Having problems with your Toshiba Satellite P305D-S8834 Notebook ?

Hello there, when I turn on my laptop ( toshiba satellite P305D), it shows "configuring stage 3 of 3 - 0% complete do not turn off your computer". then it shuting down itself, and went back on showing the configuring page. it happen on and on non stop. any idea why and how to fix it? thank you.

Answers :

The computer has gotten hung up on the latest Windows update. There may be a recovery here, but the problem with these updates especially if your have the computer to update automatically is that some of these are service pack updates, and a service pack update actually overwrites files as it updates, so if it hangs or has a problem, it can actually corrupt the windows installation. Try this fix, you'll need the Windows Vista installation disc. If you have XP, the procedure is pretty much the same except that Vista does the work automatically......
\015\012Vista Boot-up Repair
\015\012Vista is very good about repairing itself. Boot from the cd and when prompted choose your windows installation, most likely it will be the only one. Once that is chosen, windows will ask what you wish to do….choose repair, if windows finds errors in the boot-up process, it will fix them from the files on the disc….if does not find anything relevant or cannot fix the errors, it will prompt you to try system restore and give you hints on the restore points to choose, I usually will go back farther than what is suggested. If these do not work, follow the repair listed below.
\015\012Step one, you need a Windows Vista CD. If you only have a recovery disk set like the ones from HP or Compaq they will not do what you need done. Under normal circumstances however, you can use a Dell disk because the Operating system is on a stand-alone disk. All retail versions are also acceptable as well as upgrade disks. For a rule of thumb, if the disk has the Microsoft hologram it should work. You can order a boot up floppy disk from here: http://support.microsoft.com/kb/310994 with this file, if you know how, you can use “ImageBurn” to burn the file into an ISO file which can be burned to a disk. Now make sure your computer boots to the cd rom first. If you know how to do this skip on down, if you don’t, while the computer is first starting up and you see the manufacturers splash screen, tap F12 (some computers it’s F9, others it may be another key, you may have to watch and see if the computer lists the key strokes for getting to the boot menu. If you still cannot find it, boot into the BIOS settings and change your boot order there. Save your settings and exit, the computer will now seek the cd rom as its boot source first.
\015\012Place your Windows disk in the computer and start it up. When you see the test at the top of the page “Press Any Key To Boot From CD” Just hit the space bar to activate. The next screen you will see will most likely be a Windows setup screen, when you see this press the “R” key to get to the recovery console. It will get there, it may take a little time, patience. Once it loads you will be given a choice of Windows installations, there should only be one, if there are more, always pick number one. It may ask for an administrators password, if you have not set this particular password, then just leave it blank and press enter. The next prompt you see is:
\015\012You need to type the following:
\015\012cd \\
\015\012hit enter. Pay close attention to the spacing between the characters. There is a space between the character “d” and the “\\”
\015\012You are now at the ROOT of the drive, this is where basic commands can be given and changed. You should now see the following:
\015\012Now type the following:
\015\012CHKDSK /R
\015\012Hit the enter key.
\015\012The chkdsk /r command also includes the P command and will also look for lost recoverable information in bad sectors.
\015\012There are occasions depending on how corrupt the system is, that this process could take several hours, so be patient with it.
\015\012Now, after chkdsk has run type the following:
\015\012Hit the enter key.
\015\012It may prompt you with a warning, that’s ok, just continue. When fixboot has finished, type: EXIT hit enter and windows will reboot. When the system reboots, tap the F8 key during this time and you will see the multi-boot menu come up. Scroll to the title “Last Know Good Configuration” and hit the enter key. If you were having some simple drive errors this should have fixed them.
Repair Help & Product Troubleshooting for Toshiba Satellite P305D-S8834 Notebook

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello there, when I turn on my laptop ( toshiba satellite P305D), it shows "configuring stage 3 of 3 - 0% complete do not turn off your computer". then it shuting down itself, and went back on showing the configuring page. it happen on and on non stop. any idea why and how to fix it? thank you.

The computer has gotten hung up on the latest Windows update. There may be a recovery here, but the problem with these updates especially if your have the computer to update automatically is that some of these are service pack updates, and a service ... Toshiba Satellite P305D-S8834 Notebook

Re: Errors being experienced with the ACER ASPIRE 5100-5758, OS VISTA. Error dealing with BUS:06, DEVICE:04, FUNCTION:00 AND ON TO FUNCTION:03

Hi, Nice report. We don't see these too often. You've had quite a few tech inclined people on your machine. My first hunch was memory timings and that could still be the problem. However, there is also memory on the display ad ... Acer Aspire 5100 Notebook

Can't set up network w linksys modem

Video card:Your computer has an integrated video card but has a "PCI Express" expansion slot for an upgrade. After the upgrade you will be able to play most games without the choppy frame rate...depending on what card you buy. Since ... PC Desktops

Ground Noise Problem Possibly Attributed to Samsung Monitor

Do you have another power adapter to try? Sometimes those go bad, and are pretty cheap to test out (around $35-$50). Otherwise it is the DC-in board on your PowerBook. I replace about 2 of those per month with our clients up here on the PowerBooks ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Re: your suggestion for my Dell Lattitude D600 Hard Drive Problem

Ok, now we have some good discourse! While I'd always prefer to use a friend's laptop to test my fringe hypotheses, having your own is a fine option too. And it sounds like you have an enclosure too, so you are pretty much all set. It's r ... PC Laptops

The monitor turns off and on repeatedly.

There are lots of reasons why it can shutdown, but happerlly none should be serious. It may be that the B+ or Power supply is too high, look for a pot near the power supply and try turning it down a bit. Also the x-ray protection may be too high, loo ... ViewSonic VE710b 17" Flat Panel LCD Monitor


Inside the advanced payne for your wireless setup in windows try setting it for "infrastructure networks only" as follows, you should see an icon to the right of your screen thats looks like a little computer with an x or small waves to the right of ... Acer Aspire 3000 Notebook

Computer won't load anything

You stated you removed the CPU. Did you clean the old theraml grease off & apply new before you reconnected your heat sink & fan? Did you reconnect the ATX 12V JPW1? power. This 12V power connector is used to provide power to the CPU? Lastly ... PC Desktops

No Audio Output Device is Installed

Try installing a sound driver for it again ... PC Laptops

Won't start at all

It can be anything from a faulty power jack, to a fried motherboard. Take it back to best buy as soon as you can, and let them take a look. Nothing more you can really do. ... HP Pavilion tx1000z Notebook

Cannot get new Motherboard to boot up in Normal Mode

What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

Cannot start Sony VAIO PCG-5J2L /Goes to black screen only

During start-up the computer will go to a black screen for awhile and then the pointer arrow will show alone, and then the system will come up.If you think it's a hibernation problem, pull the ac plug and battery out for about 1 hour and ... Sony VAIO PCG-K23 Notebook

Year old advent netbook 4211b will not turn on,

When you press power button press F1 or F2 or "del" key if you can see bios screen then you not need to refix RAM memory or reset bios.IF you can see bios screen then lake sure harddisk is detected and SATA is disable then save settings and exi ... Advent Netbook

Black screen flashes after initial power up

This happened to me, and I fixed it, so read on! Switch on... green LED for a couple of seconds, Brief flash of light with display working, the total shutdown. Switch off, repeat but press the front panel power button as soon as the green LED comes ... Sony SDM-HS73P 17" LCD Monitor

Ati Card problem

Personally, I would replace the video card as it sounds like it is not working properly. However, it could be that it is not seated correctly. Turn off the computer, unplug it, pull out the video card and then put it back in. Make sure it goes in fir ... PC Desktops

Acer aspire 6920 startup problem (Windows Error Recovery)

You could try booting up in safe mode by pressing F8 if you haven't already. OR, if you have the Windows operating system disc, you might try to boot off of that, or a system recovery disc. You may lose a few files, but hopefully that will get you u ... Acer Aspire 6920-6422 Notebook

Turn off without warnning.

I believe your first diagnoses was correct, and your second diagnoses is correct also. 1.Laptops have a poor cooling design. For one, all the hardware components are crammed into a small box. Very little room, for the needed airflow to ke ... HP Pavilion DV6500T Notebook

Netgear Rangemax Router not supported/can't find wireless networks after first time it logged on.

Lets do it again...1. Check physical connections. a. Connect the modem to the Internet port of the router. The Internet “i” LED on the front of the router should light up. b. Connect the computer to one of th ... HP Pavilion dv8000t Notebook

I have a hp a288n desktop. It quit responding as it has done previously and it wouldn't turn off, so I turned it off by the power button. When I went to turn it back on it would not start. I have unplugged everything and plugged it back in but still nothing. Any suggestions would be helpful.

I've attached the steps needed to be taken if your computer does not turn off.\015\012If you pc is turned off and you can't turn it on now, please provide me more informations like;\015\012\015\012what is ... PC Desktops

Wireless not functioning

Reinstall it clean or reinstall wireless drivers..after that just unplug the router and let it reconfigure ..this will get the wireless network in sight again ..sometimes it just stops transmitting or makes issues like that ..but if the wireless card ... Toshiba Satellite M45-S331 Notebook

Laptop won't comeback on

1. select safe mode command prompt\015\0122. type SCANREG and press enter key\015\0123. follow the screen instruction\015\0124. select the old one date when your computer was working well, from the restore list appeared. ... Toshiba Satellite 1405-S151 Notebook

My dc7100 has a compact power supply with proprietary 24 pin plug. Pretty sure power supply is non-functional (shorted green to black and fan didn't come on). Is it possible to rewire a conventional ATX supply with this smaller 24 pin plug? I need to know pin outs? Thanks

I just spotted this, hence the late solution. Perhaps this will help someone in the future.Yes it is possible.Observe the color code of the insulation of the wires. 1) Orange wires are 3.3 Volts2) Red w ... HP Compaq dc7100 PC Desktop

Power I shut down the laptop saw it logging off but when the screen turned black the power button and the HDD button is still active. I waited and waited for the lights to go off but it didn't. I closed the laptop and after a while opened it and still everything's on. what seems to be the problem and what do i do? Thank you.

1.\015\012\015\012 \015\012\015\012\015\012.\015\012\015\012\015\012Connect your wireless router\015\012Since you'll be temporarily disconnected from the Internet, print these instructions before you go any further.\015 ... Acer Aspire 5100 Notebook


Am having intel processor ,pentium4,3ghz is not showing on the screen. l change with lntel processor ,pentiun 4, 2 ghz it show on the screen but restart it self never show on the screen. ... Intel (RK80532PG0881M) Pentium 4, 3 GHz Processor

My computer spontaneously goes into power save mode

I just had this problem exactly and it ended up being the memory card slot....which in turn means the whole motherboard. I went thru tech support and luckily my computer was still under warranty. You can check if it is this by unplugging computer, ... IBM IntelliStation M Pro 6219 PC Desktop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0743 seconds