monitor would then not turn back on. After leaving th


Hello,\015\012Two days ago I received a Gateway 900w FDP1975W Monitor from a friend. He told me that he would have to let it rest and it would work for about a hour or so and flash green with lines, then Flashing blue power light, then nothing. ... Gateway FPD1975W 19" LCD Monitor

Toshiba 5205-s503 won't start up


In my 15 year career in electronics, among other companies, I have most notably worked for United Technologies as Test Engineering Technician and as an Electronic Failure Analysis Technician for Jabil (Circuit.) I am unemployed due to US electronics ... Toshiba Satellite 5205-S503 Notebook

My friend gave me a new Samsung 953bw monitor and said that it did not work. It acts like no power is connected. My guess is it maybe a fuse inside. How do you get it open without damage?


I have repiared those boards , but I haven't taken this model apart yet so here are some general notes. \015\012\015\012If you get stuck, email me notes\015\012or pictures to [email protected]\0 ... Samsung 953BW LCD Monitor

7540 Compaq Monitor : Dry solder joints in Horizontal.


The best solution was to throw it out, and purchase a new LCD model, of another brand, as I expect there would be more troubles in the future with the Compaq model, seeing that this is the second time that dry solder joints have appeared in the two y ... Cornerstone Computer Monitors

Hp pavilion f1930 shows pic for 2 secs. then blank


Rather than guessing, or blaming the computer, I fix the F1903 backlight problem. Power the monitor and using a bright flashlight check the screen to ensure there's an image, or the menu when you press the menu button. Nearly every one of the F1703 a ... HP Pavilion F1903 19" Flat Panel LCD Monitor

Vx1932wm-3 monitor has stopped working properly,it will only stay on for around 2sec then lose digital signal and go black,same with analog.cant seem to make it stay on,the light on monitor is blue when it says lost signal, the graphics card is working fine 9400 series nvidia


I had the exact same problem. It's a bad capacitor on your power board. It's most likely the 1000uF 25v one towards the center of the board. I noticed it on mine because the top of the capacitor was pushed out more than usual and it has some residue, ... ViewSonic VX1932WM LCD Monitor

How do you remove the outer case on Viewsonic VG930M-3 LCD


Kauffman014, As far as opening the monitor up you may want to visit YOUTUBE and search for lcd monitor repair/ disassembling monitor/ or something like that. I did see a 9-11 min video there that was fairly good on un-snapping the rear cover from th ... ViewSonic VA1930WM LCD Monitor

Monitor goes blank


I was thinking about your problem, I just had a similar issue and the problem is that the inverter or the power supply with an embedded inverter had gone bad.The reason it goes black is because the inverter fails to provide power to the L ... Gateway FPD 1730 17" Flat Panel LCD Monitor

Open back cover on acer lcdAL1916W


Use the Acer AL1916v service guide as well as the Acer AL1916p service guide to disassemble the monitor. These can be found as PDF's using Google. Please note that disassemling the internal EMI perforated metal cover nor the electronics shown are for ... Acer AL1916W 19" LCD Monitor

Notebook screen stays dark


Make sure you check under a bright light that you can actually see the image.This model is notorious for a bad video card (Radeon) that makes it seems like something is wrong with your screen but if you press down just above the keyboard ... Compaq Presario X1000 Notebook

IC Power 19'' LCD Product PA192D Model # 900G quit working


I C Power PA192D Model 900G, Mfg Sep '05 19inch LCDI purchased this monitor at Goodwill not working for $20. The 900G power light failed to come on and there was no video when turned on. To fix, first pull the 2 screws at the bottom of the back ... LG Flatron L1951S-SN 19" LCD Flat Panel Monitor

Samsung Synchmaster 940N fault


I've had the same problem with mine and just fixed it (well, it's still working now, so fingers crossed).The problem is the high-voltage supply to the backlight is breaking down due to a discharge path somewhere.I took my moni ... Samsung SyncMaster 940N Flat panel Monitor

Xenon LCD monitor will not turn on..


Normal\015\012 0\015\012 \015\012 \015\012 false\015\012 false\015\012 false\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 MicrosoftInternetExplorer4\015\012 \015\012\015\012 \015\012 \015\012\015\012\015\0 ... Dell E173FP 17" LCD Monitor

Acer AL1917W goes black


I have recently opened my AL1917 (not wide) but it should work the same. First remove the stand. This is done by removing the plastic cover over the stand hinge (which appears to be part of the back cover, but is'nt.) Mine was done with simple tum ... Acer AL1917W LCD Monitor

15in dell monitor model e151fpb


Normal\015\012 0\015\012 \015\012 \015\012 false\015\012 false\015\012 false\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 MicrosoftInternetExplorer4\015\012 \015\012\015\012 \015\012 \015\012\015\012\015\0 ... Dell E173FP 17" LCD Monitor

I have a Cornea 1702. It just stopped working altogether. It doesn't even show the menu nor does it search for a signal as it used to while scrolling thru options or select input! I think it's fried, but I remember some time ago i thought it was all done then it started working again. any thoughts?


OK, first off, I'd like to say that I've never worked on the Cornea 1702, but most monitors follow similar designs, especially generic brand monitors.So there are a few things I need to know: What exactly happens when you press the ... Cornea CT 1700 17" Flat Panel LCD Monitor

Cant find where the cmos battery goes in my toshiba satellite a45 s151 laptop


On a Toshiba Satellite A45-S151, the CMOS battery (also called the\015\012“real time clock” or RTC battery) is located under the wrist rest to\015\012the right of the trackpad. This means that you’ve got some major\015\012surgery ah ... Toshiba Satellite A45-S151 Notebook

Can't remove cover of Westinghouse LCM-22w2 monitor


Hey Ed,\015\012\015\012 I hope I can help, It doesn't open from the back, it opens from the front.... carefully! There are four support screws, which hold the LCD screen to the desk stand,after removing all the support screws (4) on ... Westinghouse 22" Widescreen LCD Flat Panel Monitor

The monitor comes on to desktop then goes blank, and flashes, if I tap or tilt the monitor it will come back , but then go blank again


Not sure if this will help.To Fix Loose inner ribbon cable. Remove the monitor stand. The stand has 3 screws holding a plastic cover over the stand and one holding the stand onto the monitor. Then remove 1 screw from each lower back corner and one ju ... Dell E151FP 15" Flat Panel LCD Monitor

The brightness/contrast adjustment screen pops up randomly and often. It then scrolls through the 3 options and the only way to remove it is to turn off the monitor. How do I make it stop?


Sounds like your buttons are stuck. Try loosening them up by pressing them, then popping them out again with some sort of pin or needle.If all your buttons seem fine and pop in and out normally, then its probably a problem with the connec ... Dell Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.5492 seconds