Having problems with your Hanns.G Corporation HX191DP LCD Monitor ?

Monitor has just stopped working

\015 I have a Hanns.G HX191DP LCD Monitor, that has suddenly stopped working. nothing has happened to it, it was working fine one daya nd the next day it will not power on. even to the stage where the standby light appears on.\015\012\015\012I have tried various plugs and power cables from working screens which make no difference.\015\012\015\012any ideas??\015

Answers :

Repair Help & Product Troubleshooting for Hanns.G Corporation HX191DP LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cannot get new Motherboard to boot up in Normal Mode

What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

EMachine stopped displaying video (card not working, just mobo)

Hi there\015\012\015\012I would say it's the graphics card that's failed. You might get the same beeps for faulty card as removed card....\015\012\015\012Take it to a shop where they can test a compatible card, before they se ... E-Machines eMachines Desktop PC

My emachines EL 1200 desktop stopped working during bad storm

You can try to reset the computer by removing all power sources and letting it sit for a time. Then powering it back up and see what happens. That's called a hard reset. \015\012I am guessing that the storm surge damaged your motherbo ... PC Desktops

LCD monitor stopped working on my CPU but works on my Brother's

Definitely some electrolytic capacitors are blown inside the monitor in power supply module. Open it and observe any of them rounded on top, replace with proper ones.You see, controller operations with VGA and DVI inputs takes different current ... Proview PL913S 19" Flat Panel LCD Monitor

A Open monitors

Replace the power cords ... AOpen Computer Monitors

No DVi input, then computer goes to sleep

Hi publicworker, I had a similar problem whereas my monitor went to sleep mode after a few minutes. I'm running an HP LP 2065 in dual mode with another HP flat screen. However, I did resolve the issue after resetting the output settings. ... HP 2025 20.1" Flat Panel LCD Monitor

PF790 monitor picture issue

Was it dropped? If so, it could be a board crack or damage to the CRT.\015\012\015\012Was it stored in an unheated garage, shed, or attic, etc.?\015\012\015\012Damp air or widely changing temperatures can cause condensation on the circuit boards.\015 ... ViewSonic PF790 19" CRT Monitor

Screen Flickering on Acer 3680-2682

Ok we must remember when we setup any device on our PC, one of the many non PnP devices is and LCD Monitor, your PC should always be shutdown before installing a new Monitor. If you did not do this you could have damaged the I/O port on your PC. No ... Acer Aspire 3680 Laptop

Sceptre X7g Monitor Flashing Red & Blue Lights. Blank Screen

I fixed this problem by unplugging the monitor, unplugging the video cables. Then hold down the power button while plugging it back in. Release power button and then press power button for on. It worked then. I got the icon for no signal, i plug ... Sceptre X7GNAGAV 17" LCD Monitor

Computer boots fine but the monitor is blank

If the monitor works fine on your laptop, the problem definitely is at the computer, possibly with the video card (if it is using one). it could have loose connection, or parts might have damages. it seems the problem is intermittent so electr ... Computer Monitors

Screen not working on ACER 5315 laptop

First be sure you dont have an imput problem on your laptop while you are testing it.\015\012\015\012The input buton (swtich view) should be acessible via the Fn button and the F3-F8 on the keyboard (depends on your model) but it could looks like thi ... Acer Aspire 5315 Notebook

My monitor is stop working after 20 min workintg,

That sounds like somekind of overheating issue with whatever supplies the power to the monitor. ... Xerox XA7-17i 17" LCD Monitor

LCD Screen blinks on & Off at start up up-to about 10 minutes

Okay, forgive me if I go over covered ground but reading the post, I only see your responses, not what was recommended. From everything I've seen the problem lies in one of the following areas.\015\012\015\012\015\012 ... ViewSonic VX922 19" Monitor Flat Panel

My monitor is still working but has an odor coming out of the vent holes of back cover. This is a Fuji 19" LCD Monitor (Model: FP-988D) abut 2 years old. All features still seem to work but I have stopped using it due to the odor and suspected impending failure. Any suggestions??

It is normal for computer monitors to run hot and smell outof the vent holes. The question is how much and how bad.Under-sized power resistors on the circuit board often smelllike burned toast, this is normal. If the smell is ... PC Desktops

Inspirion laptop 1521. monitor stopped working.

Here is some info:http://www.inventgeek.com/Projects/shorts/lcdfix.aspxPersonally, I just replace the LCD with one from Ebay ... Dell Inspiron 1521 Laptop

Xerox monitor stopped working

... Xerox XG-71D 17" Flat Panel LCD Monitor

Dont get vidio at all see drives light up and can

Being able to open a cd or dvd drive only requires power to be going to that unit. The following assumes your monitor is working but is just not displaying anything.What you are describing sounds like you are having a hardware or BIOS iss ... HP Compaq Presario SR2013WM (RE468AA#ABA) PC Desktop

I have a Cornea 1702. It just stopped working altogether. It doesn't even show the menu nor does it search for a signal as it used to while scrolling thru options or select input! I think it's fried, but I remember some time ago i thought it was all done then it started working again. any thoughts?

OK, first off, I'd like to say that I've never worked on the Cornea 1702, but most monitors follow similar designs, especially generic brand monitors.So there are a few things I need to know: What exactly happens when you press the ... Cornea CT 1700 17" Flat Panel LCD Monitor

Connection to external monitor stopped working

Did you go to the display properties screen and check the settings of the second monitor connection. You must turn it on, and have it set to a low enough resolution for the monitor to work. If it shows the second monitor, Click Identify and it will ... Acer Aspire 5720 Notebook

F-17 neovo monitor stopped working. power light is flashing yellow

The power supplies in inexpensive monitors frequently blow capacitors, and during a certain period in the 2000's there was a capacitor blight due to a stolen formula for water-based dielectric compound that was flawed. Millions of electronic devices ... Neovo AG 17" LCD Monitor

Benq FP71G+S NOt starting.

Hello\015\012I have had this problem twice once at my school and once with my BenQ FP71G Monitor. At my school the monitor ( HP ) just stopped working and smelt like burnt popcorn.(though is think this is due to some kids chucking a soccer(foot ... BenQ FP71G 17" LCD Monitor

Well heres the story my sister made the screen fall on the floor one day (it fell on a very soft rug) every thing worked fine no problems but then a couple months later it started with this doesnt wana respond thing the little blue light just flashes but nothing on the screen i try restarting it i try pulling every thing out of the computer puting it back in taking out internal cards extra harddisk but nothing seems to work and then i start it up and it works for some weird reason but then when

Bamboboy, Stop yelling at your sister! ! ! If it worked fine after falling to the floor then there is something else wrong! First Prove that the pc works with a KNOWN GOOD monitor. Next, you may want to do the flashlight test with your BAD lcd monit ... Computer Monitors

My computer begins to load windows, then after the screen with the windows logo and bars goes away my screen goes black.

Nine times out of ten if that's when your display stops, it's simply because your display settings are set to something that your monitor can't handle. Depending on what it's not supporting, some monitors respond by going black ... others just ... Dell Latitude D800 Notebook

Flashing Green Light on mx705 monitor

If the HP has onboard video but you have an add-on video card, remove the add-on and connect the monitor to the onboard vid. If it works you have a bad add-on video card. If it doesn't or you are already running on on-board video hook the mx705 up to ... HP mx705 17" CRT Monitor

Monitor stopped working

It sounds like either a failing LCD or failing video card. I would probably take it to a compentent repair shop if it is out of warranty. If it is in warranty then you may have to deal with dell. \015\012You may have on-site service check what ... Dell Inspiron E1705 Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9473 seconds