Having problems with your Gateway FPD1975W 19" LCD Monitor ?

BLUE LIGHT BLINKS BUT MONITOR SCREEN REMAINS BLANK

\015 THIS STARTED AFTERI TEMPORARILILY WHILE IN USE PULLED THE MAIN PLUG AND THEN .THE MONITOR WWAS RECONNECCTED BUT NOT WORKIG WITH COMPUTER,PICTURELESS ANF A STESADT FLASHING OF THE PLUE MONITOR ON LIGHT IE BLINKING'IK SUSPECT THJE PROBLEM IS IN THE ANTI THET DEVICE BUTR CANNOT RERSTORE ORDER\015\012PLEASE HELP\015\012MODELfpd1975w\015\0127010676r\015

Answers :

The monitor is probably on protection.

To start unplug monitor\015\012from power and from computer and test computer with different monitor\015\012to find out if it is monitor or computer fault.

If it is computer fault and no video signal , then test:

\015\012
    \015\012
  • Video cable.
  • \015\012
  • Video adapter on PC (sometimes integrated on motherboard)
  • \015\012
  • Motherboard.

If it is monitor fault , then the monitor is on protection.

When on protection you keep having a flashing\015\012led on front of the monitor , and monitor turning off by itself after a while,\015\012that indicates a fault condition.

The flashing light indicates a diagnostic state called protection.
When the Monitor goes on protection there are only two possible causes.

1The\015\012internal circuits are jammed because of electrostatic\015\012charges accumulating on capacitors, or because of a wrong voltage read\015\012by the main chip on your monitor controller board. this started the\015\012protection circuit.

2 The protection circuit detected a wrong\015\012voltage or a broken contact, identified an internal fault and kicked in\015\012, starting the flashing light.


If\015\012you are in situation one, then the monitor will reset just unplugging\015\012power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

Common\015\012faults\015\012that can occurr are a blown capacitor on power board, faulty inverter\015\012board, faulty input board, or a fault on LCD Digital Controller board.

Check also\015\012the video cable or any external connection cable, if the cable is shorting, or the connector is bad, you\015\012can get same flashing state because of the video cable.

Try moving the video cable, and if the cable is not built in, then also try a replacement cable.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.\015\012\015\012
Repair Help & Product Troubleshooting for Gateway FPD1975W 19" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

BLUE LIGHT BLINKS BUT MONITOR SCREEN REMAINS BLANK


It's probably because your caps lock is on. ... BenQ FP731 17" LCD Monitor

Dell172fpb 17" monitor


Self-Test Feature Check (STFC)\015\012Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark, run ... Dell E171FPb 17" Flat Panel LCD Monitor

LG1717S - Power light flashing - no image.


The monitor is probably on protection.To start unplug monitor\015\012from power and from computer and test computer with different monitor\015\012to find out if it is monitor or computer fault.If it is computer fault and no vi ... LG L1717S-BN 17" LCD Monitor

BLUE LIGHT BLINKS BUT MONITOR SCREEN REMAINS BLANK


The monitor is probably on protection.To start unplug monitor\015\012from power and from computer and test computer with different monitor\015\012to find out if it is monitor or computer fault.If it is computer fault and no vi ... Gateway FPD1975W 19" LCD Monitor

Lg2234s monitor goes of blinking...cant turn monitor off (blue light remains off) then monitor turns on ..screen pic returns but is totally green, the OSD becomes garbled, if set to return to default then everything becomes normal, using osd buttons also blanks out screen and blinking of screen occurs again..osd is all garbled even if pc is switched off.


Emale36, Could be problem with the "switch-mode-power-supply" inside the unit. If dc voltage rail is noisey or marginally on the low side of rated specification then strange things will start to occur on screen. Contact LG (Lucky-Goldstar) if unit ... Computer Monitors

Possibly Video Card problem?


Mikolan,That is so crazy.You say you previously was able to see the POST screen and now you can't?You say you switched monitors and card outputs to no avail? Is the card an ATI with an aux Molex power connector?Is the pu ... PC Desktops

Viewsonic VG2230wm 22 Blank screen


Look for bad caps in the power supply first, see example of failed VIEWSONIC monitors due to bad caps here: http://s807.photobucket.com/home/budm/allalbums ... Relisys RLT1720 17" LCD Monitor

Dell E173FP Screen blinking red, green, blue, white


The monitor is probably on protection.To start unplug monitor\015\012from power and from computer and test computer with different monitor\015\012to find out if it is monitor or computer fault.If it is computer fault and no vi ... Dell E173FP 17" LCD Monitor

The power light blinks solid blue every four seconds or so (it?s off in-between). The screen is blank. None of the buttons on the side function (such as ?menu?). I have a second similar monitor from the computer in the other room I?m using to type this proving the video card and cable are fine. We?ve always (as in years) left the monitor on (w/ a screen saver) but for whatever reason turned it off for four days when we went away recently. The monitor would then not turn back on. After leaving th


Hello,\015\012Two days ago I received a Gateway 900w FDP1975W Monitor from a friend. He told me that he would have to let it rest and it would work for about a hour or so and flash green with lines, then Flashing blue power light, then nothing. ... Gateway FPD1975W 19" LCD Monitor

HP L1706- screen is blank when I switch on


First if you have a extra monitor try to plug it in and see if it works. If not then check your video card. or get into the computer and try and remove and reseat the memory. Sometimes by just doing that can solve the problems ... HP L1706 17" LCD Monitor

Blue power button flashing with blank screen


This is most likely the power inverter board in the monitor - this is common in many monitors. If it started taking longer and longer to display an image, and the power light is blinking on-and-off, that's the problem. You can confirm that it's the ... Dell E173FP 17" LCD Flat Panel Monitor

Screen is blank.


Could have blown some capacitors inside the monitor.I just fixed one today that had no power, the blue ring around the power button didn't even light up when plugged in.I open it and found 3 bulgingcapacitors on the power/inverter board. ... Samsung SyncMaster 932B LCD Monitor

Blinking blue light


You have to\015\012check if you can see the image on the screen or not after it went blank (Power on both CPU and monitor) by shining a flashlight into the\015\012screen, not di ... Samsung SyncMaster 930B 19" LCD Flat Panel Monitor

Monitor Display Problem.


The first Polyview has a power supply problem (a short) and locks out the power until it is unplugged. You need to check the voltages inside the Monitor to determine which component/s are faulty. I hope you know electronics if not leave it to the r ... Polyview V17E 17" LCD Flat Panel Monitor

SVA Color TFT LCD is white on start up but goes blank.


When i turn the computer on the light on the monitor blinks green but i cant get it to turn on..i have a black screen. ... Computer Monitors

Princeton VL1919 Monitor blinking blue light


... Computer Monitors

No picture LED Flashes


I just did this to a friends monitor as well, a different model and not much different in build. I think you might have 3 screws on lower back side of cover. Start your separation from the bottom of the frame.Your power switch will remain on the fron ... Samsung 226BW Monitor

Blank Screen Viewsonic VG2230wm 22" monitor. For the last few weeks I have been noticing that when I turn the monitor on it would bllink and go out. When I turned the montitor off and on again it would work fine. Then while in the middle of working on my computer the screen went black. I noticed that the blue light was still on, I turned the monitor off and back on but the screen remains blank. I shut down the computer and the monitor and let them set for a few minutes then turned them back on.


Common problem in monitors are bad caps in the power supply, that is the first place to check, look for bad caps with bulging top/bottom, see example of failed VIEWSONIC monitors due to bad caps here (worst case will be bad lamps): ... ViewSonic VG2230WM LCD Monitor

Front panel lights blink on/off once per second


Hey,\015\012 I would like to agree to the diagnosis that you have done on the monitor . Thanks for a well complied solution. You can try the following website\015\012 ... Dell UltraSharp 2005FPW 20.1" LCD Monitor

PC or monitor, signal problems


Your monitor is telling you it's on it's last legs..either that or your compaq has a bad video section. either is more vital than a video cable being loose. ... PC Desktops

The monitor doesn't power on properly


You can have bad capacitors on your power supply. ... Computer Monitors

Syncmaster 2232gw led blinking.


Change the screen resolution. The video card or video display may not be compatible to the supported video setting of the monitor. Try changing the video resolution to a lower setting such as 1024x768 and bit depth to 32 bit. ... Computer Monitors

Black Screen with Blinking dash on upper left corner


Are the xp disks specific for that computer. The reason I ask is because when you changed the hardrive none of the components on your computer know what to do because you won't have any drivers. Does your hard drive lights come on? D ... HP Compaq nc6400 Notebook

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Monitor Screen goes black every few seconds!


Check the capacitors on your monitors circuit board. If they have opened up at the top, they are fried. Buy new ones, make sure nothing has leaked from the old ones, and replace them. ... Dell SE198WFP LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8454 seconds