Having problems with your Mag Innovision InnoVision LT 765S 17" Flat Panel LCD Monitor ?

I just moved and my monitor is saying it has no signal. Everything is hooked up the way it was. Whats wrong?


Answers :

Go inside and move the card to another slot. If that doesn't work, take the monitor to a friends house and confirm the monitor is still good.
Repair Help & Product Troubleshooting for Mag Innovision InnoVision LT 765S 17" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I just moved and my monitor is saying it has no signal. Everything is hooked up the way it was. Whats wrong?


Go inside and move the card to another slot. If that doesn't work, take the monitor to a friends house and confirm the monitor is still good. ... Mag Innovision InnoVision LT 765S 17" Flat Panel LCD Monitor

Will not load.


My old computer had a problem like this, i think the only way to fix a problem like this would be to reformat your hard drive and reinstall your operating system, which would delete everything on your hard drive...if you do not want to lose the files ... Acer Aspire E380-UD420A (ASE380-UD420A) PC Desktop

I cannot restart my PC AllI get is a note saying NO SIGNAL ANALOG


I had a problem like that ,my tower got bumped and fell over. the heatsink and processor fell off. i had to remove processor (p4) from heatsink and make sure all the pins were straight and aligned properly. i cleaned both parts with alcohol. i then ... Gateway GT5058 Desktop PC

This the cisnet


Well, I CAN say, that usually an orange monitor light means: \015\012\015\012"No Signal" \015\012\015\012Either because, the computer isn't on, or the monitor just is ... ZT Group Cisnet A7020 PC Desktop

Hi,could some one walk me through setting up my Billion modem wirelessly to my Dell Desk top running XP home. I get confused with firewalls,LAN settings etc Ethernet cable is being used at the moment. Do you need drivers etc


I am not familliar with that brand, so I do not know if it is a cable/dsl modem, a router, or a combination of the 2. I will assume it is the cable or dsl modem since you said modem.The thing we need to do first is give you a basic unders ... Dell PC Desktops

Computer will not load.


Use safe mode..do a disc clean, defrag..and then reboot...sounds like the operating system headers went unhappy when you moved it(which I highly recommend you NOT do again).. ... Acer Aspire E380-UD420A (ASE380-UD420A) PC Desktop

Emachine beeps Hey, we just got a new emachine and we have the same problem! We got it mid/end of April but were in the process of moving so it stayed in the box till about a week ago. I hooked it up and when you press the on button it beeps 5 times then you hear the fan kick on like its thinking about starting up but then it just stops and beeps until you turn it off. The monitor says no signal and then goes blank. Any advise?


That would be a problem for e-machine. The beeps are codes. I will try to help, but it is hard to diagnose without looking at it.You can try several things. Open it up and make sure that everything is seated inside. Make sure the memo ... PC Desktops

Monitor reads: PC entering power saving mode then shuts off;PC on


First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

My Gateway GT5685E powers up as does the monitor by I get no signal to the monitor (running Vista) - I have checked cables and the monitor seems to be fine, I have also tried to power up with the operating system CD but the same thing occurs. PLEASE TELL ME THIS ISN'T AS SERIOUS AS IT SEEMS dUANE


Well, there is good news and bad news...first, since it is a desktop and the video is integrated into the motherboard...if the integrated card fails, you can install a midlevel video card intot an empty PCI-E slot and have great graphics again for ar ... Gateway GT5685E Desktop Computer - Intel Core Duo E4600 Dual Core Processor, 4GB DDR2, 500GB HD, 18X...

Monitor comes up shows "acer" then says no signal and goes black


The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor

Installing more memory


Hi if you go to this site first www.crucial.com then look on the site and it will then scan your computer for you telling you exactly what memory you need like p100 or p133 as getting the wrong one will cause your computer to stop working ok. ... Compaq Presario 5000 PC Desktop

HP 24" monitor says no HDMI signal, no VGA signal "going to sleep". Just moved system. Did not disconnect any cables from monitor and VGA serial and HDMI cables are connected to tower in proper spots. Everything is labeled twice and hooked up as original pre move. HELP. System is less than a year and it was working fine prior to move. HP Pavilion system.


Check the monitor cable at both ends for a bent pin (the small pins inside) if you find one be careful to try and straighten they will break. ... Smart Modular SV3170A

PC is not working. Monitor message says 'monitor


Check to make sure that you have it plug all the way in to the video card. Also make sure that the video card itself is seated or pushed in good.You could possibly need a new video card or the pins on the plug coming from the monitor cou ... PC Desktops

Monitor says no input signal


Do the icons look ok when you can see them? It sounds like your resolution may be way too high for the monitor. It loses sync and blanks the screen rather than show a lot of mess.\015\012\015\012Boot your windows in safe mode (tap F8 befo ... PC Desktops

Dc jack How do I replace the dc jack input on the Sony PCGK37


The PCG-K37 (Sony VAIO Laptop) uses a DC Jack soldered to a two-wire jacketed (shielding) cable that is routed under the DVD (tray) and towards the back to the Voltage Board located under the Touch Pad (Mouse) via a white polarized plug. The wires ar ... Sony PCGK37 Notebook

Monitor not showing picture


This is not your Monitor Problem It is your System Unit Problem.Some time Problem with VGA Card You Check your VGA Card . Hope problem will be solve. ... E-Machines eMachines Monitor E15T4

NO SIGNAL INPUT - message


Hi Rick,Most common cause of this error is when the video signal cables are knocked off rendering the connection from the monitor to the CPU loose. Turn off the PC and secure all connections. Have you had your computer moved or repaired where y ... Gateway FPD2275W LCD Monitor

Can't set up network w linksys modem


Video card:Your computer has an integrated video card but has a "PCI Express" expansion slot for an upgrade. After the upgrade you will be able to play most games without the choppy frame rate...depending on what card you buy. Since ... PC Desktops

DELL INSPIRON 1501 won't BOOT...and LEDs flashing


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... Dell InspironTM 1501 Notebook

Monitor no signal


My router won't work on my laptop since I had work done on it . But my neighbor can use it for his computer. I need some instructions on how to rehook it up. ... Dell E151FPp 15" TFT LCD Flat Panel Monitor

Moniter Black - Buttons not responding


This sounds like a straight hardware issue. However, to be certain, try to attach another monitor to this PC, and if it works properly, you will know that there is nothing wrong with the graphics card/driver or other related component of the PC invol ... X2Gen MG19MY 19" LCD Monitor

No color red displays.


If you think that electronic repair is very difficult to learn then you have to read this article where only by using a solder gun could solve a Monitor color problem. Of course there were many tough dog cases (very difficult to find out the fault) i ... ViewSonic G70fmb (Black) 17" CRT Monitor

LG screen goes in stand by. I was using two monitors for several months, everything OK, now I decided to get a new LG Flatron instead of one of the monitors... and only this one goes in safe mode!! Two screens plugged in: Philips analogical working fine no problems. New LG Flatron digital goes in power save mode after few minutes Tried to plug in ONLY the LG, same problem after few minutes. Philips monitor no problems. So it HAS to be a screen function or problem of the LG? Computer: AMD + 3Ghz


Oke having a similar problem atm, this is what i have found so far. was trying to help a friend who has bought the same 19" LG monitor. When i connected the monitor to her PC i noticed that it was not the same connection as the previous one but it ha ... LG 19" Widescreen Flat Panel LCD Monitor

My Samsung 913t says "Check Signal Cable." HELP PLEASE!!!


Cheap CRT monitors can be picked up at Thrift Stores, quick and cheap way to test your computer output. ... Samsung SyncMaster 191T 19" Flat Panel LCD Monitor

Just got a hand me down Benq model t903 19


Quite the opposite -- your new monitor can't handle the screen settings that you're running on the old monitor.Hook up the old monitor and start up the computer so you're looking at a Windows desktop. If you have windows open, close them ... BenQ Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1929 seconds