Having problems with your HP w1907 LCD Monitor ?

My HP w1907 monitor blacks out after turning it on. It only stays on for one second. What is wrong?


Answers :

I've seen something similar in some Iiyama screens recently in the office, it was caused by failing capacitors in the power supply. I managed to replace these with a bit of soldering iron work and the help of this site http://www.badcaps.net/
\015\012
\015\012Be careful if you do choose to take a look inside your screen though, there are some nasty voltages in there.
Repair Help & Product Troubleshooting for HP w1907 LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Black screen flashes after initial power up


This happened to me, and I fixed it, so read on! Switch on... green LED for a couple of seconds, Brief flash of light with display working, the total shutdown. Switch off, repeat but press the front panel power button as soon as the green LED comes ... Sony SDM-HS73P 17" LCD Monitor

Screen not lighting up and staying black.


I have this monitor for 5 years now, and the same problem you described just happened to me. I attached another monitor that a friend of mine lend me, and this one worked just fine. So, I concluded that my monitor broke down, and also consulted with ... BenQ FP567s 15" LCD Monitor

Monitor sleeps after one second


... AcerView F51 15 in. Flat Panel LCD Monitor

Proview monitor won't keep the screen on


Bzinbby1, Hi, I think I know what's wrong. In fact I already know what's wrong! But I want you to do one test to let me know how bad it really is! Here is the test. I want you to reconnect your Proview to an already fully booted "KNOWN GOOD" pc wit ... Proview PL913B 19" Flat Panel LCD Monitor

X2gen mw19u 19'' widescreen monitor going black


X2GEN - MW19U, same problem as described in the other posts. A week ago after a reboot it did not turn on. Pressed the power button, it turned off. Pressed it again after about a minute, all was fine until this morning. Same as before except t ... X2Gen MG19MY 19" LCD Monitor

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Monitor stays black


This sounds like your monitor has kicked the bucket. If this monitor is for a laptop I would try replacing the inverter before the monitor but if it's for a desktop it sounds like a legitamate problem with your monitor. If that is the case you may ha ... Computer Monitors

Soyo 17'' Monitor (DYLM017A)(VT17N71), identity of fuse.


Orange color of the ring means number 3. Part of marking also contains "3A" so I'm pretty much sure it is 3 Amps rated fuse. But before replacing it measure the resistance on the PCB where that fuse was blown, between common mask (usually metalized m ... Computer Monitors

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Video problem on my Dell Dimension 4600 PC, HELP ASAP.


The resolution set by default when you load your graphics driver is outside the range of your monitors capability.\015\012\015\012try starting in safe mode then adjust your resolution to 640 by 480 then restart.\015\012if this works ... Dell Dimension 4600 PC Desktop

Gateway monitor FPD1975W won't display


Same problem - unplug both computer and monitor - hold power button for monitor for 15-30 seconds...then power it back on and then power on the computer. Seems from other sites there is a power issue with the monitor - this worked for me. ... Gateway FPD1975W 19" LCD Monitor

Green light comes on for a few seconds then turns orange


Hello,If you have a popped cap then the mosfets are blown. They blow as soon as the cap shorts and pops. You need to replace both mosfets and the 220uf caps and test the fuse with a multimeter I would bet its blown too.Buddy ... Acer AL1916W 19" LCD Monitor

Monitor displays breifly then goes to blank screen


Well my Acer AL1711 finally gave up in as much as the screen flashed briefly at switch-on then went blank, regardless of brilliance setting so I decided to take it apart and try to fix it. The good news is that IT WAS NOT THE LAMPS that I feared in m ... Relisys RLT1720 17" LCD Monitor

Computer monitor wont stay on


LMAO it sounds like it is going into power-saving mode because there is (or it -thinks- there is) no signal. Has it always done this? Try punching up the controls when you turn it on and changing its behavior through those menus. Doublecheck the m ... PC Desktops

Monitor flashes image for split second then goes blank but green LED flashes as well


Have you checked the capasitors?,if they,re ok then the proublem is one of the transistors it will have the letters DKQA on it ,they control the backlight power ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor

Monitor Issue: 5 seconds of picture the monitor goes black.


I had this similar problem. I found out that there was a bad 1000uf, 16V cap on the power supply board. The cap is too close to a heat sink and over heated. I bought the cap at radio shack for $2, installed it so that it is far away from the heat ... Computer Monitors

Philips 190S monitor - Urgent!


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Philips 190P6EB 19" LCD Monitor

My monitor stays on for 6 seconds


Hello,You have a monitor with a common problem. After a few years some LCD monitors will\015\012blow a power supply. The problem is caused by parts called capacitors\015\012overheating in the confined space of he monitor. If you are good ... KDS Radius RAD-7 17" Flat Panel LCD Monitor

When I turn on my Sceptre monitor it stays on for a few seconds


This seems to be a comman fault with alot of monitors, the problem is caused by faulty componants on the power board called capacitors.If you have soldering skills and a bit electronic knowledge its an easy repair and one that you could t ... Sceptre Computer Monitors

I have a samsung 920nw monitor bought it new. It has worked great for months, this morning I went to turn it on and it only came on for a second then turned off. I have restarted the PC and the monitor repeatedly with the screen only coming up for 1 second then going black w/ the indicator light staying on not blinking. I've connected it to my laptop with the same result and even unplugged it from the PC just to see the check signal cable screen and it still only stays on for 1 second. Please he


Hello,It sounds like you have a monitor with a common problem. After a few years some LCD monitors\015\012will blow a power supply. The problem is caused by parts called\015\012capacitors overheating in the confined space of the monitor. ... Samsung SyncMaster 920NW Monitor

Gateway fpd1760 monitor loses picture after 2 seconds...


Check to see if the image is Dimmed. Chances are the power supply on the FPD is either dead or not supplying power to the back lights. ... Gateway FPD1760 17" LCD Monitor

Screen goes black but power light stays on


Hello. I had the same problem with my X2gen 19" (model MW19R)monitor. In my case, the monitor would turn off after 20 seconds or so but the blue power light would stay on as well. I had to replace a high voltage capacitor located in the backlight pow ... X2Gen MG19VT 19" LCD Monitor

What is wrong with my AL1711


I have had one of these acer al1711 fail - goes blank after 10 minutes. When warm goes out after 2 or 3 seconds . I have another OK unit and swapped the two logic boards around. 1 board is the video driver other is power invertor. This did NOT fix ... Acer AL1711 17" LCD Monitor

MAG Innovision LT1919WDb flat screen goes black


When a monitor works for a few seconds or more and goes black it is a problem with the power inverter board over heating because of a bad capacitor or capacitors that are not the right size. There is no problem with the VGA controller since it shows ... Computer Monitors

En7410e turns on but wont stay on


Hello,The problem you have is caused by one of two things,\015\012either a blown power supply in the backlight inverter or bad backlight\015\012bulbs. More than likely it is the bad power supply. The problem in the\015\012power supply are ... Envision EN7410 17" LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0139 seconds