Having problems with your Smart Modular SV3170A ?

HP 24" monitor says no HDMI signal, no VGA signal "going to sleep". Just moved system. Did not disconnect any cables from monitor and VGA serial and HDMI cables are connected to tower in proper spots. Everything is labeled twice and hooked up as original pre move. HELP. System is less than a year and it was working fine prior to move. HP Pavilion system.


Answers :

Check the monitor cable at both ends for a bent pin (the small pins inside) if you find one be careful to try and straighten they will break.
Repair Help & Product Troubleshooting for Smart Modular SV3170A

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

HP 24" monitor says no HDMI signal, no VGA signal "going to sleep". Just moved system. Did not disconnect any cables from monitor and VGA serial and HDMI cables are connected to tower in proper spots. Everything is labeled twice and hooked up as original pre move. HELP. System is less than a year and it was working fine prior to move. HP Pavilion system.


Check the monitor cable at both ends for a bent pin (the small pins inside) if you find one be careful to try and straighten they will break. ... Smart Modular SV3170A

NO SIGNAL What do I do?


These messages are normal when the computer truly goes into suspend mode or loses the video signal (such as when the computer is suddenly turned off).If the monitor displays any of these messages when the computer should be displaying vid ... HP PAVILION A6230N DESKTOP PC

I have a tv screen which i use for my computer.I have the hdmi cords going from the video card on the back to my tv.why is it not working


\015\012Identify your TV's input connections. Most TVs these days have three basic types of inputs. You have your coaxial cable input, the same as your cable box or satellite, an RCA composite input (the yellow, red and wh ... Acer Aspire T160 (AST160UA3400) PC Desktop

My Gateway GT5685E powers up as does the monitor by I get no signal to the monitor (running Vista) - I have checked cables and the monitor seems to be fine, I have also tried to power up with the operating system CD but the same thing occurs. PLEASE TELL ME THIS ISN'T AS SERIOUS AS IT SEEMS dUANE


Well, there is good news and bad news...first, since it is a desktop and the video is integrated into the motherboard...if the integrated card fails, you can install a midlevel video card intot an empty PCI-E slot and have great graphics again for ar ... Gateway GT5685E Desktop Computer - Intel Core Duo E4600 Dual Core Processor, 4GB DDR2, 500GB HD, 18X...

I want to hook up external speakers to my Acer H213H for when my PS3 is hooked up to it.


The method I mentioned should work for any video input. So if you're only using HDMI then you should still be able to use the RCA cables to connect the red and white audio connections to a set of speakers. You won't be able to send the au ... Acer PC Desktops

Monitor comes up shows "acer" then says no signal and goes black


The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor

Polyview v17e can not get a signal input not sure I have the right cords


Ok i had this issue.. on the monitor u have vga and hdmi ports if ur on vga then it should work unless the cord is plugged in the hdmi..check this in the bios by pressing DEL or F1 at system start up and check the BIOS for Display and ma ... Computer Monitors

I have a Dell computer that runs Windows Vista and I want to hook it up to use my TV as a monitor to watch a webcast. Please advise.


The first step is to inspect both your laptop and\015\012TV and identify the connections, easily located on the back of either\015\012component. There are five basic types of jacks, or ports involved:*Composite/phono plug (RCA)*S-Video ... Computer Monitors

I am trying to hook my Eee 1000HE netbook up to my hdtv. I have 15 pin RGB cable but it doesn't work. Followed TV (Visio) directions, but it doesn't work.


More information would be helpful - what operating system are you \015\012running - XP or Linux? are you getting no signal at all? or just a \015\012picture and no sound? or vice versa?. What settings did you try?\015\012\015\012In the ... ASUS Eee PC 1000HE Netbook

My monitor just went to a black screen and the green light on the front just blinks. I took it to Best Buy and they connected it to their power supply, but with the original cables, and it worked fine. Brought it home, hooked it up again, and it won't work again. I have an old monitor that I am using and I evem changed the plugs from the old monitor to the new one and it still won't work.


Blinking light is a sign of no signal, try to remove the VGA cord (blue) from the system unit while the green light is blinking,there must have a display, cable disconnected or no signal. if it does, the monitor is okay and your VGA driver/graphics c ... HP Compaq FP5315 15" LCD Monitor

I have a dell GX280 and I tried to connect it to a Olevia LCD TV but I have a problem to do so. I connect it via VGA cable. When I started the PC I could see TV display Windows logon and show PC is starting up. But then it turned to a blue screen with message 'A problem has been detected and windows has been shut down to prevent damage to your computer.'. and it continued to say that I needed to run a system diagnostic utility to check memory check etc. the technical information was 'Stop: 0x000


Lower you screen resoloution to 800x600 to start with. Also you must setup mutimonitor, correctly.\015\012\015\012\015\012Right, well, IF your TV has a DB15 Female Plug on it then you CAN, connect it ... Dell OptiPlex GX280 PC Desktop

No color red displays.


If you think that electronic repair is very difficult to learn then you have to read this article where only by using a solder gun could solve a Monitor color problem. Of course there were many tough dog cases (very difficult to find out the fault) i ... ViewSonic G70fmb (Black) 17" CRT Monitor

My son has an LG monitor - that is hooked up to his xbox ..... & all of a sudden - since yesterday - it keeps going/staying in this 'power save' mode. what do I do?... I've tried to unplug/replug, etc .... ,tiina.


I've done quite a bit of research on this and the problem is with the LG monitor. For some reason the DVI and HDMI ports have a history of going bad and when this happens, the monitor goes into "power save" mode because it thinks that there is no si ... Computer Monitors

No Display from new Acer Desktop AX1700


Check all power cable. check vga cable, ... PC Desktops

Use hdmi out on 2408 display


No, won't work as teh monitor does not have sound capabilities. However, this will work if you have some sound input into the monitor, like if you use the HDMI (which includes sound) to send signals to the monitor, instead of the VGA / DVI connector. ... Dell UltraSharp 2405FPW 24" Flat Panel LCD Monitor

New ACER 1751 monitor added


Try going into Start - Control panal - add new hardware. First let windows look for itself ;then If it doesn't find the monitor then tell it monitor and see if it will find the correct driver for it. Worth a try. ... Gateway FPD2275W LCD Monitor

NEC FE2111sb multisync 21 inch monitor troubleshooting


The symptoms you describe sound like the monitor is going into 'greeen mode' - that is to say, it sees no video signal present. first, try another monitor ti isolate and make sure the problem is the monitor. check the vga plug pins [especially if you ... NEC MultiSync FE2111SB 22" CRT Monitor

How can i make the laptop screen show through my tv


Hello.Simply hooking up is not enough. What type of cable are you using? HDMI? analog VGA? DVI? S-Video? * You should also use [Fn] button in combination with [F5], [F8] or another button that shows monitor sign as well (CRT/LCD if it's ... Dell PC Laptops

Hp vs17 has white screen at boot. I have eliminated the chord from the tower and the tower works fine. I have audio, no video. Only a white blank screen. It does not blink or flicker. It just stays white. It happened all of a sudden. I worked yesterday morning, turned off the system for work and on booting after work, well y'all know the rest.


There are three choices here...bad screen, bad connection, or bad video card, if the card is integrated onto the motherboard, then that part of the motherboard could be bad. If you have access to another monitor or a TV with a vga input, try the comp ... HP Vs17 17" LCD Flat Panel Monitor

Monitor not showing picture


This is not your Monitor Problem It is your System Unit Problem.Some time Problem with VGA Card You Check your VGA Card . Hope problem will be solve. ... E-Machines eMachines Monitor E15T4

"No signal detected" when LCD connected with DVI-D Cable


Thank you for providing your configuration details.\015\012You have failed to specify wheather or not your LCD Display is under Warrenty.\015\012\015\012Perhaps these simple trouble shooting procedures will get the job done.\0 ... BenQ FP71E 17" LCD Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

I've been trying to use s-video cable to connect


\012\012At the rear or side of the PC there should be either or both of a 15 Pin DIN Plug, HDMI socket. or a Yellow RCA or 4 -7 pin DIN. Now IF these are present then YES you can connect to a TV. Now some TV' ... Acer Aspire 3690-2196 Notebook

HDTV as a monitor -- is audio possible?


I also have a PG connected to my LCD TV. The problem is that you only can send the video signal to the TV if you are using a VGA or DVI cable. Unless your computer has a dedicated HDMI port, you will have to send your audio in a different way. ... IBM ThinkCentre S50 PC Desktop

Replaced motherboard but nothing comes up on the monitor & it won't turn off unless I unplug it


Slickbear,\015\012\015\012This new Motherboad has an On board video card that is likely set to be the default one to use. Try switching your monitor cable to the onboard SVGA plug. then boot up your PC.\015\012\015\012If you n ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.2333 seconds