Having problems with your E-Machines eMachines Desktop PC ?

Emachine D2880-No Power

\015 Left D2880 off, with powerstrip off, while on vacation for one week.\015\012came back, no power, but green light on motherboard. switched outlets, cable and power source-no power. observed charred component on motherboard, took power source in to comp-usa, tested good. installed new motherboard-no power. have tested and swapped power switch, checked and rechecked all connections and swapped out processor with one that came from a running unit. still only get green light on mother board. tried to power up without dvd and another good hard drive, green light on mother board. could power source still be suspect\015\012even though it was tested? noticed the guy only tested the lead to the\015\012cd and hard drive, not the P8 lead to the mother board.\015\012Thanks\015\012Dan\015

Answers :

Probably yes, the poiwer-source may be delivering "dirty" power (happens also when using a back-up generator, as in the power in the building goes out, or when used in an old RV, and the back-up kicks in) <--- is a safety feature to protect the CPU. Try also a different powerstrip, or head off to the neighbors and try their plug before swapping out the power supply.
\015\012
\015\012In the end, you may wish purchase an inexpensive clone-tower, swap out the HD and processor (if you are spending too much time and money trying to band-aid the old one)
\015\012
\015\012Hope this helps!
\015\012
\015\012 -- RT
Hi, there ! Try this on the motherboard there's a CMOS bat u have to reset it becuse u being a way for a week voltage on this bat nust have discharged ,tell ur technician to do that .
\015\012Or get a new CMOS bat and also Remove the MEM cards from slots put them back After u have all these switch the machine on
\015\012
\015\012If no change get a new motherboard
\015\012
\015\012
\015\012good luck
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Emachine D2880 no power clarification


Your getting power to your PSU, via the green light on your mobo. \015\012verify the PSU has a green light(most emachines do) \015\012it sort of sounds stupid but, check the connection of the cable coming from the front of the case(the wi ... E-Machines eMachines Desktop PC

Emachine D2880-No Power


Probably yes, the poiwer-source may be delivering "dirty" power (happens also when using a back-up generator, as in the power in the building goes out, or when used in an old RV, and the back-up kicks in) <--- is a safety feature to protect the CP ... E-Machines eMachines Desktop PC

Need large disc support for old emachine, flash bios? or try restore cds?


Hi,\015\012flashing a bios, can render your machine/motherboard useless.\015\012You should always ensure any bios download is from a trusted source. if you experience a power failure, or an incomplete bios file. your computers as good as ... E-Machines eMachines Desktop PC

I would like an internal view of eMachine T4150 to be sure everything is connected correctly


There's a bit of a toughie! eMachines doesn't like to give out this information, lyndapalimas, and I don't have one sitting in my shop.eMachines used four different motherboard manufacturers, to my knowledge. TriGem, Intel, FIC, and MSI. ... PC Desktops

EMachine no power


Ok for a start the power switch is not green and white that is the power led, you need to look for a red and black wire normally marked on the connector and motherboard as pwrsw or pswitch.\015\012if you believe it to be the switch unplug the c ... E-Machines eMachines Desktop PC

I have a T2958 and toof the face off. Can you


EMachines doesn't give out this kind of info, and I don't have one in the shop. eMachines also had the habit, of using a few different manufacturer's of motherboards. Intel, TriGem, MSI, Asus,and FIC to name five. Plus eMachines wou ... E-Machines (T2958) PC Desktop

I have emachine w3400 not powering . plz help


I found this right on this website, hope it works!As for the fans, make sure your connections are tight and in the proper sockets. ... AMD eMachines Desktop System w/ 17'' CRT Display, 2.0 GHz Athlon 64 3000+ (W3400)

2 emachines won't boot


Are you attaching them properly\015\012if so then it is something other then power supply\015\012something has caused both power supplies to blow\015\012have you installed anything in the first emachine you talk about ... E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

EMachine will not turn on.


Sounds like the power supply is faulty. Power supplies are very dangerous to try and repair, even for qualified technicians. I would also suggest not trying to plug it in or turn it on until the new power supply is in place. Faulty power supplies ... E-Machines eMachines Desktop PC

EMachine T2958 - No power


Yea that's right.Once the PSU has power the tester is powered on too. ... E-Machines eMachines Desktop PC

Emachines e4026 non-responsive


I don't think it's an overheating CPU. It would stay on for a bit longer if it was that.\015\012\015\012My best guess is a power supply issue. Either your power supply is bad, or more likely something is pulling too much power from it. Emachines a ... E-Machines eMachines Desktop PC

Emachine T3624 will not power up


Emachines are notorious for having faulty power supplies. If your lucky you just need to replace the power supply. I've seen a lot of them where the power supply also fried the motherboard.\015\012 \ ... E-Machines T2984 PC Desktop

2 year old E machine


Dear zmatt,\015\012\015\012Looks like the power outlet or UPS may be at fault. Try a different outlet. That's all I can thik of.\015\012\015\012Good luck! ... E-Machines eMachines Desktop PC

E-Machine T2862 Will Not Power UP


Regarding the power + power LED +HDD LED connections, if you haven't tossed the unit yet -- looking straight down with the box laying on side (e.g. CPU fan blades pointed straight at you) -- GreenWhite + BlackWhite (start with left pin, row nearest t ... E-Machines T2682 (000002965) PC Desktop

E-machine 5220 power up


Emachines have notoriously cheap power supplies. Often, while the power supply itself doesn't fail, it causes the failure of motherboard components, essentially trashing the computer.Try the following:First check and make abso ... E-Machines eMachines Desktop PC

No power on my emachine


The power supply might be okay but the system board could be bad and not turning the power supply on when you press the power button.On this page:http://www.helpwithpcs.com/courses/power-supply-basics-inc-pinouts.htmabout midw ... E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

Had to replace power switch on emachine computer need to know where wires go


I'd like you to look at this motherboard, and compare it to yours. It's an Intel Seabreeze T3 motherboard. My data states it was used in many computers, and the eMachines T3830 being one of them. ... E-Machines eMachines T3830 PC Desktop

EMachine 2862 Desktop Dead On Power-Up


Check all the leads to the hard drive and check that the fan starts spinning when you switch it on if it dont start then the problem is the switch these do often go and can be easily replaced and they are not expensive i had the same problem and foun ... E-Machines T2682 (000002965) PC Desktop

Toshiba Satellite 1400


To Access the Bios Setup Utility Here Is A List Of Key Commands And The Make/Model They Are For..\015\012\015\012Acer - Aspire, Power, Veriton, Extensa, Ferrari, TravelMate, Altos\015\012\015\012 ... Toshiba Satellite A35-S159 Notebook

EMachine T2824 does not turn on. Power cord/power supply seems O.K.


There are just too many eMachine models to be familiar with every one, however, as a preliminary inspection, remove the side panel, and turn the computer on to see if you see a green "Health" light. This will give you an initial clue as to how to pur ... E-Machines (T2824) PC Desktop

I accedentally knocked the power wires off inside the big box i cant think of the name on my emachine w3507 how do i put back together


Power On switch, (Button), wires from the front panel that go to the motherboard? I could really use the name of the motherboard, to try to get you this information. I don't have an eMachines W3057 sitting in front of me, at the mom ... eMachines W3507 PC Desktop

When I turn it on, only the fans run. I cannot hear the hard drive run and the hard drive light on the bezel is solid yellow


EMachines were designed to be Budget computers. As such the company used cheap Power Supply's. Cheap components within the power supply have failed. The power supply only has enough power to light, lights, and spin fans.Solution is to rep ... E-Machines T6216 (827103077834) PC Desktop

Need to know what parts compatable to ATX-1523D for an emachines T-1090


It's a Small Form Factor power supply. 4.9 inches Wide, 2.5 inches Tall, and 3.9 inches Long.Put's out a maximum of 150 watts, (Supposedly)Has the following power cables;A) (1) 20-pin ATX main power cable: ... E-Machines T1090 PC Desktop

Emachine 5210 had this machine a few years now , but it has gone off only the fans are running and a yellow light on the front , and no other response or screen coming up , the only way to stop the fan is to pull the plug out , got any sugestions please


Emachines used to use a poor quality power supply made by Bestec, I believe the quality is supposed to have improved in the last few years but inconsidering the number of dead Emachines that wind up in my workshop I doubt it.\015\012The problem ... E-Machines eMachines Desktop PC

Not turning on, has power and everything


Do any of the fans spin at all, as though it's attempting to boot up? If not, then double check your power supply to see if it has a switch on it and if it does then make sure it's switched into the ON position. If so, then I would recheck the power ... eMachines T3604 PC Desktop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4113 seconds