Having problems with your HP f2105 21" LCD Monitor ?

My monitor when powered up gives me a no input signal for VGA and DVI and then goes into sleep mode after 15 seconds. I plugged in a second monitor and have a no signal message too. Should i replace the video card or has the monitor locked itself out. Please advise....Best Regards Beth.


Answers :

Hey Beth

Sounds like you are in a bit of trouble!

Based on what you've told me, it looks like it might be a video card fault. However, a few things to check first are..

Make sure the VGA & DVI are secured tightly in to their slots, especially on the monitors as gravity can sometimes be a pain!

Use different cords, rather than the original ones you use. This is to eliminate the the point that the cords may be the issues.

And last to know whether it's the monitor or not.. check and use your monitors on another PC. If they go, then it is a hardware fault in your PC, sometime things can come lose and problems can occure espeically with older PCs as they die out. Much like a older car wears down, so do the parts of a PC.

The suggestion I then give you is to pop it in to a Computer Shop, let me test it for a half hour fee and see what they recommend. Possibly it could let on to getting a new graphics card, for a basic one it's no that costly and could solve your problems easily. Or.. it might in fact be a motherboard fault... It's hard to tell, unless you get hands on with it, and test and elimate the causes.

Well, all I can say is good luck, and hopefully you find the issue. Besides, buying something new is always a good thing, so perhaps it's time you upgraded anyway? =D

I hope I've been able to assist you.
Repair Help & Product Troubleshooting for HP f2105 21" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Monitor goes into power saver mode


Take your Agp card with you to the shop. You do not need to go through Gateway, but there are serveal formats of AGP regarding the voltages.\015\012\015\012By the sounds of it you have the newer version of AGP so finding a replacement car ... Gateway 500 X PC Desktop

Problem with the monitor


Hi,The three boxes represent the built-in diagnostics of the monitor. The letters G is green, B is blue and R is for red, the 3 color guns of the picture tube of your monitor. The words "Self Test" indicates that it is in diagnostic mode ... Compaq FS7550 17" CRT Monitor

NO video input philips 180p1 - Philips Business 170B 17" Flat Panel LCD Monitor


Hello there:This normally means that the cable that goes to the computer from the monitor is not getting any signal from the video card This is due to a couple of possible problems the graphics card is not compatible with t ... Philips Business 170B 17" Flat Panel LCD Monitor

My monitor when powered up gives me a no input signal for VGA and DVI and then goes into sleep mode after 15 seconds. I plugged in a second monitor and have a no signal message too. Should i replace the video card or has the monitor locked itself out. Please advise....Best Regards Beth.


Hey BethSounds like you are in a bit of trouble!Based on what you've told me, it looks like it might be a video card fault. However, a few things to check first are..Make sure the VGA & DVI are secured tightly ... HP f2105 21" LCD Monitor

My Computer I took the cable wire off and still it's doing the: VGA input; no input signal, after I keep turning it on and off I do finally get my computer to come on though. I didn't know how to take the back of it off though to try that. Please assist. Thank you.


OK. Thanks for the response. That message is telling us that the monitor is getting no signal from the computer. In your case, it sounds like it is working part of the time. So, here are the things that can cause the problem, starting with the mo ... HP Vs17 17" LCD Flat Panel Monitor

Power light flashes but monitor wont turn on


Your monitor is not receiving a signal from the computer. \015\012\015\012First try the monitor on another computer and/or try a different monitor on this computer. If the monitor continues to have a problem, then either replace it or ha ... Gateway FPD1975W 19" LCD Monitor

Gateway E-3200 no video signal


Hi! there,\015\012 there are common factors why no video on your screen.,right one factor is ram,the other are video card,processor and monitor\015\012you can't trouble shoot with out other computer available,tester cann't detecte ... Gateway PC Desktops

No display (black) - power light is amber color


The video signal is not reaching your monitor, check the pins on the connector from the monitor to the computer, then check the video card: \015\012\015\012Turn off your computer, unplg the power, and then take out the video card. Wait ... ViewSonic VX910 19" LCD Monitor

Try to start my computer but tower keeps on beeping and monitor keeps saying going to sleep. What could be the problem?


Hi, Probable reason for the beeping sound are:\015\012\015\012defective, dirty or faulty seated memory sticks; clean, re-seat or replace (most likely);\015\012de ... PC Desktops

Power save mode


Yes, you arent getting a signal to your monitor from your video card. Try replacing. If its onboard then the Mainboard may be bad. These machines are known by Dell to go bad and is covered under warranty, provided you still have it. \015\012 ... Dell OptiPlex GX280 PC Desktop

My monitor will not come on when power is applied automatically. the monitor does not come up when my system comes on. I just replaced the monitor which i swapped same exact monitor, but this one will not boot when the system comes up.


Please work through the following steps to troubleshoot your no power problem with a ViewSonic Monitor:\015\012\015\012Troubleshooting Power Issues: \015\012\015\012Disconnect and securely reconnect ... ViewSonic E70f 17" CRT Monitor

LCD MoNITOR no Signal


The problem lies with your video card. The fact that it worked on your friends computer proves that it is not your monitor. Some motherboards have two video adapters. One on a video card and one on the motherboard. You need to open your PC case and s ... AcerPower F1 PC Desktop

Monitor malfunction, says VGA Input: No Signal and goes to sleep


From what you have described it appears that the onboard video might have malfunctioned,there is no way to replace it, you can however go buy a video card from your nearest computer retailer. you just want to make sure it is compatible with your mach ... PC Desktops

Monitor says "Check signal Cable"


Lilsidetrack -An obvious cause is that your video card may have taken a dive on you, and it needs to be replaced. If you don't "see" anything on boot up, but what you hear sounds like it's booting, your video card has probably gone bad. ... Samsung SyncMaster 2233BW 22" LCD Monitor

Monitor says no input signal what do i do?


The video card or videl cable or monitor could be faulty.\015\012Connect a different monitor to the computer, if you get no input signal on this too then the video card is faulty. Reseat the video card and test again, if still no good then repl ... Dell Dimension 4100 (-JM0TB01) PC Desktop

No video signal


That does not sound likely. how old is your computer? if it is more than about 5-6 years, it may have a blown power supply(basically your computer is dead) this happened to my friend's computer while i was there and he blamed it on me, if you think y ... PC Desktops

Screen goes blank


Normal\015\012 0\015\012 \015\012 \015\012 false\015\012 false\015\012 false\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 MicrosoftInternetExplorer4\015\012 \015\012\015\012 \015\012 \015\012\015\012\015\0 ... Dell E173FP 17" LCD Flat Panel Monitor

My Gateway GT5685E powers up as does the monitor by I get no signal to the monitor (running Vista) - I have checked cables and the monitor seems to be fine, I have also tried to power up with the operating system CD but the same thing occurs. PLEASE TELL ME THIS ISN'T AS SERIOUS AS IT SEEMS dUANE


Well, there is good news and bad news...first, since it is a desktop and the video is integrated into the motherboard...if the integrated card fails, you can install a midlevel video card intot an empty PCI-E slot and have great graphics again for ar ... Gateway GT5685E Desktop Computer - Intel Core Duo E4600 Dual Core Processor, 4GB DDR2, 500GB HD, 18X...

No Video Signal


Try resetting the bios. On the motherboard there is a battery that looks like a watch battery. Remove the battery, then replace it again. (make sure the computer is unplugged from the wall socket when you do this)\015\012\015\012Does th ... Gateway GT4015E AMD Athlon 64 3500+ 2.2GHz / 1GB DDR / 200GB HDD / DVDRW DL / DVD-Rom / Flash PC Desktop

Gateway LCD powers on but has no picture


I have a Gateway FPD1730 LCD monitor. When I plug it into my Gateway 500x desktop the power light turns green and then says "Power Saving Mode" and then it goes black. It will occasionally flash on and have a picture and then go off. When I unplug th ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor

Red problem i'm having a problem regarding my monitor display. there is a color red only on the my screen. how can i solve this problem...my monitor samtron 45bn i change video section c r t . plssss help. thanks....


It sounds like it's probably a problem with the cable or connection. Usually this happens when the connector isn't seated properly. The first step would be to re-seat the VGA connector by taking it off and putting it back on. If that ... Gateway FPD2275W LCD Monitor

Screen stays black


Try using a different monitor if you have one available, or disconnect the monitor from the computer and then turn it on. If you see a logo or color bar or message saying no signal, then your monitor is OK and you should take a look at your video ca ... Acer Aspire 1414 Notebook

Pc starts and runs but wont boot up monitor shows no signal


1) When you turn on the computer, watch and listen for: a) power supply fan, (power is on) b) chassis lights (power is on) c) ticking sound during memory test (the BIOS POST is running) d ... HP PC Desktops

Dell 4600 no monitor signal


Hey Tony,If you haven't already: pull all pci cards:If you pull the ram, and you get no beeps at post, it's likely the main board. Does the pc beep at all? with or without ram? If not, likely the main board. Sorry. Hope this helps... ... Dell Dimension 4600 PC Desktop

I recently moved my computer into my new condo and have not been able to use it since. The problem seems to be with the monitor. I turn on the computer and the fan comes on but the monitor displays "no signal" and then goes dark but the light one the front still flashes indicating it is getting power. The last time I moved my computer from one room to another, the monitor suddenly couldn't/wouldn't display colors accruately - no red. Attempt to adjust the color by using the monitor's controls we


Lack of video signal is usually 1 of 3 things, Power supply (PSU), Video card or Motherboard (mobo).Situation #1: If you get a blank screen and no sounds or movement it either indicates that the power supply unit (PSU) has failed or somet ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8228 seconds