Having problems with your IBM xSeries 226 Server ?

I have a raid controller (ServerRAID-61, Brodcom)

\015 I have a raid controller (ServerRAID-61, Brodcom UNDI PXE-2.1 V7.5.14) on eServer 226. this morning the system was down, when tried to boot up, i get 1962 operating system not found. and also give message No SCSI Controller 3E21"\015

Answers :

Repair Help & Product Troubleshooting for IBM xSeries 226 Server

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a raid controller (ServerRAID-61, Brodcom)


... IBM xSeries 226 Server

I have an IBM eserver x series 255 and i just replaced the scsi drive on it but i still see the drive in failed status i want to know where in the bios do i go to configure the new drive?


If this drive is hot swappable, and it's a part of a RAID array, the RAID controller should handle the rebuild of the drive automatically. There are two easy ways to configure the new drive. 1 - reboot the server, wait for the ServerRAID BIOS to st ... IBM eserver xSeries 255 8685

IBM server dc can't boot due to system32driverspci.sys missing


You mention on boot that the server shows a logical drive of 158GB, which obviously means the server is detecting the drives ok.Quite often Windows doesn't have the correct drivers to support systems using RAID controllers such as IBM Ser ... IBM eServer xSeries? 206m

Raid 0 on Intellistation 6221?


That particular work station comes with both IDE and SCSI drive interface controllers. The IDE drive should be used for your OS. The SCSI drives for your data storage. Now, the issue is to get the SCSI to work in RAID_0 as I understand.\015\012 ... IBM IntelliStation Z Pro 6221 PC Desktop

FSC Amilo Xi 2550: JMircon RAID controller and Intel Turbo Memory


U have to install raid driver from the mother bord if u have disable it then go in bios by press F2 or Del key then advace manu then go chip setting there u have to disble raid controller if give me the model no of *********** bord i can provide u a ... PC Laptops

Boot a Tyan Mobo from a SATA AID


... PC Desktops

Dell Poweredge 4300 Bootup problem after cmos battery replacement


Check the version for the Raid Controller. This may need to have the firmware to be upgraded. If the controller is removable, take the controller out and then see if the computer will continue past the bios. If the controller is built-in, then disabl ... PC Desktops

Raid 1 how to use raid or mirroring ina ibm x 3400 server system ,it has 2 hdd of 250 gb,and work with Linux server


Restart server > wait for raid controller to boot > after successful controller boot , it displays the shortcut key to enter controller menu , then press that keyFor Adaptec controller it is ctrl + a key For MegaRaid controller i ... IBM x3400 Server

Can't get sata connection to work on new blu-ray rom


Oilers5, let's check a few basics first. Double check your dvd's data & power connections first. Everything good? Next, you need to get into your bios. Your blu-ray is connected to the SATA controller on the motherboard. Though I do not doupt the ... PC Desktops

Problem with scsi driver proliant ml 370 for NT4


Are you attempting to boot from the Windows CD?If you are booting the server from a Windows installation disk and it is unable to detect the hard drive, this typically means the following things. You need to provide the driver for ... HP Compaq ProLiant ML530 Server

Wont boot says array controller wont start and no bios dell power edge 2500 server


Sounds like the RAID controller has failed. I would replace this first as RAID controllers are less expensive than replacing the system board, or the server as a whole.\015\012\015\012Suggested: PERC 5i (RAID 0/1/5) or PERC 5iR (RAID 1 or ... Dell PowerEdge 2500 Server

Prolinat ML350 G2 WONT BOOT UP


You have apparently attempted to attach a tape drive or other similar device to a SCSI RAID controller. You will need to get a separate SE SCSI HBA instead. These are pretty cheap, usually just over $100 list from HP.\015\012\015\012If ... HP Compaq ProLiant ML350 G5 Server

No SCSI Chips found on the adapter


You might want to update the firmware for the scsi controler,plus upbate the esm ,and the backplain for the server ,you should be able to locate this on the support.dell.com website.failing that if you are using a raid card this might be bad,however ... Dell PowerEdge 6400 Server

Boot from non Dell raid controller


Check the Boot Sequence again -- if there are any "SCSI" devices listed, enable them, and make your CD-ROM the "primary" boot-device (so that you can install Windows) and make this "SCSI" device the SECONDARY boot-device, and disable the internal har ... Dell PC Desktops

Constant beep on poweredge 840 appears to work alright


Hi\015\012\015\012Besides standard beeps codes indicating Processor, CPU, Memory or Systemboard failures, \015\012Dell PERC (PowerEdge Expandable Raid Controller) or SAS Controllers (Serial Attached SCSI) generate beeps to alert fai ... Dell PowerEdge 700 Server

W2K3 O/S does see additional SAN drives


Although the system "sees" the drives, it also must have the new drives included in the RAID method you are using within the SAN system. Depending on the RAID type and controller used this can be accomplished in several wa ... HP Compaq ProLiant DL380 G4 Server

Dell inspiron 1721 hard drive not recognized for Vista reinstall


Ok, theres a small issue with the raid controller. You have to install a 3rd party raid driver (its on the dell cd) to continue, OR, you can set that BIOS's hard drive controls to ATA or LEGACY (legacy would likely work best, but youd have no 'raid' ... Dell Inspiron 1721 Notebook

Ibm x series 226 attempt to install os and says no harddrive


Make sure that the motherboard and/or disk controller recognize the drives during POST.\015\012\015\012Then check and see if IBM has a server installation CD-ROM that you can use boot the server and automatically load the correct drivers ... IBM xSeries 226 Server

Problem in XP installation in the HP presario Note book


Sata hard disk does not require driver, however the sata controller which belong to any manufacturer may require. You have to go to driver cdrom, browse for IDE OR SATA if you cannot find it the clue is "RAID" find the RAID driver, you will also fin ... HP Pavilion dv6000z Notebook

Raid configuration please let me know how to configure raid in the IBM X226 server as i am doing it for the first time. there are 2 nos. 70 GB harddisk installed in it. O/S is Windows 2003 Server.


When your system boots up you should see an option to access your raid controller if not or if your system doesn't see the controller at all you will have to download the utility software from IBM, but you need ... IBM eServer xSeries x226

Cant create additional raid


Hi martyblueCheck this for specs:http://www.redbooks.ibm.com/xref/usxref.pdfThe raid controller onboard is dual channel. Are you using a serveraid card as well? How have you configured the existing arrays? You may need to use ... IBM xSeries 226 Server

Windows delayed write failed


Some common reasons for a delayed-write failure are:\015\012\015\012\015\0121. Problems with a device driver, especially a SCSI or RAID device driver.\015\012Some RAID device drivers are known to issue s ... Computer Servers

Is raid controller onboard - Acer Altos G510 Server


Yes. there is an integrated RAID controller onboard this server unit.\015\012\015\012\015\012\015\012\015\0121 x RAID - integrated\015\012\015\012Ultra320 SCSI\015\012\015\012RAID 1 ... Acer Altos G510 Server

Dell XPS w/Mirrored drives. No C drive when using boot disk.


As RAID uses block for block copy, a re-sync when adding in a new mirror on RAID 1 will take some time, and system performance will be affected during that time period. There is no indication in windows if the rebuild is complete as this is bei ... Dell My XPS M2010 Notebook

RAID-1 failure on Dell Dimension 9100 Desktop


Since you are using RAID 1 (Mirroring) you will only need to send one drive for data recovery.\015\012\015\012Since the Dimension 9100 uses SATA HDDs yes you can increase the storage capacity up to a matched pair of 650GB drives. I'd suggest ... Dell Dimension 9100 PC Desktop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2511 seconds