Having problems with your KDS Computer Monitors ?

I get error message: Out of Range, on my 17 inch LCD KDS monitor

\015 On my 17 inch KDS flat screen color monitor I get the error message: Out of Range, when I turn on the computer. The Current Freq is Hf = 91.1 khz, Vf=85 hz. The correct range for Hf is 30-80 Khz, and for Vf 55-75 Hz.\015

Answers :

Get the monitor that you used previously, and on the Windows desktop, go to display properties, in settings> advanced, under the monitor tab, change the refresh rate to 60, which is common on these flat panels.
Repair Help & Product Troubleshooting for KDS Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I get error message: Out of Range, on my 17 inch LCD KDS monitor


Get the monitor that you used previously, and on the Windows desktop, go to display properties, in settings> advanced, under the monitor tab, change the refresh rate to 60, which is common on these flat panels. ... KDS Computer Monitors

"No signal detected" when LCD connected with DVI-D Cable


Thank you for providing your configuration details.\015\012You have failed to specify wheather or not your LCD Display is under Warrenty.\015\012\015\012Perhaps these simple trouble shooting procedures will get the job done.\0 ... BenQ FP71E 17" LCD Monitor

Monitor out of range when a game is booted up


The maximum resolution for the MV540 is 1024X768 @60Hz refresh. The other monitor isn't giving you an error message because not all monitors have that feature, but both the monitors are unable to display whatever data the computer is sending. If the ... Compaq MV 540 15" CRT Monitor

17 inch monitor goes blank - X2Gen MG19MY 19" LCD Monitor


\015\012Prepare to diagnose the computer .\015\012\015\012\015\012\015\012Disconnect all peripheral devices.\015\012\015\012Perform a Hard Reset.\015\012\015\012Disable th ... X2Gen MG19MY 19" LCD Monitor

Frequency problem of LCD monitor


Bugcafe: LCD monitors work best when you system is set for the native resolution of the monitor, and at not more than about 75 Hz refresh. For a 15 inch LCD that's 1024 x 768 and for a 17 inch it's 1280 x 1024. In windows you would right click on the ... ViewSonic VA800 17.4" Flat Panel LCD Monitor

Chimei CMV 938D 'Out of range' error message only when using DVI Connector on specific resolution and color depth


I know this sounds obvious but- I had the same problem, and turns out the cord want plugged in quite properly at the back of the monitor. This may not fix every problem, but, I suggest you check the cord pligged in at the back of the monitor is firml ... Envision EN-7100e 17" Flat Panel LCD Monitor

Outof Range error message & black screen


To resolve this behavior, either change the refresh rate which is what is chnaged or the resolution or change the video adapter settings.\015\012 \015\012\015\012To change the refresh rate:\015\012\015\012 ... HP L1940 19" LCD Monitor

An Out of range box


Frankr2327\015\012\015\012If you are getting this message this means that you are connecting a device to the monitor and/or a connection that is putting out a signal that is not supported but the monitor. You may also need to look at the ... Envision Computer Monitors

LCD Computer monitor as a TV monitor


Get an out of range message ... Westinghouse Computer Monitors

I have a red vertical line on my dell inspiron laptop.How do I remove it?,please


Try connecting an external monitor to the Dell Inspiron 9300and see if the vertical line is also present on the monitor. If themonitor display is fine, then your laptop’s LCD display panel isdefective. If the monitor also displays the ver ... Dell PC Laptops

Massive series of problems with IBM Thinkpad


Probably itz either minor case of software corruption/improper ground/cpu fan..or major case of faulty or defective main board/ram/addon/daughter cards....plz do check the following as in order:..the Hardwa ... IBM ThinkPad R40 2897 Notebook

"Out of Range" Message


This happens when your screen resolution is set to something higher\015\012than what your monitor can display. For example, if your monitor\015\012supports resolutions of up to 1024x768 and your video card allows you\015\012to crank it up to 1600x120 ... Compaq Presario V400 14" CRT Monitor

When i turn my computer on with the normal mode it says it's out of range. how do i fix that?


You need to set the resolution on the PC to native resolution (1024 x768 @60Hz) of your LCD monitor, the resolution was too high for the monitor to display, that is why you get the error message. Start the PC into save mode by hitting F8 key during b ... X2Gen MG15VT 15" LCD Monitor

Dell GX270 Maxtor 7Y250M0


If you are getting bad block reports on your hard drive, it means that your hard drive media has suffered some degradation. It could very well be that some system files are being affected by this, thus continually triggering the problem. You may no ... Dell OptiPlex GX270 Small Mini-Tower Desktop (162823025)

Monitor powers on for approx 8 secs then standby.Series of vertical stripes on panel but no image.Guessing the lcd is at fault?


When I applied the solution below, I go stripes when poorly reconnecting the logic board to the plate, and the plate ability to do it job can be effect by bits going on the inverter, wavely screen output etc. The lcd is an assembly kit inside have a ... iiyama ProLite E434S 17" LCD Monitor

Intstalled starlogic moniter to PC and got error message


Hi,\015\012the "Out of Range" message usually appears when the video card is putting out a video resolution or frequency that the monitor isn't able to handle. You should reboot your computer and BEFORE the Windows screen shows up, press the F ... Computer Monitors

My monitor shuts off(goes blank for a few seconds


The monitor is doing a self test a finding an error.The lcd has three parts, the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, ... LG L1915S 19" LCD Monitor

Connection hook up problem


Set the resolution lower.It is telling you that the resolution you want is beyond its normal operating range.just drop it to lets say 800 x 600Then bump it up one resolution at a time until you get the message again, the ... Computer Monitors

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Screen shows different colour grids when starting then goes black with message in right corner "out of range"


Hello ssi1,This happens when your screen resolution is set to something higher\015\012than what your monitor can display. For example, if your monitor\015\012supports resolutions of up to 1024x768 and your video card allows you\015\012to ... PC Desktops

Envision EN 5100 E with Dell Inspiron 530...


You can try to reset your display settings... try 640x480 resolution 60Hz refresh rate this can be done in the control panel under display---settings tab..good luck.if that doesn't work I would just return it and ... Envision H170L Monitor

Sony desktop booting


Runtime errors\015\012\015\012\015\012\015\012\015\0129, Subscript out of range, Program error, verify the program has all the latest updates. If upd ... PC Desktops

Flatron LCD Montor to a Dell Dimension XPS T500


> out of date?\015\012\015\012Are you sure that it is "out of DATE" ???\015\012\015\012\015\012Reconnect your old monitor.\015\012Set the screen-resolution to 800-by-600 at 60 Hertz.\015\012Shutdown. ... LG Flatron L1951S 19" LCD Flat Panel Monitor

No Power,No Booting,...


Try to visit http://www.acerpanam.com/synapse/forms/webpage.cfm?siteid=7117&areaid=2&website=AcerP ... Acer Aspire 5100-5022 Notebook

Solution for "my laptoop seems to want to boot but when is is done booting the screen turns black and remains that"


If the laptop appears to boot up and you can't see an image on the screen, you need to determine if the screen is faulty or the video card.\015\012Connect an external monitor to the laptop's external video port, power up the monitor first and t ... Acer Aspire 3680 Laptop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0270 seconds