Having problems with your IBM eServer xSeries 346 ?

SCSI hard disk is not detecting in IBM xSeries 346 Server

\015 I have a IBM xSeries 346 server. The SCSI hard disk is not detecting in the server. When I install the windows 2003 server, its showing "Setup did not find any hard disk drives installed in your computer"\015

Answers :

While running the windows 2003 setup (winnt.exe), it will ask for SASI driver, you have to add the scsi driver... then windows 2003 os will detect the HDD.. then it will install..
Repair Help & Product Troubleshooting for IBM eServer xSeries 346

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

SCSI hard disk is not detecting in IBM xSeries 346 Server

Hi While running the windows 2003 setup (winnt.exe), it will ask for SASI driver, you have to add the scsi driver... then windows 2003 os will detect the HDD.. then it will install.. ... IBM eServer xSeries 346

New install scsi hard disk no detect in ibm x3400 server

You will need to add the new drive to your array bbfore it will how up to be formated do this throught the array configuration util\015\012\015\012\015\012\015\012Regards Al "alstech" ... IBM x3400 Server

Server XSeries 220

Yes, that is the total amount of hard drive space.This server was built for speed not for storage.The xSeries 220 server supports four SCSI hard disk drives. The server does not support IDE hard disk drives. Some models support hot- ... IBM xSeries 220 (86451SF) Server

How to make the IBM eSever boot from the internal SCSI HDD

... IBM eserver xSeries 255 8685

While installing debian on IBM Xseries 306m it can't detect HDD

Have you initialized the disk from within the BIOS ? if not when you boot the server it says there are no hard disks. ... IBM eServer xSeries 306m 8849 (8849E5U)

I can not install Windows on my Compaq Evo N620c

The quickest solution here would be to put the hard drive into a computer that has Windows already running, and format it through the operating system itself. I've run into this problem a few times, and when another computer wasn't available I would ... Compaq Evo N610C Notebook

Dell poweredge 1800 scsi drive not found

Hi,check if the drive is showing in the bios of the server, shut down the server, take out the power cable, press and hold the power button so as to realease flea power, open the server, and reseat the data cable at both ends and if there ... Dell PowerEdge 1800 Server

Install windows xp on a IBM xseries 200 8479 computer

You have to download the scsi driver from the ibm site. You'll need a floppy and floppy drive. When you boot with your xp cd to setup press F6 to install driver.\015\012\015\012Link to your IBM. Since IBM have different models you have to ... IBM eserver xSeries 200 8479

Server doesnt boot

First create a floppy disk with your RAID driver for W2K3 Server. Next boot the server with the W2K3 Server CD, and hit F6 when prompted, and S to add the specific driver for your RAID and using the floppy to get the driver installed.\015\012 ... IBM xSeries 346 Server

Netfinity 550 in the cmos config, it doesn't recognize the drives. I was recently hired and unfamiliar with this old machines configuration and scsi technology. either: i. drives are all dead and need data recovery ii. planar and/or scsi adapter are dead and need replacement iii. something else is wrong and maybe somebody with prior experience may suggest something that I have overlooked anything is welcome thanks I have an IBM netfinity 5500 server. I am running sco 5.0.5 on it but it cannot re

HiThe error message you are receiving "Inquiry command failed Using IBM-PC ServerRaid Host adapter" makes me think you are attaching the tape drive to the ServerRaid Controller, which is only for Hard Disks. There should be a normal SCSI ... IBM Netfinity 5500 M20 4RY (86624RY) Server

Ibm server xseries 326

It is not detecting the HDD because the windows install does not have the necessary drivers. On the windwos install you must press F6 or F2 I don't remember which one but it prompts you for them to load external drivers fro SCSI or other type of driv ... IBM eserver xSeries 360 8686

Problem with scsi driver proliant ml 370 for NT4

Are you attempting to boot from the Windows CD?If you are booting the server from a Windows installation disk and it is unable to detect the hard drive, this typically means the following things. You need to provide the driver for ... HP Compaq ProLiant ML530 Server

Ibm xseries 235 eserver....all of a sudden stopped booting...it was set up through a kvm swtich, the kvm detects a signal and lights up the apprpriate port, yet nothing is displayed on the monitor. disconnected from kvm, connected directly to a monitor, and still no signal....only error light is indicating a HDD problem, that has never failed to put something on the display before, im kinda stuck on how to troubleshoot....i know the drives are good, i guess it could be a LSI adapter problem, but

The drives were working right before it rebooted....it booted into windows prior to this. i shut it down to install another drive, turned it back on and nothing...not even a post screen. i removed the hard drive from the scsi controller and it stil ... IBM eserver xSeries 235 8671

0200: Failure Fixed Disk 0 IBM T-41

There's a possiblility that you can still recover your files. Try to plug your hard drive to a different PC and check if it detects it. Otherwise, there's no hope but to buy a new hard drive. ... IBM ThinkPad T41 Notebook

When you turn the computer on it says SMART Failer predicted on hard disk 0: HTS54108G9SA00-(S1)

S.M.A.R.T. (Self-Monitoring Analysis and Reporting Technology) is a\015\012 diagnostic method originally developed by IBM\015\012 that at t ... PC Desktops

Configure & install two scsi disks scsi disks in ML 150 G2

The SCSI driver is required to installed during the initial boot up for installation when additional drivers are asked .the new models dont come with a Floppy drive so an external floppy drive can be used .The detection of HDD s must be at the startu ... HP ProLiant ML150 G2 Server

Xseries 346 wont boot

You don't say whether or not your os is on the RAID 5 partition. Assuming that it is (for performance reasons, this is not recommended) then you should check to see if you have the option of configuring a separate raid configuration on your raid car ... IBM xSeries 346 Server

How to repair server 2003 in IBM 226 server - IBM xSeries 226 Server

First you need to prepare the scsi drives ie host raid adapter scsi drivers are server raid cotroller 6 scsi drivers by using the serevr raid support cd dikettitools proper os drivers to floppy and boot with widows cd at the time starting boot press ... IBM xSeries 226 Server

I took out all my my old SCSI drives and put in 4 new ones. Now I can't do anything!

I had the same problem.There is a cd that came with the server called "IBM RAID Support" that is a must have to reconfigure the hard drives.It took me a week to find the ISO image.I will upload the cd via FTP and send you the link. ... IBM Netfinity 5500 M20 4RY (86624RY) Server

When booting the ds20 compaq server from system disk it brings an error saying scsi drive at channel 1 dead, target 0 dead and goes on to say the same for all the other disks

If you are sure the disks are ok (they could have been fried by a bad power source) then the SCSI chip is probably dead.Simple test: remove all hard disks and boot from the recovery disk. If you are lucky it will report all HDD channels operational a ... Computer Utilities & Maintenance

While i was formatting a TC2120 server, i used low level formatting with Ctrl+A option after that the server is not detecting the SCSI hard disk although i've tried to install the third party driver with F6 option but it is showing an error message like" file win2000adf6u160adf160.sys caused an unexpected error(18) at line 1211 in D: tprivate tosootsetupoemdisk.c" Please suggest mesomething so that i can install win2000 Server on HP TC2120.

This error message usually relates to the wrong third party scsi drivers being use.\015\012\015\012Check what SCSI card you have installed and make sure you have the correct drivers and that you select the correct driver from the list at ... HP Server Tc2120 (335874-001)

Irq dma err

IRQ's (Interrupt Request) LinesIRQ's are hotlines to the main computer (CPU) that allow devices connected to the computer to signal the CPU that they need immediate attention. If you're a Batman fan, think of IRQ's as the Batphone - getting his atten ... PC Desktops

HDD detection I have a seagate HDD cheetah ultra 320 (scsi), i am able to format the disk but when i try to install a OS it says no hard disk. is it due to jumper settings or due to some other problem

What O/S are you installing? You might need to load the driver during the O/S install. Default ID for a scsi boot disk is 0. Make sure the scsi id is set to that id. ... PC Desktops

Just purchased IBM Intelistation 6221..installing windows????

Hi!\015\012try this. reboot your cpu, then press the CMOS setup key (del), then select load default setting, then go to hard disk detection settings, select the LBA setup. I believe you know how to manipulate the CMOS setup configuration. if still do ... IBM IntelliStation Z Pro 6221 PC Desktop

Upgrade IBM Xseries 346 Server

You can add drives to the array through the scsi management software, then you can extend any dynamic partitions that don't have the OS on them. I don't think you can extend the array if it contains the OS. You may need to use the disk management u ... IBM xSeries 346 Server
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6948 seconds