Having problems with your Mag Innovision LT765b 17" Flat Panel LCD Monitor ?

Picture goes black on Mag Innovision LT765b

\015 I have a dual monitor setup, and the MAG just started going black. It comes up just fine, but after a few minutes, the picture just ends. My PC still thinks the monitor is connected, and the display on the other screen is unaffected...even the power on light doesn't change. I've checked all of the connections, and even tried re-connecting the video cable, but the only thing that brings the picture back is a power cycle (after which the image is fine again for a few minutes). I'm afraid it's just done, but wanted to see if there were any other suggestions first.Thanks in advance for the help.\015

Answers :

I used to repair LCD monitor from Dell. It works for me. You might be using\015\012these following steps to examine what wrong with your monitor. After you turned PC on and\015\012monitor stopped working or went black, you have to check that if you can see the image on the\015\012screen or not by shining a flashlight into the screen, not directly but find\015\012the best angle to the screen and take a look very closely. If you can see the\015\012icons or any image (Start menu), there will be a minor problem. This is because of CCFL lamps\015\012inside screen. Some of them were broken and it is very easy to replace. If you\015\012cannot see anything on the screen, there'll be some problems with inverter board. If you\015\012have soldering tool and want to fix it by yourself, check the caps first. It\015\012may cause this problem. Some caps might show leaking or burn spot on the board\015\012because of too high temp. If you don't have soldering tool, you better go get a\015\012technician to do so.\015\012Hope this help!! If anything I can help you with, feel free to let me know.
\015\012\015\012Thank you.
Repair Help & Product Troubleshooting for Mag Innovision LT765b 17" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Picture goes black on Mag Innovision LT765b


I used to repair LCD monitor from Dell. It works for me. You might be using\015\012these following steps to examine what wrong with your monitor. After you turned PC on and\015\012monitor stopped working or went black, you have to check that if ... Mag Innovision LT765b 17" Flat Panel LCD Monitor

MAG Innovision LT2219WDB monitor will turn on -picture up clear as ever and 2 seconds screen goes black, turn it on and off screen comes up clear as always and 2 seconds goes black. will not keep the picture up. what is wrong. hooked my old monitor up it stays up clear as ever. MAG monitor is only 18 months old, 6 months out of warranty. has anyone had this happen or know what i need to do.


I have the same problem with a customer's monitor (LT716S); it turned out to be damaged power supply board. As I understand it, MAG has a 3 year warranty on parts, will probably charge you a flat labor fee plus shipping. If you do not have your pur ... Computer Monitors

MAG Innovision LT1919WDb flat screen goes black


When a monitor works for a few seconds or more and goes black it is a problem with the power inverter board over heating because of a bad capacitor or capacitors that are not the right size. There is no problem with the VGA controller since it shows ... Computer Monitors

Mag Innovision LT982s screen problem


Hi,Based on your post/description, I will initially suspect the inverter and/or the CCF Lamps since as you\015\012posted "dim screen picture" indicating that there is ** backlight(s)\015\012and/or it is **t receiving power from the inver ... Mag Innovision LT982s 19" Flat Panel LCD Monitor

Monitor goes black but green light still on.


The problem with the Mag lt916s is that it is made with cheap capacitors. If you are interesnted it is a cheap and easy fix. Open it up, which is the hardest part. And replace the six 470uf 105 degree 25v capacitors and maybe even the smaller 220u ... Computer Monitors

MAG Innovision LT916S monitor problem


Hi this is the way how to examine\015\012what's wrong with your monitors. After you turned it on and the screen went black, you have to check that if you can see the image on the screen or\015\012not by shining a flashlight into the screen, not ... Mag Innovision 19" LCD Flat-Panel Monitor LT916S

I have a mag lt 2219 and everytine I turn it on it goes black


Hello Chris,You have a monitor with a common problem. After a few years some LCD monitors will blown a power supply. The problem is ca ... Mag Innovision 19" LCD Flat-Panel Monitor LT916S

Monitor black screen


I experienced a similar problem with my MAG LT776s. As a "band-aid" fix, I have found that if I turn the monitor brightness to near zero my problem is minimized. Meaning - the monitor goes on after a little wait (~ 20 sec) and will stay on. ... Mag Innovision LT776s 17" LCD Monitor

Mag Innovision LT1919WDb LCD goes black after 30 seconds.


... Hanns.G Corporation HW-192D LCD Monitor

MAG 700P monitor display goes black after 60 seconds


Hello,Can you send pictures of the power board to me at [email protected] I will check our service manuals for the model and get back with you about a solution.BuddyCorporate Computer ... Mag Innovision LT782S 17" Flat Panel LCD Monitor

Mag Innovision LT776s Model 780


Sounds like an inverter problem. If the power supply is internal replace the capacitors coming out of the voltage regulators. These are usually 1000mf and/or 470mf. If that doesn't do the trick look up the numbers on the 8-pin chips that drive the se ... Mag Innovision LT776s 17" LCD Monitor

Monitor problem i have a mag innovision monitor, it comes on for 1 sec. and goes off and in about 3 to 4 minutes come back on for 1 sec. and goes back out. my monitor goes out every couple of seconds. if i turn it off then back on i can see my display, but then after a couple of seconds it goes black. this happened suddenly, just started today.


You need to figure out if the monitor is faulty or if it is due to the power in your house (not likely) or the fault of the computer.\015\012\015\012Try the monitor on other power jacks.\015\012Try the ... Gateway FPD2275W LCD Monitor

Monitor turns on for a couple of seconds then goes black


This problem is due to trouble in the inverter circuit which powers the lights inside the monitor. (LCD monitors require a light source so you can see the display. Your display is still there but you can't see it.) It is repairable. Usually the cause ... Computer Monitors

17 in Widescreen Mag Innovision


Dear tfollisHave you checked the HZ that you are using the monitor in windows ? If set at a very high level (for example 100hz) it may damage the monitor as it is not supporting it. (and maybe this explains the reason for the shutoff as a ... Mag Innovision LT776s 17" LCD Monitor

Black screen i have a mag innovision 900w when i turn the power on it comes on for about two seconds then the screen goes black but the power lite stay's on


It is most likely that the filter capacitors on the power inverter board have failed. I took mine apart and found seven swollen capacitors on the this board, they fail prematurely and seem to be the only thing wrong with the unit. I replaced them and ... Mag Innovision 19" LCD Flat-Panel Monitor LT916S

Monitor goes blank less than a second after turning on.


This is an easy problem to diagnose but not so easy to fix. the power inverter for the backlight is dead. this is a very common problem with lcd monitors, if it is a module they are usually range in price from $20-75. ... Mag Innovision LT982s 19" Flat Panel LCD Monitor

Mag Innovision LT576S monitor goes blank after 2 seconds


The MAG LT576S is an LCD monitor ... Mag Innovision LT576s 15" Flat Panel LCD Monitor

LT582s Mag Innovision


Hi,It all depends if the Mag has been used before on the same system or it is a new installation or on a different computer.\015\012\015\012If it is connected to an existing set-up and has been used ... Mag Innovision LT576s 15" Flat Panel LCD Monitor

Screen goes blank after being on several seconds


Is the green light on (still indicationg power?\015\012Ist put your ear to it and switch on - hear any buzzing?\015\012Most like the HV Fluro Inverter for the lamps has an issue. For some the 2SC5707 may have gone - common. ... Mag Innovision LT776s 17" LCD Monitor

Mag 19" LT916s


This is a common problem due to capacitors in the inverter circuit\015\012going bad. The inverter provides the voltage to light the backlight, so\015\012the lamp is usually not the problem.If you open the case on the\015\012monitor (somet ... Mag Innovision 19" LCD Flat-Panel Monitor LT916S

The l226wtq goes black


Try shining a flashlight on the screen, or without the flashlight, try to see if you can distinguish anything on the screen at all, if you do, the backlight is dead, or the monitor has an internal most likely unfixable problem. ... PC Desktops

Toshiba satellite a135 monitor goes black


You could have a defective screen - a defective inverter or a CCFL lamp.To determine if you have a LCD screen or video card problem, read this and follow the instructions.Defective CCFL backlight, it may have the following symptom: ... Toshiba Satellite A135-S2386 Notebook

Screen goes black when plugged in


The high pitch sound is most likely a faulty inverter.\015\012\015\012Most defective screen are caused by a defective inverter or a CCFL lamp or simply the video cable needs reseating. After reseating the video cable and the problem is still there th ... Dell Inspiron E1505 Notebook

With dvi monitor goes black for 2 second then comes back intermittently


To what I understand. Dvi and vga is only applicable to a system or CPU. Sorry if I am wrong.\015\012\015\012Tia. ... ViewSonic VX2025wm 20.1" LCD Monitor

Screen goes black after a few minutes, switching off and on and picture returns then goes black again


Faulty PSU ... Relisys RLT1720 17" LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3825 seconds