Having problems with your E-Machines eMachines Desktop PC ?

Emachine no power - E-Machines eMachines Desktop PC

Answers :

Check to make sure you have a good outlet. Does anything happen when you try to power on (any lights or fans starting to run etc). Could be a bad PSU (power supply unit)
Anything happen prior to this, any random shut offs? Any loose screws causing it to short out?
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Desktop Lockup Hello. I have an emachines model T2042 desktop and it has started to lock up and the activity light below the power button blinks at a steady interval, and I can hear a rhythmic "knocking" inside the machine. I have to unplug the power cord from the rear of the machine to get it to power cycle, and then turn it on again. It's a Celeron, 2GHZ machine, with 128MB of original memory. Could this be a power supply issue? I know it's an old machine, but was planning on giving to my sist

Remove the cover to look at the power supply fan while it is powered on ( if needed). The fan should be spinning at a steady rate. If you observe fluctuations in the rotation, these are early indications of a malfunctioning power supply unit. As for ... E-Machines T2042 CELERON 2 GHz 128 MB 40 GB HDD Dsktop Computer System PC Desktop

E-Machine T2862 Will Not Power UP

Regarding the power + power LED +HDD LED connections, if you haven't tossed the unit yet -- looking straight down with the box laying on side (e.g. CPU fan blades pointed straight at you) -- GreenWhite + BlackWhite (start with left pin, row nearest t ... E-Machines T2682 (000002965) PC Desktop

EMachine 2862 Desktop Dead On Power-Up

Check all the leads to the hard drive and check that the fan starts spinning when you switch it on if it dont start then the problem is the switch these do often go and can be easily replaced and they are not expensive i had the same problem and foun ... E-Machines T2682 (000002965) PC Desktop

EMachine Model T3828 No power

Greetings! As the first answer suggests, you must be comfortable taking things apart. I've actually just finished diagnosing the same problem on a customer's computer, and Here's what I did.First, I remove the power plug, open up the co ... E-Machines eMachines T3830 PC Desktop

T2893 desktop did not power on when I hit the power button

If you can find someone that has the same model, that is the best way to make sure it fits. Some other motherboards will fit, but you may have to do some work to get them to fit. The best way would be to try to do some research on your particul ... E-Machines eMachines T3830 PC Desktop

E-Machines 2862 Dead On Power-Up

You might want to try to unplug it at the power cord and then plug it back in again, ... E-Machines T2682 (000002965) PC Desktop

LCD monitor signs "no signal" on eMachines t3418

E-machines had had a long history of bad power supplies. I've seen many of these machines go bad and when they do they take out the video chip (Nvidea) with it, usually shutting down the whole machine. I've never seen one operable. You might be ab ... E-Machines eMachines Monitor E15T4

E-machine desktop powers up and shuts right down

Yes absolutely it is the power supply and EMachines have a reputation of using less than great power supplies. Do not turn it back on as it may cause damage to motherboard components. Now as for as getting a new one they are not expensive. FIrst you ... E-Machines eMachines Desktop PC

My e-Machine W3115 automatically shuts down multiple times

1) Computer off, and unplugged from power. (Unplug from the surge protector FIRST, then unplug the power cable out of the power supply)2) Work on a table where you have plenty of room.Open the computer case. (Rear of computer, ... eMachines W3115 PC Desktop

Producr assistance In November of 2007 I purchased an eMachine model number T5230 desktop pc. My son is having trouble loading some of his games and I would like to know exactly what I need to purchase to increase the speed and memory of this particular model. Thank you. [email protected]

Many of the newer machines for sale now unfortunatly do not include a seperate and powerful video card. The machine comes with an internal video card that shares the machine's memory for video loads; iy is built into the motherboard to reduce the sel ... E-Machines eMachines Desktop PC

Noisy machine My desktop is an emachine 5260. For the last 6 months the machine has been getting noisier, presumably it is the fan. I have tried reformatting but no change. I dont think that i have too many programmes , but even so i am reluctant to remove any. Any help would be wellcome

You are probably right the fan or the power supply. Most likely the CPU fan. Emachines have always had problems with noisey fans. The fan noise has nothing to do with the software on the computer. Deleting software doesn't help\015\012the problem. I' ... E-Machines eMachines Desktop PC

Emachine desktop power switch is shot

I would still try to replace the power supply first,before replacing the motherboard.In 80% cases that you are describing it is the power supply.\015\012Hope this helps ... E-Machines eMachines Desktop PC

I unplugged my emachine desktop when i went on vacation and now after repluggging it is dead to the world?

Hello there:This is fairly common on these e-machines Normally what happens is that the silver coin sized cmos battery will drain down and when this does by default it shuts it'self completly down untill you replace the battery ill nee ... PC Desktops

Power switch doesnt turn on machine - E-Machines eMachines Desktop PC

Most often, and especially with many E-Machines I've seen the past few years, it's not the power switch it is the mother board that has failed.\015\012Unless you have a reasonable priced local repair person you'll probably have to contact E-Mac ... E-Machines eMachines Desktop PC

Emachine no power - E-Machines eMachines Desktop PC

Check to make sure you have a good outlet. Does anything happen when you try to power on (any lights or fans starting to run etc). Could be a bad PSU (power supply unit) ... E-Machines eMachines Desktop PC

Wont power on . is it worth repaairing? - E-Machines eMachines Desktop PC

If the problem is your power supply: power supply can be replaced easily and its cheap. if you can get a used one in a computer surplus shop nearest you, that's even better. so yes, it is work repairing.if the problem is mainboard: it dep ... E-Machines eMachines Desktop PC

My emachine desktop is not not coming on

I've owned nothing but e-machines towers for probably 9yrs. I've had this exact problem with two of them already. E-machines are notoriously known for power supply problems (which is usually about a $50 fix), but oddly enough the two problems I've ... E-Machines eMachines Desktop PC

Emachines T2698? This is my sisters computer and she ahs had it for sometime not really sure how long but just this past weekend the computer was running real slow and her father in-law went ahead and did a system restore. She told me that when they got done with the restore everything worked better. She also has a Emachines laptop that is acting up and so she went to try her desktop computer. She pushed the power button and it came on but it stops at a big E on the screen and you can't do anyti

Hi,\015\012\015\012On the e-Machine desktop, go to the CMOS/BIOS set-up and set everything to default or fail-safe settings. Save and Exit. Verify also that the desktop auto detected the hard disk.\015\012\015\012If the unit will still not boot to th ... E-Machines eMachines Desktop PC

Emachine T3624 desktop PC won't turn on?

I can guarantee 100% you have a bad motherboard. I have seen this exact problem with hundreds of E-machine PC's (especially your particular model).\015\012\015\012What happend is the power supply went bad and took the motherboard with it ... E-Machines eMachines Desktop PC

Need manual for Eone 433 desktop computer

I had the same problem recently with an emachines Eone 433 desktop. Taking it apart is certainly difficult. First of all, the metal compartment that holds the motherboard and drives is beneath the CRT monitor. In order to access and remove the compar ... E-Machines eOne 433 PC Desktop

Where does the cable labled P7 go - E-Machines eMachines Desktop PC

Hiya,\015\012\015\012I have an image for you to look at, and I will need confirmation that this is or is or is not what you are giving reference to.\015\012\015\012 ... E-Machines eMachines Desktop PC

My emachine 770 just lost sound why? - E-Machines eMachines Desktop PC

I think u have directly doing power of the machine. that resion driver goes. reinstall the audio Driver ok.\015\012After that same issue it means the foult with mother board. ... E-Machines eMachines Desktop PC

Emachines desktop Wont boot. - E-Machines eMachines Desktop PC

A simple and effective task (well most of the time) is to reseat components on the motherboard. This can include unplugging the components, including but not limited to:Hard Drive and Optical Drive CablesIDE/SATA ConnectorsSys ... E-Machines eMachines Desktop PC

Emachine wont start up

This is a DESKTOP machine, not a laptop. It has to be plugged into a wall outlet that has power, for the machine to run. ... E-Machines eMachines Desktop PC

HOW TO RESTART eMachines Desktop PC - E-Machines eMachines Desktop PC

You can either go to the start menu, power setting, restartORpress Ctrl & Alt & Del (ALL AT SAME TIME) Than select restart.If you are talking about an entire system reset, you will have to find the system restore se ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6248 seconds