Having problems with your Fujitsu Siemens Celsius R610 PC Desktop ?

Configure SCSI hard-drive jumpers

\015 Two problems. 1) My Fujitsu Celsius R610 reboots immediately I turn it off via the sceen controls 2) I want to add another SCSI drive but I can't get a clear idea of how to set the jumpers. A '3D' diagram would help.\015

Answers :

Set one the master and the other slave to the master .that should work.
Repair Help & Product Troubleshooting for Fujitsu Siemens Celsius R610 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dell Poweredge 4300 Bootup problem after cmos battery replacement

Check the version for the Raid Controller. This may need to have the firmware to be upgraded. If the controller is removable, take the controller out and then see if the computer will continue past the bios. If the controller is built-in, then disabl ... PC Desktops

What kind of hard drive do I need for an acer aspire 4315? From what I have found it needs to be 68 pin, is there anything else? I have replaced a few hard drives and this is an easy fix (much easier than digging into my Thinkpad and replacing the power jack!!). I am just not familiar with this model, she brought it over with her from the Phillipines.

A hard drive with 68 pins is a wide SCSI-3 hard drive device.\015\012SCSI drives need a SCSI controller (eg in this case an Adaptec SCSI-3 controller) and the SCSI ID of each hard drive can be set from 0 to 7. The ID setting on the hard drive i ... Acer PC Laptops

Installed a new Optical Drive and require assistance in the wiring

What kind of optical drive? Is this a CD, DVD?, Blue ray,or an opto-ferro-magnetic floppy?Generally:1) External drive: ============ a) just power it up and connect it to the PC using an USB or ... PC Desktops

My Computer did not access Western Digital Hard Disk, Model No. WD 1600 AABB Caviar SATA.

Good morning! Please make sure that the drive’s power and SATA cables are properly connected. If the Serial ATA host adapter card is installed in a 64-bit PCI slot on the system motherboard, move the card to a 32-bit slot.\015\012 ... PC Desktops

Drive failed to boot up next time it was turned on have tried conncting as a slave computer recognises drive but say its 138mg when its 40gig, and there is nothing showing on the drive! have tired running Seatools for windows and all the test say there are no problems with the drive. I have in stall a nerw 250gig drive (Seagate) with NTFS file system and the problem one is a Maxtor with fat file system .

Hi silverend,I have some questions and some recommendations for you...The original problem of the system not booting might have been temporarily compounded by moving it to a different system as a secondary or slave disk. You' ... PC Desktops

Trubleshoot Motherboard what is mother board prob and how can find n fix them....

More than 70% of all computer problems are related to cabling and connections. Ensure all cables are connected and connected firmly. IDE and floppy ribbon cables and power cables can often go loose. Ensure microprocessor, memory modules, and adapters ... PC Desktops

Hard drive problem

Although I covered most of the ways to speed up Windows boot time in another article, I encountered a unique roadblock recently that made me write this article. During the last week I was asked by a customer to upgrade one of their office ... PC Desktops

After formatting my pc is unable to run

Note: Some of these steps may require you to access windows via safe mode. If that's not possible then skip those steps.\015\012\015\012Restart your computer if you haven't already done so. The STOP 0x0000007B \015\ ... PC Desktops

I have a dell 4600 that I got from my daughter . which I had to re-install and It has a password in the bios for the set up and my daughter dont know

\015\012 \015\012Hi katmbutts;\015\012 \015\012 \015\012Before attempting to bypass the BIOS password on a computer, please take a minute to contact the hardware ... Dell Dimension 4600 PC Desktop

Configure SCSI hard-drive jumpers

Set one the master and the other slave to the master .that should work. ... Fujitsu Siemens Celsius R610 PC Desktop

How many hard frives can be installed

You can put as many drives as you can fit as long as you have the cables and connection. Usually 4 is the max in a computer, but you can by a SCSI IDE card and add even more. The biggest problem is to make sure that the jumpers are set to slave on ... Dell Dimension 4600 PC Desktop

My computer will not read any of my disk or install

When you say disk did you mean hard disk? if you do... did you recenlty install a new hard disks?... if you did... did you check the jumper-master-slave configuration when installing the new hard disk? \015\012only one hard disk can be configur ... HP PC Desktops

New HDD Install Prob

Basic Troubleshooting Tips after Installing a New Hard DriveBased on Seagate IDE hard drives.If you have installed your drive and it does not function properly, perform the following basic checks:Additional Troubleshooting Tip ... PC Desktops

Driver needed for TSST Corp CDDVDW TS-H653N SCSI CdRom Device please. DVD drive shown in My Computer, and MS says I have the correct driver for this device. But, it doesn't work.

If the computer still cannot read a disc, there may be a problem with the drive. Go to method 3 to troubleshoot the CD or DVD drive.\015\012If the computer can read the other disc, there is a problem with original CD or DVD. Contact the manufacturer ... Compaq PC Desktops

Installation of a 2nd hard drive steps & tips

Step 1: Back up and scout around\015\012 First,\015\012back up your critical files (don't forget your Outlook .PST archive) to\015\012optical discs, an external drive, or online storage. Then check whether\015\012a CD comes with t ... HP Pavilion a1410n (ER890AA) PC Desktop

I have a maxtor 6L080M0 hard drive that has crashed The return code is 7 Is there any way to fix this problem.

If the following determines you have hard drive failure then you may have to purchase a new HD. Follow what is recommended from the manufacturer below. READ EVERYTHING.\015\012\015\012According to Seagate the makers of Maxtor, you have a ... PC Desktops

Hi i have a 10.1gb Maxtor model 31024H1 IDE hard drive and i need the jumper setting for slave

Slave is NO jumpers at all \015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012(Master) - The vertical jumper over the J50 pins is configuring the drive as a Master. The horizontal jumper over the J48 and J46 pins ... PC Desktops

How can I repin a hard drive so I can download information?

Dear Rorange, to copy data from your your old hard drive to new one, you have to change their config. you should have to make ,Your new Hard drive as master hard drive and old one is Slave, through Jumper configuration, th ... PC Desktops

Cannot Boot up Computer: sends me to the bio screens

I presume you know how to get into the BIOS, but you don't say if this is a new drive being replaced or a second drive being added etc., but I'm guessing that you don't have the drive configured correctly. There are three jumper positions on most ... Sony VAIO PCV-RS530G PC Desktop

Trying to add another internal hard drive to Dell Dimension 3000

Leave the cable connection as it is. That is, one ribbon cable for the 2 dvd drives and the original cable for the old hard drive. You dont need to set the jumper on the second hdd. It has to be set to 'cable select'. Then make sure to connect the se ... Dell Dimension 3000® Pentium® 4 2.8GHz, 256MB, 80GB, 48x CD-RW PC Desktop

Monitor reads: PC entering power saving mode then shuts off;PC on

First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

Issue Installing 4th Drive Device (2 DVD Drives and 2 Harddrives)

You cannot plug an IDE ribbon in the floppy slot (port). The total IDE drives you can install is four (4). But check your jumper configuration. The DVD & DVD/CD-ROM cannot have the same jumper configuration to share the same IDE slot. One has to ... Dell Dimension 5150 (DIM515MIN) PC Desktop

Bios Fail to detect Local Disk C and DVD-RW - Computer Speakers

I'm going to make an assumption here and guess that you have both hard drive and cdrom plugged into the same IDE cable. I think you have either 2 masters or 2 slaves and that is why the bios can't see them. On any one cable you can have a master and ... Computer Speakers

Highest Priority Problem: HDD moved from old machine works but is physically damaged . Trying to clone/ recover using DataLifeguard and Acronis. Been trying for days and always fails although the damaged drive will still start windows. The bios is showing my SCSI as primary and HDD or DVD as secondary depending on jumper config but it will still boot to drive not showing in bios. I finally got it to boot with DVD removed and old/new HDD on IDE cable (showing SCSI (with no MBR) as master and slav

If the hard drive is physically damaged , that means that hard drive motor has blown, or that drive heads are broken.\015\012\015\012In that case you cannot use such software as DataLifeguard and Acronis, and you risk that your SC ... IBM eserver xSeries 232 8668

Netfinity 550 in the cmos config, it doesn't recognize the drives. I was recently hired and unfamiliar with this old machines configuration and scsi technology. either: i. drives are all dead and need data recovery ii. planar and/or scsi adapter are dead and need replacement iii. something else is wrong and maybe somebody with prior experience may suggest something that I have overlooked anything is welcome thanks I have an IBM netfinity 5500 server. I am running sco 5.0.5 on it but it cannot re

HiThe error message you are receiving "Inquiry command failed Using IBM-PC ServerRaid Host adapter" makes me think you are attaching the tape drive to the ServerRaid Controller, which is only for Hard Disks. There should be a normal SCSI ... IBM Netfinity 5500 M20 4RY (86624RY) Server
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5816 seconds