Having problems with your eMachines D3415 PC Desktop ?

Emachines won't turn on

\015 Emachine was working fine; powered down and turned it off; now it won't turn back on. The light on the motherboard is on; but when i push the switch nothing happens - no fan; no access to hard drive, etc. I've already replaced the power supply.\015

Answers :

Remove the processor,ram for 30min and put them back
Repair Help & Product Troubleshooting for eMachines D3415 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My emachines wont turn on

Also in addition to the above, try reseating the ram chips..take them out individually and plug them back into their respective slots..might be the miracle cure..If the motherboard fan turns on, it might just be bad memory..replace RAM chips ... E-Machines eMachines Desktop PC

Computer wont turn on

Hi\015\012Bad news. your motherboard has been fried. You could try refashing the BIOS but I've got $10 dollars to your one that it wont work. Best bet - keep the tower, keep all of the running gear but a new motherboard and prosessor are in ord ... E-Machines eMachines Desktop PC

Emachines pc help plz

Besides MSN, what else can you not do? ... E-Machines eMachines Desktop PC

When i turn on my emachines 420 at the mains, the led power light comes on, but it wont do anything else including turning on or off

Hello there,this sounds like a problem with your power supply unit inside the computer,emachines are always blowing there power supply because the one that comes with the computer just is not powerful enough.If you are confident enough around electri ... E-Machines eMachines Desktop PC

Gatweway lap top button light up, but wont turn on

I'm afraid this sounds suspiciously like a motherboard problem. It would help to know what model etc, as some Gateway & EMachine model laptops have had extended warranties due to motherboard issues, or just go to Gateway.com and research it yours ... PC Laptops

Wont power up

Ok, the best actions here will be to purchase the correct power supply unit. you can order your unit online or , you can purchase it, via best by or office depot. this current supply unit may not have the correct ratings for your unit. if so, it will ... E-Machines eMachines Desktop PC

I got an emachines w3650 it wont power on i don't know really anything about computers but i opened the side of it to look in side and saw a wire with P6 written on it hanging and not plugged into anything. should that be plugged in to something? could that be y the comp wont turn on? any ideas or suggestions i would appreciate

In the most basic system setup the power supply will have two wires power the motherboard, one for the CD/DVD drive, and one for the hard drive. there will be extra ones for future upgrades...i.e.2nd hard drive/DVD burner and so on.... On my PC there ... PC Desktops

Emachine T5062 pc wont turn on, I get 5 beeps When the computer performs the ''Power on system test''. I could not remember what BIOS the computer had but I think It was AMI. The five beeps for AMI mean that its Processor failure: The CPU has failed this is the site i used to check the beeps http://kb.iu.edu/data/afzy.html I did vaccum the inside is the pc because it was really dusty and i removed the hatsiins for the CPU, I tried to reinser it but Im sure I put it back on right any suggestion

Make sure it is not getting really hot, also try cleaning all again and start putting them together step by step. make sure the dust didn't got in another part like RAM memories slots, and if you have a big problem with the processor the PC wouldn't ... E-Machines eMachines Desktop PC

The lights are on, but nobodys home

Im having the same problem with mines, so im on my laptop now. I've done some research and it turns out that eMachines has a habbit of blowing out their motherboards, and that its being caused by the design of the case for which the board sits on. So ... E-Machines eMachines Desktop PC

NTLDR is compressed

All you need to do is boot to the recovery console, and type the following commands, in order:cd \\attrib -c ntldrexit ... E-Machines eMachines Desktop PC

My Emachine wont stay turned on

This can b caused by a few different problems\015\0121) The machine can be over heating, maybe due to a bad or slow running CPU Fan.\015\0122) Bad power supply\015\0123) Can b software problem, maybe a Virus\015\012Try turning ... E-Machines eMachines Desktop PC

T3624 MB not turning on

Try to reset and clean the memory located in mainboard memory slot, that is the first ideal step to fixed that problem ... E-Machines T3624 PC Desktop

Contrast/menu/screen resolution box wont stop flashing on screen.

Try to clean around it's exit button sounds stuck\015\012or unplug monitor for about 20 minutes\015\012if the problem persists i would reinstall driver ... E-Machines eMachines Desktop PC

I have a Emachines w4682 and the monitor was showing no signal when I turned computer on. I hooked up a different monitor and that one worked so I re connected the original monitor and it worked I then got the computer working except that the USB ports quite working. Stupid me I shut the computer down and when I went to start it up it turned on and back off after less than a minute and now the computer wont turn on at all. Is it the motherboard, the power supply? Any help would be appreciated

Possible reasons are bad power switch, bad power supply, bad motherboard, bad memory , device card is not seated properly. Suggest replace power cord to see if still no power, also you may want to remove cover and make sure all your memory and device ... E-Machines eMachines Desktop PC

Emachine shut down

I have an emachine T3646 that is relatively new, when I hit the power button on the front it flashes and makes a solid beep but wont turn on, has anyone else had this problem? ... E-Machines eMachines Desktop PC

Computer wont turn on

You might try turnin yer PC off & unplug. Then open the case & carefully remove the battery. Let sit for 5 min. Re-install the battery & put it back together. Plug in & turn on. IF you get a screen givin you the option "last known ... E-Machines eMachines Desktop PC

Emachine Wont Load Windows

... E-Machines M6805 Notebook

Emachine Wont Load Windows

Delena \015\012problems like this is associated to RAM malfunctioning.\015\012\015\0121.your RAM might not be sitting properly on the RAM slot,you will need to resit the RAM by opening the system unit and remove the Ram and resit it ... E-Machines eMachines Desktop PC

I have a Emachine W3650 And it wont start up

Insert your windows cd and set computer to start from cd. When prompted to, hit a key to boot from CD. Let Windows start the install (relax it is not really installing anything) when it gets to the prompt, tell it you want to Repair an existing ... E-Machines eMachines Desktop PC

I have an emachines mx4624 laptop that wont turn on. The power cord has tested good but won't turn on or charge the battery. Can it work with a dead battery and a good power cord?

Hi there, Sounds like your Power Jack is Broke... Take a small screw driver and lightly check to see if theres any play in the jack. if you are getting play don't panic its a cheap easy fix but my require some desoldering/soldering to install new jac ... E-Machines PC Desktops

Emachine T6520 Wont Start Up

Check your num lock key status press it on and off if hum lock led is on and off when u pressing then your cpu working fine. so check connectiopn of vga cable cpu to monitor.Also some times display screeen resolution issue so when u power up pr ... E-Machines eMachines Desktop PC

EMachine T3406 wont boot

Is there a post beep when the pc is switched on. check the memory if it is a beep beep beep sound , also disconect the hard drive, dvd drive, floppy, and any usb devices and see if it boots up. if that fails it does seem like the mother board, also c ... E-Machines eMachines Desktop PC

When i turn on my pc the desktop dont show

Go to Start > Programs > Accessories > System Tools > System Restore.Follow the prompts and select a bold date prior to when your problem first appeared. The system will reboot and with luck, the scanner will work. ... E-Machines eMachines Desktop PC

Emachine t2385 for no aparent reason wont boot (as far as i know wasn't powered down). cant power down, just rapid tapping and flashing lights

Hello,You might have a stuck key on your keyboard. I emphasize might.Try this though:Remove the power cord from the back of your PC. Leave it out for a minute or so. While it is unplugged turn your keyboard over and stri ... E-Machines eMachines Desktop PC

Emachine t7242 yesterday i wasnt able to turn my computer on it is stuck. It makes just a ticking noise i cant turn it off without unplugging it. it wont go past this. thought it was the power supply. bought new one it didnt help. replaced the cooling fan still doing same thing help what is the problem here?

The ticking sounds like it could be your hard drive failed. The computer is not making any beeps or anything? just the ticking? If the pc is under warranty I would definetly handle it that way. If this is not the answer you are looking for please d ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4630 seconds