Having problems with your E-Machines eMachines Desktop PC ?

Emachines t3958, bad ram, green stand-by only no boot

\015 Emachines t3958, I had a ram card go bad and went through a couple of motherboards. Now I know which ram is bad but I still have two boards that are powering the green standby light but wont boot, much like the other folks who owned one. I ask for a way to find the fuse or circuit that would be affected by a bad ram card and got a RTC BIOS reset, tried it, need more in put help please!~!!\015

Answers :

Are you saying you bought 2 more machines to fix the problem? I don't understand. Do you have the manual for the machine. How long did your system run before a Ram stick went bad? What brand and size are your Ram sticks. Are they identicle? As far as Clearing BIOS, your manual should show you the jumper position to do this, which you will leave in this ( drain ) position for a minute. Powering up from here you need to immediately hit a key to send you to BIOS most are <del> or F10 or alt esc. You must look in your manual for this and then all your boards should work. If you need my help in finding your manual, give me all numbers pertaining to your machine.
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Emachines t3958, bad ram, green stand-by only no boot


Are you saying you bought 2 more machines to fix the problem? I don't understand. Do you have the manual for the machine. How long did your system run before a Ram stick went bad? What brand and size are your Ram sticks. Are they identicle? As far as ... E-Machines eMachines Desktop PC

Bad power supply, installed new one, get green light on mother board; but doesn't boot up. Bad start up button?


Yes, it is my belief that it is the Power On button. To test this, there is a simple solution. I however, would like to caution you at this point.You will have the power supply plugged in. There will be a small spark. I wouldn't advise how to t ... PC Desktops

Emachine w2686 no display when boot up


Couple things to check. First, check with different monitor. Their monitors are usually build by KDS and I think there was a bad series out there. Also check for any beep codes through speakers on startup, this can tell you bad ram or bad video out. ... E-Machines eMachines W2686 PC Desktop

EMachine T3958 Won't start - Please help


The green LED indicates that the standby voltage is present which is what provides the power so the front button can tell the unit to turn on fully.\015\012At that point, there are 3 possibilities; the power supply has a fault and won't turn on ... E-Machines eMachines Desktop PC

Emachine t3958 Hi, I turned off my t3958 by pushing the power button and now it want come back on. I ohm the switch, not sure what it should be but it 0 out. I pulled out the mother board and inspected it, nothing looks or smells burnt. With the mother board out I plugged the power supply in to a outlet and one fan started running but only for a second then stopped. I then waited a few minutes plugged it back in and it did the same thing and if I unplug and then plug right back in again it does


First check to see if a drive died. Unplug all the drive Floppy, hard and dvd or burns. I have come across many time that a drive will die and keep motherboard from booting. Being that you say you get a green light on the motherboard shows that the ... E-Machines eMachines Desktop PC

New ram cards to upgrade, now won't run windows


Ok,I looked up the specs on this pc. It's kinda old & it says it comes with windows me installed,but apparently some come with or are upgraded to xp. Go into bios setup,usually f1 or delete,should say during post. On the first page in bios see if ... PC Desktops

My ibm thinkpad booting and hanging fault


Try this... to see if your video card is bad...\015\012 Connect your laptop to an external monitor and press the Function key plus F5 on the laptop... if your OS shows up on the monitor screen, then you have a bad video card... \015\012 ... IBM ThinkPad T42 Notebook

Screen will not come on hard drive light no light checked power supply is ok


Things to check:\015\012\015\012\015\012Power led on the front of the tower, it should be solid green when on. Flashing Amber is generally an indication of a bad power supply inside the tower\015\012Power L ... Dell Dimension 4600 PC Desktop

Won't power up


This error can be caused by one or more of the below possibilities.\015\012Floppy or CD that is not bootable is cur... BIOS or CMOS setup is not setup properly... Hard disk drive does not have bootable f... The hard disk drive ... IBM ThinkPad T20 Notebook

Gateway 702GE desktop When i push the front botton to start it up,the fans start to turn and then stops with no operation. The small green led on the motherboard stays lit and green and the front start button stays lit and blue, but there is no start up. Can anybody help please? Matt


Try removing all the cards from the expansion slots and remove the ram sticks. disconnect the drive cables from the board but dont touch the cpu or power connectors. Now hit the button. If nothing changes, probable board fault. If it now boots up and ... Gateway 702GE PC Desktop

IBM T30 - no screen - sortof booting


I own a t-30 myself with all the same problems i am reading about not reading ram beeping on startup no screen display but you could here hard drive running before these symptoms started the first symptom i ever noticed was if i picked the unit up wi ... IBM ThinkPad T30 2366 Notebook

Cannot get new Motherboard to boot up in Normal Mode


What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

My monitor goes to sleep mode at startup & can't access safe mode


Turn the computer off, open the case and remove the RAM. Does the computer beep when you turn it on with no RAM? If not, your motherboard is dead. If your computer beeps, turn it off again and try putting one stick of RAM in. If the co ... E-Machines eMachines Desktop PC

Dell Dimension 8400, no post. B and D amber.


GYGY diagnostic lights -- Memory is detected, but a memory configuration or compatibility error exists, and the 1-3-2 beep sound indicates the MEMORY test failed, which means one of the four memory has gone bad or the one of the four slots on the mot ... Dell Dimension 8400 PC Desktop

Emachine T2484 will not power up


Try to start it without any memory in it (RAM), if it beeps then you have bad RAM. If you have more than 1 piece of RAM then try one at a time and see if it will boot. If it doesn't beep and still doesn't turn on your CPU is probably the culprit si ... E-Machines eMachines Desktop PC

Computer will not fully boot


It is almost certainly a memory error. First off remove the power cord and the small battery on the motherboard. You may see a jumper near the battery with something like 'rst cmos' next to it. If so pull it off and short it over the other pin. Wait ... HP Pavilion dv8000z Notebook

IBM ThinkCentre 8183 (M51) does not boot


The situation you describe is usually 1 of 2 things, Power supply (PSU) or Motherboard (mobo).Situation #1: If you get a blank screen and no sounds or movement it either indicates that the power supply unit (PSU) has failed or something o ... IBM ThinkCentre M51 PC Desktop

Asus P4S800-MX Motherboard video problem


It is obvious that your system is NOT booting. Recheck the wiring harness and ensure that the motherboard is wired correctly. Check for boot.\015\012\015\012Take your memory out and then reseat the modules. Check for boot.\015\012\015\012Take your CP ... PC Desktops

Getting power but wont boot up or anything


Pull out everything in the computer except what's required to boot...so any pci cards or video cards (if you have onboard video). you can also try pulling out the ram (while unpowered AND unplugged) and then booting to hear beeps...if you pull the ra ... E-Machines T2792 PC Desktop

Stuck on BIOS Screen?


I would try to power off the machine completely and hold a key down on the keyboard and power on the computer while still holding down one key. Keep holding it (it might make an irritating beep sound, that is expected) . This is one trick that will a ... E-Machines eMachines Desktop PC

Computer in black screen, no energy outputted


A few possibilities(the only problem is if you never get any display to try many of these suggestions):\015\012\015\012-Suspend. With suspend, everything is put to RAM and the computer goes to low power state, shutting off USB, HD, and most other thi ... E-Machines eMachines T3830 PC Desktop

Acer One 1542 series.Power on but not boot.


Since you reseated the memory, the last two things I would do is remove the hard drive and dvd drive.If you remove those and you can't get video then the motherboard is bad. ... Acer Aspire One PC Notebook

Desktop monitor port not working. processor, keyboard, mouse all powered on & working, you can hear it boot up. I use this with other computers, it works fine. monitor has power but goes to sleep. Is there another way to connect monitor with a different adapter, as usb port or to serial port?


Ha, no kidding! I just had a HP Pavilion a705w come in for repair at my shop!Small world.Okay, let's go with your theory that the power supply is okay, and the Processor is indeed operating.Your theory is that the ... PC Desktops

Dell Dimension 5100, Doesn't Boot Up, Display Lights Up "!, 2 3"


2 green lights usually indicate a memory problem, however, when you get 3 lights, RAM is good, but the BIOS is unable to hand off to the operating system.To test this, disconnect your hard drive (both ribbon and power) and connect the mon ... Dell Dimension 5100 (D51L1) PC Desktop

COMPAQ PRESARIO SR1420NX, TRYS TO POWER UP BUT GREEN LIGHT ON FRONT POWER BUTTON JUST FLASHES..


Could be one of two things: either the power supply is going bad or the RAM is either going bad or isn't seated properly inside.First thing I would try would be to re-seat all the memory chips inside the computer. There could be up ... HP Compaq Presario SR1420nx (SR1420NXPS69AA) PC Desktop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9250 seconds