Having problems with your HP dc7700 PC Desktop ?

Monitor not supported

\015 Have a dc7600 monitor is fine. But just got a dc7700. Hooked up everything. Load XP. Bootup. XP Screen appears then Screen goes blank then this icon floats on the screen (monitor not supported). Run restore and diagnostics screen is fine. Reboot XP screen appears then goes away icon comes back monitor not supported, you hear XP in the back ground but no sceen. Went back to my dc7600. Any thoughts on this issue.\015

Answers :

Well the monitor not being support is not the issue. the issue is the video card cannot produce a signal that is supported for the monitor. Its doing this to let you know also to lower your resolution because the monitor will pop if the resolutions is to high. the monitor itself does not matter if you had Vista as lond as the monitor agree with the signal your cool if it don't it will do this. Try lowing the res using another monitor then put the orginal back on and you should be good.
\015\012
\015\012Thanks
Repair Help & Product Troubleshooting for HP dc7700 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The monitor turns off and on repeatedly.


There are lots of reasons why it can shutdown, but happerlly none should be serious. It may be that the B+ or Power supply is too high, look for a pot near the power supply and try turning it down a bit. Also the x-ray protection may be too high, loo ... ViewSonic VE710b 17" Flat Panel LCD Monitor

I JUST CONNECTED A STARLOGIC FLAT SCREEN MONITOR TO DELL PC AND NOW I HEAR AN ANNOYING RINGING EVERY FEW. ALSO HAVE LOGITECH SPEAKERS CONNECTED. ANY IDEAS?


You need to test the sound circuit in the monitor with another pair of speakers. This should tell you if it is a problem with the speakers or the monitor. If it is in the speakers, replace them. If it is in the monitor, you will have to have a servic ... Star Logic 17" LCD Monitor

Star Logic 17 inch LCD Monitor Problem


The problem is with component failure in the monitor, causing the protection circuit to turn on, This circuit turns on to prevent further damage to the components. The unit should be sent or taken in to a service center for a complete testing and ser ... Star Logic 17" LCD Monitor

Looking for new computer that will support 4 monitors.


I may be wron but i'm not aware of any standard pc that will support 4 monitors. I used to run two monitors when i used my pc for djing on but that was down to the garphics card, many better spec cards will support dual monitor output. You could tr ... E-Machines eMachines Desktop PC

Monitor not supported


Well the monitor not being support is not the issue. the issue is the video card cannot produce a signal that is supported for the monitor. Its doing this to let you know also to lower your resolution because the monitor will pop if the resolutions i ... HP dc7700 PC Desktop

Trubleshoot Motherboard what is mother board prob and how can find n fix them....


More than 70% of all computer problems are related to cabling and connections. Ensure all cables are connected and connected firmly. IDE and floppy ribbon cables and power cables can often go loose. Ensure microprocessor, memory modules, and adapters ... PC Desktops

EzTune problem with lost PIN number to disable Theft Deterence


Whatever you do - DON'T CONTACT GATEWAY. I am in the UK, and the Gateway support number is only available 9 - 5 (funny 'cos I'm at work then and can't access my PC), so I filled in the technical support form - waited 2 days for a reply only to be to ... Gateway FPD1975 19" LCD Monitor

Push button power broke Starlogic LCD 19"


You can find customer support at this website for your monitor. www.fourstari.com They should be able to tell you how to send or take you unit to a service center for servicing.I hope this information helps you with your problem. \015\012 ... Star Logic 17" LCD Monitor

Starlogic 17 in lcd


This monitor is experiencing a component break down causing a loss of the video function. You should send tor take this unit in for a complete testing and servicing at the service center. They will have all the information to do a proper evaluation o ... Star Logic 17" LCD Monitor

Starlogic MJ7BBA with power and VGA cable not plugged in the monitor first show RGB in the upper left corner then a white box with red border stating that it is disconnected. I have tried four computers now two laptops and two desk tops. all four with the same results. using linux ubuntu 8.04, 8.10, and windows XP. every time when the monitor gets a signal the power light starts to flash at a one sec on/off and the display goes blank. I don't get any responce from the three menu buttons ever


This unit has had a failure in control circuit.The unit should be sent or taken in to a service center for a complete testing and servicing. The customer support website is www.fourstari.com They should be able to tell you, what the problem is and ho ... Star Logic 17" LCD Monitor

Computer monitor can not get the monitor to come on. there is power but no screen


This is most likely a problem with component failure in the main video board. The unit should be tested and repaired at a service center,They will have all the information to assess the problem and repair it for you. The customer support website is w ... Star Logic 17" LCD Monitor

Closing notebook - "Input not supported"'


The Input not supported on your monitor normally means that the\015\012refresh rate, or the resolution is set to high, CHK laptop settings\015\012\015\012Hope this helps\015\012Have a nice day ... Acer 22" X223w LCD Monitor

'input not supported'


All I can say is WOW! I have been using my pc with my monitor for months and I was installing a new printer and must have wiggled something loose, and all I was getting out of my monitor was "INPUT NOT SUPPORTED." So I came to this forum, and low a ... Acer AL1916W 19" LCD Monitor

W17e says "input not supported"


Hi - here's what I found about your wide screen monitor:The HP Pavilion w17e LCD wide-screen monitor has the following features:\015\012 \015\012\015\0121440 x 900 factory-set resolutio ... Acer AL1916W 19" LCD Monitor

Acer 20" LCD monitor AL2016W, INPUT NOT SUPPORTED message


Try to reinstall the drivers for the monitor and see if that works.\015\012\015\012http://www.driversdown.com/drivers/A ... Acer AL2016W 20" LCD Monitor

Have just replaced CRT screen with brand new 24- inch Acer V233H LCD widescreen monitor. Couldn't get the recommended resolution, so installed SiS v3.90 driver, (the latest, I think), but my SiS Utility / Support Modes only shows CRT - the LCD part is grayed out. What SiS driver do I need for LCD? Acer says to use 1920 x 1080. I can get this setting with the new driver, but now my Desktop is way longer than the actual screen, and I have to "scroll" left and right, with the mouse, to get to e


Right click anywhere on the desktop\015\012then on the window properties.\015\012then on settings. You should now be seeing your display properties.\015\012Check the slider along the lower left to see if it matches the 1920x1080 ... Acer V233HBD Monitor

Black monitor screen and the green light will not come on either


This unit has had a component failure in the power supply board. The unit should be sent or taken in to a service center for a complete testing and servicing. The customer support website is. www.fourstari.com They should be able to help you with you ... Star Logic 17" LCD Monitor

Yellow line down center of screen


The customer support website is www.fourstari.com. I hope this information helps you with your problem.\011 \015\012\011\011\011\011\011\011\015\012\015\012\015\012\015\012\011\011\011\015\012Welcome to Fourstar Group's customer ... Star Computer Monitors

I've turned the monitor off and on for about 50 times now and each time I turn it on, it only stays on for about a second and then it turns off automatically.


This unit has had a component failure in the power supply board. The unit should be sent or taken to a service center for a complete testing and servicing. The customer support website is www.fourstari.com. They should be able to tell you how to get ... Star Logic 17" LCD Monitor

Monitor Picture is Blurry because of shadows


If you've already checked all your cable connections, to make sure they're tight, check your windows settings: Go to Start>rt click My computer, choose properties, settings on performance, and choose adjust for best performance. (This will unche ... Gateway FPD1760 17" LCD Monitor

I have CRT moniter i installed harry potter Game.when i start the game, it shows "OUT OF FREQUENCY" error with time notification(20 sec) and the moniter shuts. Please tell me the solution .


1. Change the monitor frequency My Computer----->Control Panel-------> Display-----.Refresh Rate tab (select one by one and check the game)\015\012 \015\012or\015\012 \015\0122. try to attach another mo ... LG Studioworks 563N 15" CRT Monitor

Problem with Dell 2100FP LCD monitor


Hi,\015\012 Dell support , would recommend you to buy a new monitor because , they donot do any repairs on the LCD monitors., except for exchanging them, if they are in warranty. You can try the following people , they do repairs on dell flat ... Dell UltraSharp 2001FP 20.1" LCD Monitor

'input not supported'


First install another monitor so Windows will load.Then right click on "My Computer" and select "Properties", then click on the "Hardware" tab and click on "Device Manager" button. In the list and click on the "+" sign next to "Monitors" then r ... Acer Aspire 3680 Laptop

Ground Noise Problem Possibly Attributed to Samsung Monitor


Do you have another power adapter to try? Sometimes those go bad, and are pretty cheap to test out (around $35-$50). Otherwise it is the DC-in board on your PowerBook. I replace about 2 of those per month with our clients up here on the PowerBooks ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

My computer begins to load windows, then after the screen with the windows logo and bars goes away my screen goes black.


Nine times out of ten if that's when your display stops, it's simply because your display settings are set to something that your monitor can't handle. Depending on what it's not supporting, some monitors respond by going black ... others just ... Dell Latitude D800 Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4463 seconds