Having problems with your Gateway 507GR PC Desktop ?

My monitor wont come on it says it has no signal i turn onpc but monitor is blank


Answers :

First open cpu cabinet then REFIX RAM memory.
\015\012Pull cmos cell for 10 minutes then all settings are defaults.
\015\012.
\015\012Then reconnect vga cable from your monitor to cpu vga port.
\015\012Then when you power up press continue F8 key so you can see safe mode and other menu then enter in enable vga mode then go to control panel then dispaly property then settings then change screen resolution to 1024*768 then apply and ok.
\015\012Then restart and check .
Hi Lily

Your monitor is on, the PC is not sending it anything.

Check that the video cable is properly attached to the PC.

Best regards,
Mike
Repair Help & Product Troubleshooting for Gateway 507GR PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Viewsonic monitor lcd to laptop problem


... Computer Monitors

Cant get it to turn on/ panasonic CF-51 toughbook laptop.


Here are some troubleshooting hints, see if these will work for you. It is hard to knnow what to do in these situations because there is no way of telling what key combinations etc. were hit.\015\012\015\012 ... Panasonic Toughbook CF-51 Notebook

Blank screen Help. I have a compaq presario sr1103wm. When I turn on the computer the monitor acts like it is getting no power. Also the keyboard lights don't come on. I tried replacing the video card and got the same results. I also tried a different monitor and cable with still the same results. Does anyone have any sugestions. Could it be the mother board?


When you say "When I turn on the computer the monitor acts like it is getting no power", do you mean the light on monitor doesn't come on or it does and it states it has "No Signal"? If it says no signal then it is receiving power just no signal from ... Compaq Presario SR1103WM-B (PC183B#ABA) PC Desktop

Problm with viewsonic va712b


Sounds like the operating mode is at a frequency or refresh rate that is outside the viewsonic operating specifications when in normal mode. possible solution: in safe mode access control panel, system, devices (hardware) and look for display. do a r ... ViewSonic VA721 17" LCD Monitor

NO SIGNAL What do I do?


These messages are normal when the computer truly goes into suspend mode or loses the video signal (such as when the computer is suddenly turned off).If the monitor displays any of these messages when the computer should be displaying vid ... HP PAVILION A6230N DESKTOP PC

RGB No Signal Message


First you need to check the cable at both ends, inside and out. Make sure it is plugged in, to the proper connector and that there aren't any bents pins. Now put this monitor on another computer, a laptop will do. Does it come on now? If so then ... Gateway FPD1975W 19" LCD Monitor

A mind of its own


Check the cmos battery and the power suply. lok for swollen compassitors ... PC Desktops

My monitor wont come on it says it has no signal i turn onpc but monitor is blank


First open cpu cabinet then REFIX RAM memory.\015\012Pull cmos cell for 10 minutes then all settings are defaults.\015\012.\015\012Then reconnect vga cable from your monitor to cpu vga port.\015\012Then when you power up press ... Gateway 507GR PC Desktop

Power outage,monitor wont power up,hope its not fried


I may or may not make your day. (But I wish you to know that I want to! lol!)I believe it's not your monitor, I believe it's your computer. (Oh, that helped, huh!) However, don't freak out yet, it maybe a simple fix.Let's test ... Gateway FPD2275W LCD Monitor

Monitor does not come on when powered on, it says no input signal


Check your video card. It sounds like it has went bad. Hope this helps. ... Gateway 420GR PC Desktop

Monitor status - no input signal. What does this


The problem might be coming from your video card or try changing your RAM ... HP Computer Monitors

Fujitsu c series labtop screen goes blank, the hooked up to a monitor, starts to work then says out of frequence and goes blank


The video resolution and/or frequency that's set in windows is not supported by the monitor you have plugged in. Restart the PC in VGA mode (hit F8 after the BIOS messages but before any Windows messages) and change the video settings to something ba ... Fujitsu LifeBook C6555 Notebook

Blinking green power light and monitor doesn't work


... Acer AL1714CB (Black) 17" LCD Monitor

Wont go to normal start up screen!!!


The screen that you're seeing is the self-test of the monitor, as it's already stated. It's commonly caused by having no signal coming from the computer to the monitor. You were advised to check the monitor cable, if you have already done that, then ... E-Machines eView 17f3 17" Flat CRT Monitor

Monitor says no input signal


Do the icons look ok when you can see them? It sounds like your resolution may be way too high for the monitor. It loses sync and blanks the screen rather than show a lot of mess.\015\012\015\012Boot your windows in safe mode (tap F8 befo ... PC Desktops

Computer or Monitor problem?


Seems like you have a bad motherboard. Try a different keyboard, mouse, and VGA cable, and see if it works. I fnot then you deffinitely need a new motherboard. ... E-Machines eMachines Desktop PC

Monitor comes up shows "acer" then says no signal and goes black


The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor

The power light blinks solid blue every four seconds or so (it?s off in-between). The screen is blank. None of the buttons on the side function (such as ?menu?). I have a second similar monitor from the computer in the other room I?m using to type this proving the video card and cable are fine. We?ve always (as in years) left the monitor on (w/ a screen saver) but for whatever reason turned it off for four days when we went away recently. The monitor would then not turn back on. After leaving th


Hello,\015\012Two days ago I received a Gateway 900w FDP1975W Monitor from a friend. He told me that he would have to let it rest and it would work for about a hour or so and flash green with lines, then Flashing blue power light, then nothing. ... Gateway FPD1975W 19" LCD Monitor

Monitor won't stay on. Error message comes up that says "no input signal", then monitor goes out.


Problem with the monitor, monitor cable, or video output. For monitor, if you have more than one input, make sure it's set to the correct one. Try a different cable. Try a different monitor. Check your video card settings--if you see the BIOS boo ... HP PC Desktops

Dell 2407WFP Monitor losing signal and having colored line artifacts


... Dell UltraSharp 2407WFP 24" LCD Monitor

Blank screen upon startup


Try taking out the hard disk, plug in power and see if you have a display on your screen or external monitor. if same thing happen, try taking out the memory card. If you hear a beep sound it's a faulty mem. card, if no beep sound appears I suspected ... Lenovo ThinkPad T61 Notebook

VX900, Backlight Works, But no picture.


It is impossible to see defective components visualy, unless there was a serious burn-up or something like that. \015\012\015\012Without at least a DVM you cannot even verify if the power supply is functioning properly!!! \015\012 ... ViewSonic VX900 19" LCD Monitor

Monitor comes up shows "acer" then says no signal and goes black


This Problem is Acer(s) Monitors. Though it is a nuisance one fix That has work for many is the Unplugging after it goes back to Good (viewable) screen. I have hooked mine up to an inexpensive Power strip to make it easier for me and just turn ... Acer X241Wsd Monitor

Dell computer monitor wont come on when I turn


When you turn on most dell monitors they come on with a yellow light, then turn green when the monitor and video source synch. If your light is not turning from yellow to green, your monitor is either dead or not getting a signal from the video sour ... PC Desktops

Screen comes on briefly then blanks out.


Check inverter, memory, and powersupply. ... HP w1907 LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9417 seconds