Having problems with your Samsung SyncMaster 930B 19" LCD Flat Panel Monitor ?

My computer is on and working, but the monitor is blank and black. THe little green light showing the connection is blinking. When I turn it off and on again, the blue square the says analog-digital appears for a little while, then goes off. Did the monitor die? is there a button that needs to be pressed?


Answers :

Hello,

The power supply in the monitor is blown. We have a step by step repair guide posted on our web site at: www.ccl-la.com/badcaps.htm The guide shows you how to open the monitor and replace the defective capacitors and get back going.

Check it out. I hope this helps, If so please rate my solution.

Buddy
Corporate Computer
www.ccl-la.com

May be the interface is loose, you can pull out all the line and insert strict. If it doesn't works, another possibility is the computer memory bank loose, take it down and fit it on again.
Repair Help & Product Troubleshooting for Samsung SyncMaster 930B 19" LCD Flat Panel Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My computer is on and working, but the monitor is blank and black. THe little green light showing the connection is blinking. When I turn it off and on again, the blue square the says analog-digital appears for a little while, then goes off. Did the monitor die? is there a button that needs to be pressed?


Hello,The power supply in the monitor is blown. We have a step by step repair guide posted on our web site at: www.ccl-la.com/badcaps.htm The guide shows you ... Samsung SyncMaster 930B 19" LCD Flat Panel Monitor

Samsung syncmaster 931a... connected to computer


Hi,\015\012its unlikely to be the cable. Most likely cause of this is a faulty inverter board. If you are lucky it will only be 1 or 2 blown capacitors which are easily identifiable and replaceable once you have got inside it. it could however, be al ... Computer Monitors

L222WT flatron 21.6 monitor is not working


Power saving is the default the monitor goes into if it doesn't get the correct signal down the cable wires of the computer. There might be three culprits:  (1) the cable between computer and display (most likely), (2) the display itself (unlike ... Computer Monitors

Screen light goes out but image is still viewable...


Hello..Now let's discuss what we\015\012should do when the laptop seems to be booting up without problems, the\015\012hard drive spins appropriately, and we even hear the welcome sound of\015\012the operating system, but we have no ... Sony VAIO Notebook

Can't get monitor to connect


There are a few things to look at. It is very obvious that the screen is in good condition since you can see the message on it. Now the problem lies with either the RAM and/or the VGA. If you are using an onboard VGA, try a PCI VGA card. Try to r ... Samsung SyncMaster 2233BW 22" LCD Monitor

Monitor Problem We Have the Princeton VL 173 Monitor and when we hooked it up to the computer the Monitor Turns on and trys to Load Windows XP and then The Message Appears that It is OUT OF Range and these Numbers Appears H 53.8 KHZ and V 85.2HZ and then Monitor goes into Sleep Mode.


That is because your computer is trying to display a picture at a higher resolution than the monitor can handle\015\012\015\012EG. if your monitor was only capable of lets say 800 x 600 and you deci ... Princeton Digital VL1916 19" LCD Monitor

My Samsung SyncMaster 2463UW no longer auto detects the video input. I normally use it with my MacBook Pro - I turn it on, it detects the digital output and Bob's your uncle. Today, I turned it on and it continues to cycle through analog, digital and HDMI input sources. However, I can actually see the correct output when it switches to ''digital'' mode - it just won't stay there.


OK UncleBob...Try this for me..does hitting the menu button on the monitor do anything for you?..NO huh...Do any of the other buttons (besides power) do anything for you?..Probably not?! Your in the early stages of my fixed problem...Is your warranty ... Samsung SyncMaster 753S 17" CRT Monitor

Screen goes blank


Hello..Now let's discuss what we\015\012should do when the laptop seems to be booting up without problems, the\015\012hard drive spins appropriately, and we even hear the welcome sound of\015\012the operating system, but we have no ... Toshiba Satellite A45-S1202 Notebook

Monitor not using all available space


Do NOT use the VGA cable. Only use the digital DVI cable for video. Using the DVI cable connect one end to the DVI connector on the monitor and the other end to the DVI connector on the video card. You should NEVER connect cables to ... Samsung SyncMaster 2253BW LCD Monitor

Screen resolution problems


When I rang Samsung about the problem, they took my details and sent a new monitor within a week even tho my monitor was 18 months old ... Samsung SyncMaster 713BM 17" LCD Monitor

Samsung syncmaster 730b blinking. switches from


Oct 23, 2009\015\012- This is how it went for me..I have a Samsung SYNCMASTER ... Computer Monitors

Blacks out within seconds of being on the screen


Your monitor has problems with instability in the circuits,This causes error voltages to appear in the feedback circuits and the unit goes into protection mode to protect itself from more damage If you are still under warranty take the unit to a serv ... Acer Monitor Lcd 19in Al1923 0.29mm 1280x1024 Tco03 - ACER - ET.L660B.045 19 inch LCD Monitor

My 2gb ram stick died, so I tried upgrade to 4gb


Most appreciated naturalgal66. Perhaps you would like more information, to put together some of the information I stated in the Clarifications.This is a motherboard block diagram,http://en.wikipedia.org/wiki/File:Motherb ... HP Pavilion a6600f Desktop PC

Cannot get new Motherboard to boot up in Normal Mode


What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

I have just installed a crucial x1600 pro graphics card,when i fired up the computor the monitor displayed multi coloured vertical lines and a box appeared saying it was in analog mode, how do i configure the targa visionary monitor to digital mode. regds A Gough


I'm assuming "it" is the monitor rather than the video card, and that you are using some flavor of windows as your operating system. 1. Digital vs Analog mode is determined by the cable input plug on the monitor that use. Your cable fr ... PC Desktops

ViewSonic VX922 monitor - black screen - green power light flashes


PLEASE read Carefully so here is a fix for the green blinking light ...the monitor is going into shutdown....protect mode......THIS is ...Only for the seasoned electronic service tech ......YOU NEED TO BE into Electronics ..or have electronic backgro ... ViewSonic VX922 19" Monitor Flat Panel

Screen goes blank when I move the mouse


Did it work properly using a VGA (analog) cable? If so, check your DVI (digital) cable against the pictures at the bottom of http://www.datapro.net/techinfo/dvi_i ... Samsung SyncMaster 204B 20.1" LCD Monitor

LG 2542T goes dark after showing "analog power saving mode" message


If it is saying analog signal power saving... I am wondering do you have it hooked into you computer with the white DVI cable?Is there an option on your monitor to switch modes? Analog-Digital? If you are using the white DVI cable to hoo ... LG L1717S-BN 17" LCD Monitor

Switching from digital to analog


You have bad capacitors. You need to replace them and they should start working fine again. ... ViewSonic VX924 19" LCD Monitor

Hello i just installed my chimei 19" lcd to my hard drive and i have connected it all up right it all loads up but when my screen comes on the little button on screen goes from green to red and says no signal input screen stays black why would it be doing this if everythink has been connected


Most probably your monitor has two inputs, one digital and one analog. Using the monitor's on screen menu select the other input and you should see your picture. ... Acer AL1916W 19" LCD Monitor

Moniter keeps blinking analog and digital at the


This happens when your monitor cannot detect a VGA or Digital port, either on the monitor it self or at the video card. If you don't hook it up to anything at all and turn it on it will do this. \015\012\015\012Step #1 \015\012 ... Samsung Computer Monitors

New LG 2452T keeps going to digital power saving mode


I had the same problem.\015\012connect the monitor with the analog cable and shut down your pc.\015\012while it is off unplag the analog cable and place the digital one(dvi).\015\012this should fix your problem m8 ;) ... LG Flatron L2320A 23" LCD Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

Monitor goes black when i turn it on


Just a big hardware problem in your monitor ... Samsung SyncMaster 216BW Monitor

LG screen goes in stand by. I was using two monitors for several months, everything OK, now I decided to get a new LG Flatron instead of one of the monitors... and only this one goes in safe mode!! Two screens plugged in: Philips analogical working fine no problems. New LG Flatron digital goes in power save mode after few minutes Tried to plug in ONLY the LG, same problem after few minutes. Philips monitor no problems. So it HAS to be a screen function or problem of the LG? Computer: AMD + 3Ghz


Oke having a similar problem atm, this is what i have found so far. was trying to help a friend who has bought the same 19" LG monitor. When i connected the monitor to her PC i noticed that it was not the same connection as the previous one but it ha ... LG 19" Widescreen Flat Panel LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6417 seconds