Having problems with your Gateway PC Desktops ?

Gateway E-3200 no video signal

\015 Powers on, fan is running and lights are blinking, but no video signal output. Tried flashing the board like one person suggested, and replaced the RAM with a new stick, and still, i dont get a video signal to my monitor. Any suggestions?\015

Answers :

Hi! there,
\015\012 there are common factors why no video on your screen.,right one factor is ram,the other are video card,processor and monitor
\015\012you can't trouble shoot with out other computer available,tester cann't detected all this,it make easy to parts to parts.disconnect cd room,hardisk and floopy also disconnect your video card and memory card put video card and ram one by one (if youhave nultiple ran) to other computer ,be sure other computer is run good and observed, if no video take the previous video card and put back if there video,possible your video card is busted,or try to put other video card and ram to your pc be sure this are good,if ok select your own part that you think is busted since you said your ram is good,put back to your pc observed.....replace aby busted parts,
\015\012take all precaution avoid electric shock wear safety shoes.regards and have a nice day
Repair Help & Product Troubleshooting for Gateway PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Signal to monitor goes in and out, mostly out


Hopefully, it is just the on board video that has gone bad, and not the motherboard. When you install a video card on a PC, that has on board or integrated video, you will need to access the BIOS screen on start up and disable the on board video. T ... Gateway GT5220 PC Desktop

Gateway LCD powers on but has no picture


I have a Gateway FPD1730 LCD monitor. When I plug it into my Gateway 500x desktop the power light turns green and then says "Power Saving Mode" and then it goes black. It will occasionally flash on and have a picture and then go off. When I unplug th ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor

No Video Signal


If you can't use the onboard video and it does POST or the PCI-E video card does show anything, most likely the motherboard is toasted. Apparenty gateway uses real poor quality power supplie and motherboards.\015\012\015\012I have the sam ... Gateway GT5228 PC Desktop

Hello, I have a Gateway model GT5662, stock setup - Will not boot


Usually, if it's a motherboard that has a failed component on it, you will see failed Electrolytic Capacitors. The small aluminum 'Cans' on the motherboard.Note*The Electrolytic Capacitors that surround the Processor, should have sp ... Gateway GT5662 Desktop PC

Gateway E-3200 no video signal


Hi! there,\015\012 there are common factors why no video on your screen.,right one factor is ram,the other are video card,processor and monitor\015\012you can't trouble shoot with out other computer available,tester cann't detecte ... Gateway PC Desktops

Composite connection on Gateway Desktop


They are Video and Audio for connecting device together \015\012\015\012\015\012Yellow = Video\015\012White = Audio - left channel\015\012Red = Audio - right channel ... Gateway GT5453E Refurbished AMD Desktop Computer - AMD Athlon 64 X2 4200+ 2.2GHz , 1GB DD

Computer "turns on" i hear four to five beeps, but the monitor gets no signal. a friend gave me the computer, only once did i see it boot up fully but it froze up so i had to restart it and it wont work. everytime i try i get the same thing four or five beeps and monitor says no signal. so i dont know whats happening. its a gateway computer runing windows xp. thats all i know. i know the monitor is good cause i tested it on another computer.


Without knowing the exact frequency/length of the beeps my first guess would be a bad stick of ram or a bad video card. If there is more than one stick of ram in the computer try it with one of the sticks pulled, pulling each stick until it does boo ... Gateway GT5028 PC Desktop

Newer monitor to older xp pc


If your monitors are displaying "no signal" they aren't receiving input from the video card. If your PC has two video outputs (onboard) try charging to the other output to see if it will come on. Also reseat your video card in its slot. Also, what ca ... PC Desktops

No Video Signal


Try resetting the bios. On the motherboard there is a battery that looks like a watch battery. Remove the battery, then replace it again. (make sure the computer is unplugged from the wall socket when you do this)\015\012\015\012Does th ... Gateway GT4015E AMD Athlon 64 3500+ 2.2GHz / 1GB DDR / 200GB HDD / DVDRW DL / DVD-Rom / Flash PC Desktop

Monitor goes into power saver mode


Take your Agp card with you to the shop. You do not need to go through Gateway, but there are serveal formats of AGP regarding the voltages.\015\012\015\012By the sounds of it you have the newer version of AGP so finding a replacement car ... Gateway 500 X PC Desktop

Gateway E4100 PC


Remove your ram, reseat 1 stick ,then try it to see if you have a video signal. If not remove 1st stick of ram, try the 2 nd one. I have recieved a couple of Gateway Pc's that had no video output. Reseating the ram worked on both of them. ... Gateway E-4100 Special PC Desktop

My wireless does not work!How I can turn on again?


BASIC Wireless Troubleshooting Steps:\015\012Verify that the network adapter is being seen by the operating system: Check Microsoft Windows Device Manager and look for an icon that appears as Network Adapters and see i ... Acer Aspire 4520-5582 Notebook

Computer monitor flashes on then turns off


Try the monitor with another computer. If it works, the video circuitry (whether it is on-board or a separate adapter) in the Gateway is the problem and needs to be replaced. Otherwise, the problem is with the monitor itself. From your description ... Computer Monitors

Sony Vaio Wireless Problem


BASIC Wireless Troubleshooting Steps:\015\012Verify that the network adapter is being seen by the operating system: Check Microsoft Windows Device Manager and look for an icon that appears as Network Adapters and see i ... PC Laptops

Screen goes blank


Normal\015\012 0\015\012 \015\012 \015\012 false\015\012 false\015\012 false\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 MicrosoftInternetExplorer4\015\012 \015\012\015\012 \015\012 \015\012\015\012\015\0 ... Dell E173FP 17" LCD Flat Panel Monitor

PC STARTS BUT NO VIDEO SIGNAL IS PRESENT AT THE MONITOR


I was wondering if this person helped you ... Gateway 310 S PC Desktop

Gateway monitor (FDP1965) Power/video problem


You have a problem with your lcd..get it fixed by technicians... ... Gateway FPD1975W 19" LCD Monitor

Monitors won't work with Gateway Desktop


The video adapter has probably gone to it's reward. Some Gateways have the adapter built onto the motherboard. Some have separate video cards plugged into the motherboard. Pop the case open and check to see if the connector for the monitor is a ... Gateway PC Desktops

No video signal to Monitor.


Lack of video signal is usually 1 of 3 things, Power supply (PSU), Video card or Motherboard (mobo).Situation #1: If you get a blank screen and no sounds or movement it either indicates that the power supply unit (PSU) has failed or something o ... E-Machines eMachines Desktop PC

Got a 3347 modem from Netopia and ATT/sbc. We have a sonicwall tz170. We have bridged the netopia, but We cannot get out to the internet. We cannot take the sonicwall out of the loop, because the HP Procurve switch is expecting to talk with it, and getting it to talk to the netopia by itself will entail a whole other can of worms. we need help in configuring the netopia to allow access to the internet.


Hello sir,I didn't necessarily need to enable QoS when I was on 3 meg, but now that\015\012I've downgraded back to 1.5 once again due to financial strain (and\015\012since I'm not at home that much anymore), it's critical that I find a\01 ... PC Desktops

My 2 year old out of the box Gateway GT5220 boots up as usual but there is no video signal from the onboard video card. No modifications to this unit at all.


After verifying this issue with a second monitor, it would seem a new video card would be in order. As far as I cant tell this model has built in video, often referred to as integrated. therefore replacing the current video component will not work. ... Gateway GT5220 PC Desktop

I recently moved my computer into my new condo and have not been able to use it since. The problem seems to be with the monitor. I turn on the computer and the fan comes on but the monitor displays "no signal" and then goes dark but the light one the front still flashes indicating it is getting power. The last time I moved my computer from one room to another, the monitor suddenly couldn't/wouldn't display colors accruately - no red. Attempt to adjust the color by using the monitor's controls we


Lack of video signal is usually 1 of 3 things, Power supply (PSU), Video card or Motherboard (mobo).Situation #1: If you get a blank screen and no sounds or movement it either indicates that the power supply unit (PSU) has failed or somet ... E-Machines eMachines Desktop PC

No display the stand by light goes from orange to green the no signal dispay comes on then goes...but the display does not turn on. Tried a different monitor with the same video card and it works. What's the problem


Normal\015\012 0\015\012 \015\012 \015\012 false\015\012 false\015\012 false\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 MicrosoftInternetExplorer4\015\012 \015\012\015\012 \015\012 \015\012\015\012\015\0 ... Neovo E-19A 19" LCD Monitor

Gateway mx3222b laptop ram upgrade problem


Your computer does not support 1GB memory sticks. The max memory for that system is 1GB which would be 2 sticks configured as 512MB\015\012\015\012see below for the specs (i bold, italics and underlined the main part)\015\012\ ... Gateway PC Laptops

Screen just showing white.


This is definitely a problem with the monitor ONLY. The fact that you don't even see the Gateway splash sign when you power on the monitor or even the symbol indicating, which source you are using is very telling.This sort of problem usua ... Gateway HD2200 LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3178 seconds