Having problems with your E-Machines eMachines Desktop PC ?

Fan turns on but will not boot. - E-Machines eMachines Desktop PC

Answers :

Try removing and re-inserting the Memory modules of the computer. remember to power off first the machine before attempting to open the case and servicing any pars inside
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Friend has a Emachine T1862 that won't start

May be the CPU fan is going bad. I hope it is that simple. ... E-Machines PC Desktops

EMachines T6528 desktop will not boot up

The power supply fan runs from either 5V or 12 so that only tells you that the voltage for fan operation is present.\015\012\015\012If you don't have a multimeter already, I would highly advise that you buy one.\015\012They are available for &l ... E-Machines eMachines Desktop PC

PC SHUT down

Three things i find to cause this,one, the power supply is bad,two, the power connector is lose or not push in three, the heat sink on the processor has come off. This will cause the cpu to over heat and self shut off. ... Dell E151FPp 15" Flat Panel LCD Monitor

Computer dies on me (can't say it better due to no technical knowledge; pls read :-)

The 'click' sound you hear when your computer goes off is the hard drive head parking itself.  It does this whenever the machine shuts down to prevent damage.As for the problem itself, I believe your computer is overheating.  Th ... Acer TravelMate 290LCi Notebook

Fan turns on but will not boot. - E-Machines eMachines Desktop PC

Try removing and re-inserting the Memory modules of the computer. remember to power off first the machine before attempting to open the case and servicing any pars inside ... E-Machines eMachines Desktop PC

My e-Machine W3115 automatically shuts down multiple times

1) Computer off, and unplugged from power. (Unplug from the surge protector FIRST, then unplug the power cable out of the power supply)2) Work on a table where you have plenty of room.Open the computer case. (Rear of computer, ... eMachines W3115 PC Desktop

Computer turns on, but does not boot to XP

Generally, fans are controlled by heat readings...something to check is the operating temperature that is shown in your BIOS when you boot up...(access your BIOS by tapping on the delete key, or F2 key while booting)..if it goes over 70C real quick t ... Sony VAIO Digital Studio PCV-RX660 PC Desktop

Compaq presario sr1950 nx desktop - won't start

Hopefully you didn't discharge any static into the machine. Try pulling out your memory sticks and turning the machine on. If you hear a repetitive beeping from the computer it's good sign. Turn off the machine. Put the ram back in and locate th ... HP Compaq Presario SR1950NX PC Desktop

EMachine W3107 will not boot, no display.

Have you tried a different Graphics Card, looks to me like the onboard graphics card is at fault, there should be an AGP slot or PCI slot that you can plug a new Graphics card into then you should be fine... ... PC Desktops

Desktop Lockup Hello. I have an emachines model T2042 desktop and it has started to lock up and the activity light below the power button blinks at a steady interval, and I can hear a rhythmic "knocking" inside the machine. I have to unplug the power cord from the rear of the machine to get it to power cycle, and then turn it on again. It's a Celeron, 2GHZ machine, with 128MB of original memory. Could this be a power supply issue? I know it's an old machine, but was planning on giving to my sist

Remove the cover to look at the power supply fan while it is powered on ( if needed). The fan should be spinning at a steady rate. If you observe fluctuations in the rotation, these are early indications of a malfunctioning power supply unit. As for ... E-Machines T2042 CELERON 2 GHz 128 MB 40 GB HDD Dsktop Computer System PC Desktop

Hello, I have a Gateway model GT5662, stock setup - Will not boot

Usually, if it's a motherboard that has a failed component on it, you will see failed Electrolytic Capacitors. The small aluminum 'Cans' on the motherboard.Note*The Electrolytic Capacitors that surround the Processor, should have sp ... Gateway GT5662 Desktop PC

I need to reboot e machined620 triedf10 but then got stuck

T2958- Emachines is very much like I have. If you are running Windows Vista. I can advise you now to open the machine and blow out the dust. Remove the ram and reinstall checking for tightness. Check all wires and make sure t ... E-Machines (T2958) PC Desktop

EMachine 2862 Desktop Dead On Power-Up

Check all the leads to the hard drive and check that the fan starts spinning when you switch it on if it dont start then the problem is the switch these do often go and can be easily replaced and they are not expensive i had the same problem and foun ... E-Machines T2682 (000002965) PC Desktop

Compaq Presario SR1000 desktop boot up problem

Nothing to do with the ram ... this motherboard sometimes locks, ( dont ask me why) but if you take out the power cord for 5-10 minutes and then press and hold the front power button on the machine (about 10 seconds) it will reset the board. Plug in ... PC Desktops

My Emachines Desktop W5243 works sometimes and others just beeps

You might be having a minor dust particle situation going on. Take the memory out of the system. Get a can of air and blow out the slots on the motherboard where the memory would normally go. Then take the can of air and blow the connectors on bot ... E-Machines eMachines Desktop PC

E-machine desktop powers up and shuts right down

Yes absolutely it is the power supply and EMachines have a reputation of using less than great power supplies. Do not turn it back on as it may cause damage to motherboard components. Now as for as getting a new one they are not expensive. FIrst you ... E-Machines eMachines Desktop PC

Not turning on, has power and everything

Do any of the fans spin at all, as though it's attempting to boot up? If not, then double check your power supply to see if it has a switch on it and if it does then make sure it's switched into the ON position. If so, then I would recheck the power ... eMachines T3604 PC Desktop

E Machine T6534 fails every 6 to 9 months

This could be caused by the processor or fan,But very unlikely to be the mother board. ... eMachines T6534 PC Desktop

Emachine M5105 that won't boot up.

I suspected the IDE cable is not properly connected to your hard disk. Check connections and boot up machine normally. ... E-Machines M5105 Notebook

Emachine 3240 possible power problem?

I would suggest try to swap the power supply out with another known good power supply.I've seen where even though the light on the motherboard is lit, it is not getting enough power to start the machine up, especially if you have a higher ... E-Machines eMachines Desktop PC

Xw6200 gives 6 beeps but goes no further, suggestions? Can resetting the cmos back to default solve the problem?

On any type of desktop o laptop computer, you can access the BIOS settings by pressing at DEL key while it turns on (in some computers you will see a message on the screen after you turn it on displaying the right key to press in order to get into th ... HP CTO HP Workstation XW6200 Base (DY247AV#ABA) PC Desktop

Emachine trouble The emachine desktop that i have is currently haveing problems loading Windows XP. This is the operating system that came with the compuer. However everytime I turn the computer on it starts to boot fine until I get to the page that says (Windows IS Now Loading) and then ti freezes up and will not go any further. I have tried to restart it sveral times and even ran system test but no problems are acknowledged. Could you please assist me with this problem at your earliest canvien

There are several causes that are common.The first,especially with e-machines, is they do not like service pack 2 updates.If you have a standard winxp cd you can boot from that and choose repair console once the cd starts to load win xp f ... E-Machines eMachines Desktop PC

Fan runs but will not boot.

Remove all external devices first like printers etc and then try again.\015\012If it doesn't work then you will have to open the computer case side panel so we can start troubleshooting some parts.\015\012If the machine has warranty then ... Gateway GT5228 (7156) PC Desktop

Compaq desktop freezes on me when am working

Sounds like you may have a virus or spyware running in the background. When you turn on your computer, keep pressing F8 and it should take you to a boot menu. Choose safe mode and let it boot, if you can't get into safe mode without the lockups hap ... PC Desktops

EMachine Desktop Computer

This is most likely an issue with the powersupply being faulty, contact Emachines and tell them the error(as well as model and all that). They will then most likely send you a power supply that you can easily install yourself. Its just four screws in ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7716 seconds