Having problems with your Hannstar I-Inc TW-191D Monitor ?

Monitor stays on for 1 sec and goes black - Hannstar I-Inc TW-191D Monitor


Answers :

Sorenke, Monitor "switchmode-mode-power-supply" going into shutdown mode when detecting a FAULT CONDITION with some other circuit or with itself. Your monitor has same technology as any other backlit lcd display!! Read more of my responses to owners that have BLACK screen problems. Some have BLACK and BLANK screen problems Do you know flashlight test of SMPS status? How old is unit? How many Total "ON" hours unit have? Do you know what a bad electrolytic filter capacitor looks like? Have you been to YOUTUBE yet? 12fixlouie
Repair Help & Product Troubleshooting for Hannstar I-Inc TW-191D Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Monitor stays on for 1 sec and goes black - Hannstar I-Inc TW-191D Monitor


Sorenke, Monitor "switchmode-mode-power-supply" going into shutdown mode when detecting a FAULT CONDITION with some other circuit or with itself. Your monitor has same technology as any other backlit lcd display!! Read more of my responses to owners ... Hannstar I-Inc TW-191D Monitor

Dell E171FP Monitor goes black after 2 secs


Hi, I don't think the problem is with your monitor. Your monitor sounds like it's doing exactly what it's supposed to do. The monitor is supposed to turn off if there's no cable attached, which means there's no signal input. When the screen goes b ... Dell E171FP 17" Flat Panel LCD Monitor

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Monitor black screen


I experienced a similar problem with my MAG LT776s. As a "band-aid" fix, I have found that if I turn the monitor brightness to near zero my problem is minimized. Meaning - the monitor goes on after a little wait (~ 20 sec) and will stay on. ... Mag Innovision LT776s 17" LCD Monitor

Liquid Video monitor goes black after 30 seconds


I acquired one of these at a flea market. Same problem, same solution as skotkolr's. The "runs for 30 seconds" or cycles on and off is caused by the run capacitor for the switching power supply controller IC. It's usually 47uF/25V and can be found on ... Computer Monitors

Acer AL1711 LCD Monitor goes repeatedly black after bootup after just a few secs picture and has to be turned on & off at least 6 times thereafter with picture staying only 2 secs each time until picture stays permanently. Same thing when connected to a different computer but had to use the same monitor cable each time.


Cpburn, It's BROKEN!!! SHUT IT OFF AND LEAVE IT OFF!!! The "switch-mode-power-supply" has DETECTED a fault and then goes into full or partial SHUTDOWN to save itself from a catastrophic, nonrecoverable failure. eg. sparks, smoke, fire. The good news ... Acer Computer Monitors

LCD display Proview


The power inverter is the problem and the only way to fix it is to replace the board. It was a poor design and my Proview 19" experienced the same screen issues as those previously stated. You'll pay $25 for shipping and up to $65 in repair costs. ... Proview PL926WBi 19" LCD Monitor

I have an SVA LCD Model VR-17S Monitor that has a black screen


Sounds like the Backlight balance sensor circuit is shutting down the inverter supply. A weak bulb can cause this or a malfunctioning sensor circuit can cause it too. Best method to troubleshoot is to substitute good bulbs; if it still shuts down, lo ... Computer Monitors

When i hook up my comp the monitor stays black...whats going on?


Try remove your VGA card and reinsert and test. And if the problem\015\012persist then test your monitor to the other PCs and if it displays then\015\012it could be the card is bad or the monito's resolution was ajusted\015\012causing to be uncompati ... Computer Monitors

Samsung 940BX LCD monitor 9 mos. old, Problem with monitor not staying on. You turn it on, it will come on for about 3 secs w/picture then goes off, but blue light stays on, black screen. Press power button again to turn on, it will come up for about 3 secs w/pic, but then shuts off again w/blue light staying on. How do I fix this?


The IPboard part no. BN44-0012A is bad. We had to replace 5 monitors with the same problem. If under warranty call 1-800-Samsung for repair or exchange.Korhan Balimtas ... PC Desktops

Monitor is black. Press power on monitor/screen shows for 1 sec


We have the same problem and think that the monitor may be getting too warm with staying on all of the time. Try to turn off the monitor when you arent using it. It might save you some time while you look for another monitor. ... Dell E172FP 17" LCD Flat Panel Monitor

My acer al1916w displays the image for 3 seconds then goes black


Sounds like your video card. Check to make sure it's connected properly. If so, check to make sure it's properly seated to *********** board. The possible issue could be the card is connected enough to display the picture, but not enough to communica ... Acer AL1916W 19" LCD Monitor

When I boot up, The opening Dell Image is shown for 1 sec, then it goes black. 1 minute later the same thing occurs with the Windows startup logo. Then the screen stays black. I have determined that the problem is with the monitor. What can I do?


Assuming you have tested the monitor on another system and issue follows the monitor or issue doesn't occur on this system with a different monitor here is my opinion:\015\012Due to the cost of repairing a LCD monitor versus the cost to replace ... Samsung SyncMaster 193V 19" Flat Panel LCD Monitor

Screen goes black after 2 seconds


Simplest solution may be the screen resolution settings are set higher than the monitor's capabilities. Try lowering the screen resolution and refresh rate in the display properties or try booting to safe mode (press F8 when the Windows splash scree ... Samsung SyncMaster 940N Flat panel Monitor

Xerox XG-19D LCD monitor goes black in 5 seconds


You may also have to check the IC/Transistors Inverter transfomer drivers, also should Ohm out the resistance of the transformers. ... Xerox XG-91D 19" LCD Monitor

MY MONITOR TURNS ON AND AS IT SAYS STARTING ANALOG, IT IMEDIATELY GOES BLACK BUT FOR A SECOND I CAN SEE XP STARTING


Then ther is problem with your ram,please change your current RAM and upgrade it to newer one... ... Gateway FPD1760 17" LCD Monitor

Monitor sleeps after one second


... AcerView F51 15 in. Flat Panel LCD Monitor

Screen Not Staying On


Hi TontBrowne,\015\012\015\012I'm not sure exactly what causes this problem. However it seems that lowering the 'Brightness' and 'Contrast' fixes things. The problem is, you can't see the menu without the backlight. However, try this, as ... Dell Dimension 4600 PC Desktop

Emachines monitor goes black while CPU is still working


... E-Machines eMachines Monitor E15T4

Monitor comes on, I can see everything perfect then goes black


"Most" newer monitors will let you know if the are no longer receiving a signal. Sounds like the backlight is burnt out. Try getting a bright (LED works best) flashlight and shining it at the screen at all angles to see if you can see any of what you ... Westinghouse L2046NV Monitor

LCD Monitor my hp f2105 lcd widescreen monitor screen goes black after 1 sec when you turn it back on it again stays on for only 1 sec any help would be good, thanks


Is it connected to a PC? is the power source good 110v or 220v? ... PC Desktops

Monitor goes blank less than a second after turning on.


I start my computer and turn it on, and everything looks fine for about 1/4 of a second and then it goes black while leaving the power light green. I can only see the screen again after turning it off and on, but that's only for another 1/4 second. W ... Rosewill R700J 17" Flat Panel LCD Monitor

Same problem i have a planar 20" monitor and it worked fine for months, then one day i turned of my computer then rebooted it and the monitor just flashes on for a sec then goes black but the light stays green.


It may be the back plane lamps, and or the back plane power supply that is in a failing condition. If in your model they are changeable, they should be changed together. \015\012\015\012You can verify this by turning on the monitor, feedi ... ViewSonic VX900 19" LCD Monitor

Samsung SyncMaster 215tw screen goes black after about 1 sec.


I have the same problem its defenitly a problem with the lcd monitor not with the graphics card nor the pc. I hooked up the digital and afterwards the vga connection both had the same result. 1 s perfect screen all visible but than black. pushing the ... Samsung 215TW SyncMaster 21" LCD Monitor

ViewSonic VX922 monitor - black screen - green power light flashes


PLEASE read Carefully so here is a fix for the green blinking light ...the monitor is going into shutdown....protect mode......THIS is ...Only for the seasoned electronic service tech ......YOU NEED TO BE into Electronics ..or have electronic backgro ... ViewSonic VX922 19" Monitor Flat Panel
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7441 seconds