Having problems with your HP Pavilion zd8000 Notebook ?

I went into accessories and turned off the monitor


Answers :

Plug in normal monitor and turn it back on... (VGA port somewhere on ur laptop)
Repair Help & Product Troubleshooting for HP Pavilion zd8000 Notebook

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Green light comes on for a few seconds then turns orange


Hello,If you have a popped cap then the mosfets are blown. They blow as soon as the cap shorts and pops. You need to replace both mosfets and the 220uf caps and test the fuse with a multimeter I would bet its blown too.Buddy ... Acer AL1916W 19" LCD Monitor

Monitor Display Problem.


The first Polyview has a power supply problem (a short) and locks out the power until it is unplugged. You need to check the voltages inside the Monitor to determine which component/s are faulty. I hope you know electronics if not leave it to the r ... Polyview V17E 17" LCD Flat Panel Monitor

Whilst in use went completly dead canot resart


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... HP Pavilion dv6000z Notebook

I went into accessories and turned off the monitor


Plug in normal monitor and turn it back on... (VGA port somewhere on ur laptop) ... HP Pavilion zd8000 Notebook

No picture on monitor 997M


One reason that this is happening could be that it is on Power saving mode. This happens when the LCD monitor detecs an incorrect timing then thats the time that the LCD goes blank and the power botton starts to blink.\015\012\015\012what ... Microtech Computer Monitors

Monitor will not turn on at all


What is your monitor brand, size, and LCD or CRT? ... HP vs17

One of two monitors went blank. When I turned it


The problem can be the inverter board or worst case will be the lamps, you need to have spare lamps for testing, that is how I narrow down the problem to find out if the inverter is bad or bad lamps. see example here: ... MegaVision MV220 Monitor

Turned it on a minute later went black - Westinghouse L1975NW Monitor


Good day sir/ma'am hi, if you monitor turns black, here are the more common probable reasons;\015\012\015\012\015\012Your PC went to standby the screen saver kicks in, just reset your PC then the monitor will power on again. ... Westinghouse L1975NW Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

Mymonitor is black and the on button from the monitor is green and is flashing


I havent seen this question asked, and believe me i have searched. i have compaq presario, windows xp media edition 2005, 64 amd processor, model # SR2017CL, with HP 1703 17" monitor. Prob-put computer in hibernate mode other evening, without turnin ... HP Pavilion F1703 17" LCD Monitor

Monitor falls asleep during/after startup


... HP Computer Monitors

The power light blinks solid blue every four seconds or so (it?s off in-between). The screen is blank. None of the buttons on the side function (such as ?menu?). I have a second similar monitor from the computer in the other room I?m using to type this proving the video card and cable are fine. We?ve always (as in years) left the monitor on (w/ a screen saver) but for whatever reason turned it off for four days when we went away recently. The monitor would then not turn back on. After leaving th


Hello,\015\012Two days ago I received a Gateway 900w FDP1975W Monitor from a friend. He told me that he would have to let it rest and it would work for about a hour or so and flash green with lines, then Flashing blue power light, then nothing. ... Gateway FPD1975W 19" LCD Monitor

My monitor just went completely blank. There is a


Hello,The ticking sound you hear is from the power supply trying to power up. If you can solder you should be able to repair the monitor yourself. The problem is caused by blown capacitors on the power board. Go to our web site at : ... Computer Monitors

Monitor goes blank less than a second after turning on.


If you put bright light at an angle close to lcd can you see a windows shadow, text icons etc, ie still logic power passing,then .... (from a.n. other) after two weeks searching I finally find doctor living stone http://www.aplusperfect.com/articles/ ... Dell E176FP 17" LCD Monitor

Monitor went black


Hi there,This is a very common problem,Most monitors go due to the connection, for example when you open and close the lid this loosens the connection so this is your problem.You may be able to find and download th ... Toshiba Satellite L305D-S5904 Laptop

Gateway M305 Laptop


Check to see if the monitor shows up in the device manager.\015\012Right click 'my computer'\015\012click 'manage'\015\012click 'device manager'\015\012look for any yellow question marks beside the 'monitors' heading.It is possible there might be a l ... Gateway M305CRV Notebook

Monitor turns off


If the picture is Reddish either at top or bottom It could be the backlight failing.If you are technically able you maybe able to Replace the CCFL backlight.\015\012Samir ... LG Flatron L1710B 17" LCD Monitor

Dell XPS 400 tower does not power up monitor?


The “self test” on the monitor displays when not plugged into a computer. This means that it’s working. The LED error code 2 and 4 means the video subsystem has a problem. Either your video card is bad or bad memory module. ... Dell XPS 200 PC Desktop

DCLCD 19" flatscreen won't turn on correctly


Same problem here, but after using the plugging/unplugging method it eventually stopped all together. So, I took it to a local monitor repair shop (AM Stereo, Seattle). The problem is a power supply issue where the capasitors go bad. They fixed th ... Sceptre DCL 7A 17" Flat Panel LCD Monitor

Viewsonic VG2230wm 22 Blank screen


Look for bad caps in the power supply first, see example of failed VIEWSONIC monitors due to bad caps here: http://s807.photobucket.com/home/budm/allalbums ... Relisys RLT1720 17" LCD Monitor

Monitor goes blank less than a second after turning on.


Sounds like either there is a bad connection from the computer to the monitor, or the monitor has a faulty power regulator, causing the monitor to overheat prematurely, and shut off. ... Proview PL926WBi 19" LCD Monitor

My laptop froze one time and i had to hold the power button to shut it down. when i turned my laptop back on which is plugged with the emprex, the emprex LCD monitor went to auto adjustment by itself and now its too bright. how do i change it back to normal?


Try to do a syestem restore on it. click on start go to programs. then accessories system tools and at last system restore. and go back to the last time it worked ok. \015\012 good to you sawdust46 ... Emprex LM2201 22" LCD Monitor

Ma acer aspire 5738z does not start at all. the power on led nd the on/off buton light glows but the scree remains black. when i last left the comp i put it to sleep nd it went 2 sleep after installing new updates. now it doesnt respond after 5 hrs.only led light of power nd on off switch shows up..wat 2 do?


When you plug the DC power adapter and press on the power button, the laptop starts making normal noises, the LEDs work properly but noting appears on the screen. The laptop will not start.\015\012First of all, take a ... Acer Aspire 5735 Notebook

Hi, I hope you can help. I have a Sony Trinitron monitor. It suddenly went a bit out of focus. I am trying to find a restore function, with no success. I wonder if you have any suggestions.


Hi,\015\012\015\012Follow these\015\012instructions carefully. \015\012\015\012Make sure the monitor\015\012is in a place where you have easy access, \015 ... Sony CPD G420 19" CRT Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6126 seconds