Having problems with your eMachines D3415 PC Desktop ?

Nothing on my Emachines computer will turn on.

\015 It was sitting for two years, and I just replaced the power supply today. I plugged everything in, and nothing will turn on. No fan, no green light on the motherboard, nothing.I think that the power button may be broken, but I can't be sure since everything's plugged in and the motherboard still isn't turning on.\015

Answers :

I would recommend rechecking your connection to the motherboard. All wires from the power supply to board and making sure the front panel switch connection are correct. Also, make sure the power supply is compatible to the motherboare. even though a 20-Pin ps will connect to a 24-Pin board, it still does not work. Good Luck
Repair Help & Product Troubleshooting for eMachines D3415 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

CD drive not working

Based on your indication the CD drive is clean, and you know the cables are attached to it, inside the computer. (Flat ribbon IDE interface cable, and 4-pin Molex connector power cable)1.Go to Device ManagerLeft-click on Start ... Sony VAIO PCV-RX462DS PC Desktop

Weird blink problem...

That's definitely a hardware (incompatiblity) problem. Download the most updated driver for the graphics card. Also see if there is a monitor driver for the monitor.I understand it worked seamlessly for the emachine but you should switch ... E-Machines eMachines Monitor E15T4

My monitor goes to sleep mode at startup & can't access safe mode

Turn the computer off, open the case and remove the RAM. Does the computer beep when you turn it on with no RAM? If not, your motherboard is dead. If your computer beeps, turn it off again and try putting one stick of RAM in. If the co ... E-Machines eMachines Desktop PC

EMachine will not turn on.

Sounds like the power supply is faulty. Power supplies are very dangerous to try and repair, even for qualified technicians. I would also suggest not trying to plug it in or turn it on until the new power supply is in place. Faulty power supplies ... E-Machines eMachines Desktop PC

Monitor reads: PC entering power saving mode then shuts off;PC on

First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

EMachine Model T3828 No power

Greetings! As the first answer suggests, you must be comfortable taking things apart. I've actually just finished diagnosing the same problem on a customer's computer, and Here's what I did.First, I remove the power plug, open up the co ... E-Machines eMachines T3830 PC Desktop

Trouble starting up computer

First thing to do is remove as much as you can from the motherboard, cdrom,some memory(if possible) floppy drives ect...any slot cards then try it and plug each item in and reboot each time till you find whats causing it. or could be a week pow ... E-Machines eMachines Desktop PC

Unmountable boot volume

Hopefully you have a windows installation cd or a recovery cd. If you do then you need to install it into your cd rom drive. Reboot the computer and you will see a message that says to press any key to boot from CD. If you do not get this message and ... eMachines EL1600-01

EMachine T3958 Won't start - Please help

The green LED indicates that the standby voltage is present which is what provides the power so the front button can tell the unit to turn on fully.\015\012At that point, there are 3 possibilities; the power supply has a fault and won't turn on ... E-Machines eMachines Desktop PC

EMachine T3406 wont boot

Is there a post beep when the pc is switched on. check the memory if it is a beep beep beep sound , also disconect the hard drive, dvd drive, floppy, and any usb devices and see if it boots up. if that fails it does seem like the mother board, also c ... E-Machines eMachines Desktop PC

After installing hard drive, monitor, keyboard, mouse not working

Have you tried to enter BIOS? Are you able to enter BIOS?? There may be an option you have to hit to enable SATA, and to select the boot device order, which may be messing things up.Also, remember that STATIC ELECTRICITY is your enemy! Groun ... E-Machines eMachines Desktop PC

EMachine 2862 Desktop Dead On Power-Up

Check all the leads to the hard drive and check that the fan starts spinning when you switch it on if it dont start then the problem is the switch these do often go and can be easily replaced and they are not expensive i had the same problem and foun ... E-Machines T2682 (000002965) PC Desktop

Emachine problems My emachine is a couple of years old. It has always worked great until this weekend. When you push the button to turn on the computer, the fan starts going fast and loud, but nothing else happens. The fan will stay on until we shut the computer down. The moniter is not showing a connection to the pc as well. Please let me know if you have any ideals.

My emachines is couple of years old but has ran great until now. We had a power outage and ever since then it will not come on, there is nothing. I have replaced the power supply and the mother board and still nothing.Could it be my processor?? model ... E-Machines eMachines Desktop PC

Emachine boots to bios with a new hard drive installed

A computer cannot boot straight to the bios, unless under 2 circumstances. First, the jumper on your motherboard is not set into the right location. (If you never mess around inside of your computer, this shouldn't be an issue...) The only other way ... E-Machines eMachines T3830 PC Desktop

Cpu turns on but nothing else does.

Well, when my emachine did this, I was informed the "power toggle" was "gone" and that basically it would cost more to fix than to replace. I suggest you have this looked at as I suspect you will be given similar information. Wish I had better ... E-Machines eMachines Desktop PC

Mobo problems Hi all , I have a T2824 that will not turn on. When i open the case to inspect it i found a little light on. The location of the light is just above F-1 ? I not sure if its a powersupply or motherboard any help would be nice. P.s I have googled it for an hour and still nothing ? Spex T2824,Windows Home,2.53GHz(intel 325), 40g hard drive,combo Dvd drive,256mb DDR SDRAM. Again when i turn it on NOTHING happens ?? No fans no harddrive just one little light ???

I have the same computer (emachine t2824) and the same problem but my computer there are no funs are on, no exterior light on, the only light on is this green light on the montherboard between where the cpu is and the ram slots. and one more thing i ... E-Machines (T2824) PC Desktop

My Emachines Desktop W5243 works sometimes and others just beeps

You might be having a minor dust particle situation going on. Take the memory out of the system. Get a can of air and blow out the slots on the motherboard where the memory would normally go. Then take the can of air and blow the connectors on bot ... E-Machines eMachines Desktop PC

Emachines single beep

It may be necessary to enter the BIOS setup to disable the integrated video and/or turn on the PCI slot(s).\015\012\015\012It varies but entering the BIOS setup uses one or more keys (sometimes Esc, sometimes F1) that are pressed right after po ... Dell Dimension 4300S (Refurbished) (4300SB8BZ411) PC Desktop

Emachines model T1862 WILL NOT START

Do any lights come on, or any activities? It is possible that your power supply has bummed out from old age or either powercut and surges , you need to open the tower(box) casing and check wat happens when you turn it on,if nothing happens then you ... E-Machines T1862 PC Desktop

My pc beeped twice and nothing came

Lack of video signal is usually 1 of 3 things, Power supply (PSU), Video card or Motherboard (mobo).Situation #1: If you get a blank screen and no sounds or movement it either indicates that the power supply unit (PSU) has failed or somet ... Dell Dimension 2400 PC Desktop

T2085 will not turn on

It is fairly easy to replace the power supply, a few screws to remove the power supply then it is just a matter of unplugging all the power connections from the old one, swapping out the supplies and matching the power connections up with the s ... E-Machines eMachines Desktop PC

T6532 emachine doesn't start up and fans run @ hyper speed

I suggest you open it up and check for bad capacitors. I have a T1742 right now that I am replacing capacitors on. They're round, a little bigger than a pencil, less than an inch tall and the ones you will be looking for are close to the microprocess ... E-Machines eMachines Desktop PC

Emonster 550 wont load operating system wont read disk nothing can you help me please?

Go into the BIOS (watch your POST screen as you turn the computer on for instructions if you don't know how to get in there, it will say something like "press F2 to enter setup") and set your computer to boot from your CD drive. Put your restore or ... Dell PC Desktops

Emachine 180 (bought 2004)

I have this type of computer (just sitting around , not for my main computer) and I had a smilar problem. I took it to a guy I know (who owns a computer repiar shop) an he said the motherboards on this model go haywire about four years after initial ... E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

Weird power issue...I think.

Check if cpu is getting hott ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7514 seconds