Having problems with your IBM PC Desktops ?

Power pin outs

\015 I purchased a ibm netvista 8317 s42 motherbaord and can't find the front panel pin outs for the power on and hard drive led etc. etc. Can you help?\015

Answers :

Repair Help & Product Troubleshooting for IBM PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dc7100 has a compact power supply with proprietary 24 pin plug. Pretty sure power supply is non-functional (shorted green to black and fan didn't come on). Is it possible to rewire a conventional ATX supply with this smaller 24 pin plug? I need to know pin outs? Thanks


I just spotted this, hence the late solution. Perhaps this will help someone in the future.Yes it is possible.Observe the color code of the insulation of the wires. 1) Orange wires are 3.3 Volts2) Red w ... HP Compaq dc7100 PC Desktop

Pinout on t6410 gATEWAY CONNECTING POWER BUTTON


I don't see that this problem was solved. Adding additional information.The eMachines T6410 Desktop PC uses an MSI MS-7145 motherboard.(MicroStar International ), ... E-Machines eMachines Desktop PC

Mag Innovison LT917S LCD Monitor


After looking at the description of the pin outs on the BIT3193 and following signals to/from that chip I discovered I had burned up one of the FETS that I had installed. With the FETS replaced for the second time the monitor works fine now. HEY!! ... Gateway FPD2275W LCD Monitor

Power pin outs


Refer to this diagram.http://www-307.ibm.com/pc/support/site.wss/document.do?sitestyle=lenovo&lnd ... IBM PC Desktops

Foxconn LS36 mobo , front panel (34pin) connection DETAILS needed


Dell has never published the pin-outs of their proprietary ribbon connectors to the front panel ... Dell OptiPlex GX270 PC Desktop

Emachines 790 the front of the machine came off and the attached leads that run from the front cover (the on switch) to the main unit were disconnected. The 3 leads are for the Power switch; power LED; HDD LED. I am just wondering where to reconnect them (they have very small plugs at the end. Many thanks.


I'm still looking the pin outs aren't listed even in the manual.I believe your board is a TRIGEM IMPERIAL G (intel845G) ... E-Machines eMachines Desktop PC

I have a 17 inch mag moniter and when i turn it on the green light comes on and blinks but is really hard to get the screen to turn on. usually have to click the mouse all over the screen until it his something??


Sounds like an Inverter problem. I hacked mine into the case after this happened. Running it off of the Power supply now that I figured out the pin outs for the video power. ... Mag Innovision LT776s 17" LCD Monitor

When I turn the computer on I get a buzzing noise and it won't boot. I press the power button and lights 3 and 4 are illuminated on the front. Fan is active, screen power light goes orange. When I press the power button again it instantly turns itself off. Any help gratefully recieved!


The LED lights on the Front Panel are Diagnostic Lights.LED's 3, and 4 being illuminated, indicate a problem with the ram memory modules (Sticks), according to Dell.This is Dell Support, and the Service Manual main menu, for t ... Dell DimensionTM E520 PC Desktop

I have a dell demension 4300 that recently started having issues, slow cutain effect, freeze ups. harddrive clicking away. Then one day I had the blue screen that said an error was detected. Then it wouldn't reconize the harddrive but it would go into the bios screen and then not do anything else. So I took it in to have it diagnosed and they said the edie circuit on the board was fried. They offered me a card option for the back but I opted to replace the motherboard with one that was listed as


CaSmogTech,There is a No Signal on the monitor because the monitor is not receiving a Video Signal.Your computer is not producing a video signal.In essence, your computer isn't working, because there is no Operating System on ... Dell Dimension 4300 PC Desktop

I was unable to power up my 8250 and I have oirdered a new power supply. Is this difficult to install and is there a set process to follow?


Not difficult at all.1) Work on a table. Computer unplugged from power, computer case open. TOUCH the metal frame of the computer case. (Not shouting)[Your body carries Static electricity. Static will fry out the hardware comp ... Dell Dimension 8250 PC Desktop

I would like an internal view of eMachine T4150 to be sure everything is connected correctly


There's a bit of a toughie! eMachines doesn't like to give out this information, lyndapalimas, and I don't have one sitting in my shop.eMachines used four different motherboard manufacturers, to my knowledge. TriGem, Intel, FIC, and MSI. ... PC Desktops

I need a diagram for wiring a new power supply to a Gateway 509ge.


Although this problem is a year old, no solution was stated.Stating this in the hope it may help someone in the future;This is Gateway Support, and the main support page for the Gateway 509GE Desktop PC, ... Gateway 509GE PC Desktop

Need to know what parts compatable to ATX-1523D for an emachines T-1090


It's a Small Form Factor power supply. 4.9 inches Wide, 2.5 inches Tall, and 3.9 inches Long.Put's out a maximum of 150 watts, (Supposedly)Has the following power cables;A) (1) 20-pin ATX main power cable: ... E-Machines T1090 PC Desktop

Need where pwr sw and pwr led and hdd led plug onto au31 motherboard


FIC AU31 mb (a.k.a K7m-NF18G mb)Pin Configuration = PinoutThe Front plastic panel of the computer is the Front Panel.The area of pins on the motherboard that the cables (Wires) go to, is the Front Panel header.Front Panel head ... E-Machines T3092 PC Desktop

Bad power supply, installed new one, get green light on mother board; but doesn't boot up. Bad start up button?


Yes, it is my belief that it is the Power On button. To test this, there is a simple solution. I however, would like to caution you at this point.You will have the power supply plugged in. There will be a small spark. I wouldn't advise how to t ... PC Desktops

There is a bad connection between the power cord and the port into which it fits. this bad connect has lasted for weeks. i've been able to jiggle the cord and situate it so their is a connection. but, now i have lost the connection entirely and am operating solely on with battery. need help.


The port on the laptop where the AC adapter, (Charger to some), plugs into is the DC Power Jack.(Or DC-in )This is an example of an aftermarket manufacturers offering for a DC Power jack, that fits an Acer Aspire 4520 Series Noteboo ... Acer Aspire 4520-5582 Notebook

No power Hi there! Its been 2 month I haven't turn on my computer but just now I turn it on it is not working at all no power and even the cpu fan is not spinning at all can anyone help me with this please thanks.


1. Please check with the power supply of pc from a/c plug.\015\012\015\0122. if power supply is ok then ensure that the input poewer cord is at right position in behind of cpu.\015\012\015\0123. If you are using old type power supply (which do not au ... Compaq dc7100 Small Form Factor (PJ361UA) PC Desktop

My Dell XPS 420 will not turn on. Power light


Hey! Nice Computer! ( At least while it was working! Specifications show some high-end hardware parts)Steady amber light on the Power On light, means a bad power supply.The Dell XPS 420 uses the standard ATX style of power sup ... Dell XPS 420 PC Desktop

Dell Dimension 8200 does not power up.


1) It could be something as simple as the 4-pin ATX +12 Volt power cable isn't plugged into the motherboard.The 4-pin +12 Volt power cable supply's power to an Intel Pentium 4, and above, processor. Looks like this, ... Dell Dimension 8200 PC Desktop

My t2862 powerlight will not come on but a green led comes on on the main board, nothing else happens. I also disconnected the pwr sw,hdd led and pwr led plugs and don't know which pins they go on. Thanks


On the front panel header where the wires connect, there are two rows of 5 pins. The top row actually has 4 pins with the end one missing, and the bottom row has 5 pins. The first two pins on the top row are for the power LED. The next two pins are f ... E-Machines T2862 PC Desktop

I have a phillips freevents desktop pc which


Not much information out there Steve on the Philips Freevent 9602/05 Desktop Computer.This is from Techguys.com,http://support.thetechguys.com/layout.aspx?ID={6ac70071-61fe-4e67-b886-1761c0b50c92}&CatID={b9f15b97-d311-4395-aceb- ... PC Desktops

I have a T2958 and toof the face off. Can you


EMachines doesn't give out this kind of info, and I don't have one in the shop. eMachines also had the habit, of using a few different manufacturer's of motherboards. Intel, TriGem, MSI, Asus,and FIC to name five. Plus eMachines wou ... E-Machines (T2958) PC Desktop

Front panel leads Emachine model T2862


E-machine model T2862 pin-out for the 10-pin front panel header is screen-printed on my Emachine's motherboard, but is so small and far away from the actual pin location, that it is likely being overlooked. If looking into the computer case from the ... PC Desktops

How does the power switch and led plug up on a GT5428 motherboard?


This is Gateway Support, and Support Documents for the Gateway GT5428 Desktop PC,http://support.gateway.com/s/pc/R/1009466/1009466nv.shtml ... Gateway GT5428 PC Desktop

Hp pavilion dv6000


The only internal power for a laptop is the battery. The external power is the AC adapter. (Charger)If you're asking for the schematics, for the circuitry and component layout of the motherboard, to my knowledge only HP trained authorized techn ... HP Pavilion dv6000z Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4624 seconds