Having problems with your Mag Innovision 19" LCD Flat-Panel Monitor LT916S ?

Black screen i have a mag innovision 900w when i turn the power on it comes on for about two seconds then the screen goes black but the power lite stay's on

Answers :

It is most likely that the filter capacitors on the power inverter board have failed. I took mine apart and found seven swollen capacitors on the this board, they fail prematurely and seem to be the only thing wrong with the unit. I replaced them and now it is working just fine.

six 470uf 25v electrolytic capacitors and one 220uf 25v Capacitor.

you should not attempt to repair this yourself unless you have some electronics training since there is a shock hazzard involved and also these capacitors will blow apart if they are installed incorrectly (very messy experience).
Repair Help & Product Troubleshooting for Mag Innovision 19" LCD Flat-Panel Monitor LT916S

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Computer dies on me (can't say it better due to no technical knowledge; pls read :-)

The 'click' sound you hear when your computer goes off is the hard drive head parking itself.  It does this whenever the machine shuts down to prevent damage.As for the problem itself, I believe your computer is overheating.  Th ... Acer TravelMate 290LCi Notebook

Monitor comes on, I can see everything perfect then goes black

"Most" newer monitors will let you know if the are no longer receiving a signal. Sounds like the backlight is burnt out. Try getting a bright (LED works best) flashlight and shining it at the screen at all angles to see if you can see any of what you ... Westinghouse L2046NV Monitor

Screen won't stay on

This is a common problem with LCD monitors after a few years of use. The capacitors in the power supply board start to fail and this prevents the monitor from starting up correctly. Sometimes you get a picture and then it goes black. On some units y ... ViewSonic VA902b 19" Monitor

Monitor stays on for a few seconds then goes out

This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

I have an HPW19 wide screen monitor that goes to black.

I have the same monitor and it is only 3 month's old, the power lock button continues to fail and they have replaced it 3 times with the same issue, What a piece of ****!!!! ... HP w19 19" LCD Monitor

Gateway Monitor FPD1760

Sounds like classic symptoms of capacitor failure.\012 Old thread, but in case anyone else is still looking for an answer, the problem is probably bad capacitors on the power board. There was a world-wide problem with capacitors in the early 2000 ... Gateway FPD2275W LCD Monitor

Black screen i have a mag innovision 900w when i turn the power on it comes on for about two seconds then the screen goes black but the power lite stay's on

It is most likely that the filter capacitors on the power inverter board have failed. I took mine apart and found seven swollen capacitors on the this board, they fail prematurely and seem to be the only thing wrong with the unit. I replaced them and ... Mag Innovision 19" LCD Flat-Panel Monitor LT916S

Monitor goes black 1 second after coming to full screen

Same problem here. Does anybody have an answer? ... Gateway FPD 1510 15.1" Flat Panel LCD Monitor

Samsung 931B Monitor Screen will not stay

Jane657, Hi there. Will you stop pushing the On/Off button on your lcd/fpd. It's Broke. Period. End. Finito!!! You will not fix it. However there is one test that you should do to determine hoe bad the problem is. You will need to reconnect the 931B ... Samsung SyncMaster 931BF LCD Monitor

Sdm x73 screen goes black

Here is one thing you can do to help get to the root of your problem.Take a flashlight and shine it on the screen once it has gone to black. If you are able to see the screen information (your desktop) then you have a back light problem. ... Sony DELUXEPRO SDM-X73/B (Black) 17" LCD Monitor

Gateway monitor FPD1975W won't display

Same problem - unplug both computer and monitor - hold power button for monitor for 15-30 seconds...then power it back on and then power on the computer. Seems from other sites there is a power issue with the monitor - this worked for me. ... Gateway FPD1975W 19" LCD Monitor

Acer AL1917W goes black

I have recently opened my AL1917 (not wide) but it should work the same. First remove the stand. This is done by removing the plastic cover over the stand hinge (which appears to be part of the back cover, but is'nt.) Mine was done with simple tum ... Acer AL1917W LCD Monitor

Black screen flashes after initial power up

This happened to me, and I fixed it, so read on! Switch on... green LED for a couple of seconds, Brief flash of light with display working, the total shutdown. Switch off, repeat but press the front panel power button as soon as the green LED comes ... Sony SDM-HS73P 17" LCD Monitor

My monitor screen goes black

The monitor is going bad. Either going to be a bad screen or a bad inverter. Also Since you tried it on another computer and its still giving you the same symptoms, you know the computers are fine. To be sure, try another monitor on your computer a ... Dell UltraSharp 2000FP 20.1" Flat Panel LCD Monitor

Screen stays blank

I'm seeing the same problem as the original poster. that delaying the power-on helps, seems to be related to the video mode - it fails in the vga text mode the bios boots up with, but works fine with the later activated graphics mode. switching to te ... iiyama Vision Master Pro 450 Monitor

Monitor black screen

I experienced a similar problem with my MAG LT776s. As a "band-aid" fix, I have found that if I turn the monitor brightness to near zero my problem is minimized. Meaning - the monitor goes on after a little wait (~ 20 sec) and will stay on. ... Mag Innovision LT776s 17" LCD Monitor

X2gen mw19u 19'' widescreen monitor going black

X2GEN - MW19U, same problem as described in the other posts. A week ago after a reboot it did not turn on. Pressed the power button, it turned off. Pressed it again after about a minute, all was fine until this morning. Same as before except t ... X2Gen MG19MY 19" LCD Monitor

W1907 Monitor Goes Blank

If you still have this monitor type, you are obviously no longer under warranty and need some help, not "smart alek" or "return" it advise.The issue is with the power board that feeds the inverters which in turn power the CCFL bulbs. This mon ... HP Compaq WF1907 Monitor

Screen goes Black about 1 or 2 seconds after powering up.

You have problem wit the lamp just plug in another once you removed the back cover and if the lamp stays on the it is 100%. you do not need original lamp. Any 15" lcd lamp that fits will do the job. HA HA well done\015\012Ahmad\015\012COM ... Computer Monitors

LCD screen goes black repeatedly

Make sure you test that the power brick is supplying power properly before you go down the road of buying a new one of them. I had it tested and it is working fine. The backlight in the monitor itself seems to have the problem. Good thing I didn't ge ... Fuji FP-988D 19" Flat Panel LCD Monitor

Black screen not booting

Check both your power and video connections to the monitor, sounds more like a monitor power issue.\015\012if the connections appear ok, but screen still blank, try connecting a known good working monitor from somewhere else and see if it works ... HP Pavilion a305w (DM181AR) PC Desktop

ACER AL1914 LCD Monitor goes black but green light stays on

The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Keeps blinking out to a black screen

Hi,If the power light stays on and the unit works even if for just a moment, then chances are that you either have a cold solder, or a heat problem with some components or your CCF Lamp is starting to fail.All possibilities re ... Computer Monitors

The screen stays on for only 2 seconds and then goes black. I push the button on and it will come on again for 2 seconds for several tries. Pretty soon it won't come on at all but you can see the button turn on and off on its own with a faint flash on the screen. After awhile "Dell" appears briefly on the screen and it stops flashing on its own. I can then turn the screen on and off again for awhile with the button and then the process starts all over.

Most likely the back light is problem.If you see the whole screen initially, the CCFLs are ok.Solution 1. Replace the power board, if you can get a cheap one.Solution 2. ** Warning ** This method defeats the protection circuit ... Dell Computer Monitors

VA1930WM monitor turns on, displays normal for one second then goes black. Then it turns on again after a minute or so for one second and goes black. This keeps repeating over and over. Is there a known cause for this condition? It does the same thing on two different computers so I'm sure it is in the monitor. Power supply maybe? The power light stays on all the while. BK

If it was the power supply, the light would change to amber (orange) and then turn green again when it comes back on. Look closely at the screen when the it looks to turn off. See if you can still see an image. It may be hard to see, but when the bac ... Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9841 seconds