Having problems with your HP L1702 17" LCD Monitor ?

How to open HP 1702 mornitor case. - HP L1702 17" LCD Monitor


Answers :

Repair Help & Product Troubleshooting for HP L1702 17" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Massive series of problems with IBM Thinkpad


Probably itz either minor case of software corruption/improper ground/cpu fan..or major case of faulty or defective main board/ram/addon/daughter cards....plz do check the following as in order:..the Hardwa ... IBM ThinkPad R40 2897 Notebook

How to open HP 1702 mornitor case. - HP L1702 17" LCD Monitor


... HP L1702 17" LCD Monitor

How to open the casing of my LCD Monitor Model HP w 1907v


I have a problem of opening the casing of my LCD Monitor, I want to open it so that I can visually check inside. ... Hyundai ImageQuest L50A 15.1" Flat Panel LCD Monitor

Philips 190S monitor - Urgent!


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Philips 190P6EB 19" LCD Monitor

How to open casing


Just managed to open a FP17G+ monitor. My hope is that FP17G is similar and that this comes in handy.\015\012\015\012There are 5 screws holding the casing together. Four are in the corners (black screws on my monitor). The 5th is right un ... BenQ FP71G 17" LCD Monitor

My monitor shuts off(goes blank for a few seconds


The monitor is doing a self test a finding an error.The lcd has three parts, the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, ... LG L1915S 19" LCD Monitor

Monitor powers on for approx 8 secs then standby.Series of vertical stripes on panel but no image.Guessing the lcd is at fault?


When I applied the solution below, I go stripes when poorly reconnecting the logic board to the plate, and the plate ability to do it job can be effect by bits going on the inverter, wavely screen output etc. The lcd is an assembly kit inside have a ... iiyama ProLite E434S 17" LCD Monitor

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Dell latitude d500 had a power socket problem, but now resolved pc will not boot-up, drive spins-up, then nothing, completely dead display i think most likely scenario is mobo is fried, but open to suggestions how tio get this working again


Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... Dell Latitude D500 Notebook

How to open an LCD monitor.


I personally haven't worked on this monitor, but most monitors are held together with plastic clips on either side of the casing. After removing the stand and all other screws, you will need to use a small flat-head screwdriver (or someth ... Gateway FPD2275W LCD Monitor

Can't remove cover of Westinghouse LCM-22w2 monitor


Hey Ed,\015\012\015\012 I hope I can help, It doesn't open from the back, it opens from the front.... carefully! There are four support screws, which hold the LCD screen to the desk stand,after removing all the support screws (4) on ... Westinghouse 22" Widescreen LCD Flat Panel Monitor

Extended Desktop on Dell Dimensions 4600


Yes your right..leave it set to AUTO BUT ONLY USE THE ATI CHIP SET VIDEO CARDS.\015\012\015\012\015\012Dell Dimension 4600\015\012We saw great image quality from the 17-inch E171FP analog LCD monitor that accompanied our review syst ... Dell Dimension 4600 PC Desktop

Monitor goes blank less than a second after turning on.


If you put bright light at an angle close to lcd can you see a windows shadow, text icons etc, ie still logic power passing,then .... (from a.n. other) after two weeks searching I finally find doctor living stone http://www.aplusperfect.com/articles/ ... Dell E176FP 17" LCD Monitor

Gateway monitor FPD1975W-UK screen fuzzy lines for a few seconds blue on & off light flashes on and off then screen goes blank also a small current coming through the pc connector cable.


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... Gateway FPD1975W 19" LCD Monitor

Is there an easy way to open this monitor?


-Flip the LCD face down and remove the screws that hold the base in place.\015\012-looking at the top edge of the LCD monitor you should see a small notch on each end between the front bezel and the back cover.\015\012-Using a plastic tool or a flat ... Dell E173FP 17" LCD Monitor

Pavilion dv6600 dimmed lcd monitor


You could have a faulty inverter or a CCFL lamp, To determine if you have a LCD screen, inverter or video card problem, read this and follow these instructions. Defective CCFL backlight, it may have the following symptom: Screen flashs on red/p ... HP PC Laptops

Need to remove dell e193fpc flat panel covers to repair


First remove the stand. Then at the bottom of the monitor there are two small openings an inch or two from each edge. Starting there with WIDE flat blade screw driver (or a couple of them) it IS possible to pop the catches that hold the back of th ... Dell E193FPC 19" TFT LCD Flat Panel Monitor

DELL LCD monitor E151FPb turn white


If the screen is all white light then you can have a number of problems.\015\012One could be a bad video board, the next could be a simple loose wire\015\012from the video board to the back of the lcd screen OR a simple blown\015\012fuse on the ... Gateway FPD1975W 19" LCD Monitor

I have a Cornea 1702. It just stopped working altogether. It doesn't even show the menu nor does it search for a signal as it used to while scrolling thru options or select input! I think it's fried, but I remember some time ago i thought it was all done then it started working again. any thoughts?


OK, first off, I'd like to say that I've never worked on the Cornea 1702, but most monitors follow similar designs, especially generic brand monitors.So there are a few things I need to know: What exactly happens when you press the ... Cornea CT 1700 17" Flat Panel LCD Monitor

Screen will only open for a couple of seconds. I think someone changed the imput settings, but I can't get the screen to stay open long enough to adjust it


Rhettpayne, When you say: "can't get screen to stay open" do you really mean to say that the SCREEN WENT TOTALLY BLACK!! If such is the case then you may have a common problem that E173FP and E173FEP units have. I think that you really need to visit ... Dell E173FP 17" LCD Monitor

Gateway lp2207 appears power supply has burn out...is worth repair any suggestion on repair


Actually the problem is one of the capacitors on the power supply.\015\012\015\012 \015\012\015\012I have the same monitor Gateway LP2207 and just replaced the capacitor.\015\012\015\012 ... Gateway GT4010 (RBGT4010) PC Desktop

Opening the dell 1707FP monitor - PC Desktops


To open the case, do the following:1. Remove the base from the back of the monitor by pressing the large black button on the back.2. Remove the 4 large black screws located under the plate you removed in step 1.3. ... PC Desktops

Opening the case


I am repairing my E173FPc Dell Monitor and to take off the back cover you must look on edge of frame to the lcd and you will see little Pry Slots.\015\012\015\012\015\012 Get a flat head or knife and stick it in there, then give it a twist and "snap ... Dell E173FP 17" LCD Monitor

The brightness/contrast adjustment screen pops up randomly and often. It then scrolls through the 3 options and the only way to remove it is to turn off the monitor. How do I make it stop?


Sounds like your buttons are stuck. Try loosening them up by pressing them, then popping them out again with some sort of pin or needle.If all your buttons seem fine and pop in and out normally, then its probably a problem with the connec ... Dell Computer Monitors

Optiquest Q9 After about 14 months, my 19" LCD Optiquest Q9 monitor suddenly got very dark ( the bottom 1/4 was still viewable, though dark) and then went blank. After it cools for a while I can power it back up with the same results. There is a faint click when it goes black. I have replaced it with another 19" LCD ( different MFG.) which is working fine, but hate to throw this one away if it is repairable. The screen itself seems fine with no pixels missing at the time it went dark. There are


I had this problem with my Q9 and I was glad to find the FixYa website with help. But I will offer more detailed info for novices to make sure you find the capacitors. First of all, it is not easy trying to find out how to open the monitor up! First, ... ViewSonic Optiquest Q9b 19" Flat Panel LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7495 seconds