Having problems with your E-Machines eMachines Desktop PC ?

Emachine will not power up

\015 Green light on motherboard is on, but nothing else model t2862\015

Answers :

By nothing else, from a technical standpoint this would mean literally nothing, the CPU fan, power supply fan, aux fan, disk drive not spinning up, etc. My experience with EMachines is their motherboards aint the best, have been known to take out hard drives and other peripherals to the mother board. If you are technically inclined the first thing to do is to bare out the system, Power Supply attached to the Mother Board w/ Cpu Monitor and Keyboard no Hard Drive and no Non esential boards installed, very carefully remove the memory and start it up all should be fine except it should give you a long beep from the PC Speaker indicating the Mother Board is aware there is no memory installed if it will not do this most basic of tests this is not good. If it does give you a health beep continue to install one item at a time, first the memory, the display should, if working, tell you there is a boot failure, of course, the hard drive is not connected, do so and keep on testing. Without knowing what type of mother board you have, most likely an AT with integrated peripherials the process to determine exactly what the problem is would take hands on trouble shooting. If you dont get the beep indicating the mother board cant determine if memory is installed and truley nothing else is on it is more likely the mother board. There are several good ones online that will fit your case if you want to go this route. Or is it time to upgrade ?
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I would like an internal view of eMachine T4150 to be sure everything is connected correctly


There's a bit of a toughie! eMachines doesn't like to give out this information, lyndapalimas, and I don't have one sitting in my shop.eMachines used four different motherboard manufacturers, to my knowledge. TriGem, Intel, FIC, and MSI. ... PC Desktops

EMachine no power


Ok for a start the power switch is not green and white that is the power led, you need to look for a red and black wire normally marked on the connector and motherboard as pwrsw or pswitch.\015\012if you believe it to be the switch unplug the c ... E-Machines eMachines Desktop PC

I have a T2958 and toof the face off. Can you


EMachines doesn't give out this kind of info, and I don't have one in the shop. eMachines also had the habit, of using a few different manufacturer's of motherboards. Intel, TriGem, MSI, Asus,and FIC to name five. Plus eMachines wou ... E-Machines (T2958) PC Desktop

I have emachine w3400 not powering . plz help


I found this right on this website, hope it works!As for the fans, make sure your connections are tight and in the proper sockets. ... AMD eMachines Desktop System w/ 17'' CRT Display, 2.0 GHz Athlon 64 3000+ (W3400)

2 emachines won't boot


Are you attaching them properly\015\012if so then it is something other then power supply\015\012something has caused both power supplies to blow\015\012have you installed anything in the first emachine you talk about ... E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

EMachine will not turn on.


Sounds like the power supply is faulty. Power supplies are very dangerous to try and repair, even for qualified technicians. I would also suggest not trying to plug it in or turn it on until the new power supply is in place. Faulty power supplies ... E-Machines eMachines Desktop PC

EMachine T2958 - No power


Yea that's right.Once the PSU has power the tester is powered on too. ... E-Machines eMachines Desktop PC

Emachines e4026 non-responsive


I don't think it's an overheating CPU. It would stay on for a bit longer if it was that.\015\012\015\012My best guess is a power supply issue. Either your power supply is bad, or more likely something is pulling too much power from it. Emachines a ... E-Machines eMachines Desktop PC

Emachine T3624 will not power up


Emachines are notorious for having faulty power supplies. If your lucky you just need to replace the power supply. I've seen a lot of them where the power supply also fried the motherboard.\015\012 \ ... E-Machines T2984 PC Desktop

2 year old E machine


Dear zmatt,\015\012\015\012Looks like the power outlet or UPS may be at fault. Try a different outlet. That's all I can thik of.\015\012\015\012Good luck! ... E-Machines eMachines Desktop PC

E-machine 5220 power up


Emachines have notoriously cheap power supplies. Often, while the power supply itself doesn't fail, it causes the failure of motherboard components, essentially trashing the computer.Try the following:First check and make abso ... E-Machines eMachines Desktop PC

E-Machine T2862 Will Not Power UP


Regarding the power + power LED +HDD LED connections, if you haven't tossed the unit yet -- looking straight down with the box laying on side (e.g. CPU fan blades pointed straight at you) -- GreenWhite + BlackWhite (start with left pin, row nearest t ... E-Machines T2682 (000002965) PC Desktop

No power on my emachine


The power supply might be okay but the system board could be bad and not turning the power supply on when you press the power button.On this page:http://www.helpwithpcs.com/courses/power-supply-basics-inc-pinouts.htmabout midw ... E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

Toshiba Satellite 1400


To Access the Bios Setup Utility Here Is A List Of Key Commands And The Make/Model They Are For..\015\012\015\012Acer - Aspire, Power, Veriton, Extensa, Ferrari, TravelMate, Altos\015\012\015\012 ... Toshiba Satellite A35-S159 Notebook

Had to replace power switch on emachine computer need to know where wires go


I'd like you to look at this motherboard, and compare it to yours. It's an Intel Seabreeze T3 motherboard. My data states it was used in many computers, and the eMachines T3830 being one of them. ... E-Machines eMachines T3830 PC Desktop

EMachine T2824 does not turn on. Power cord/power supply seems O.K.


There are just too many eMachine models to be familiar with every one, however, as a preliminary inspection, remove the side panel, and turn the computer on to see if you see a green "Health" light. This will give you an initial clue as to how to pur ... E-Machines (T2824) PC Desktop

EMachine 2862 Desktop Dead On Power-Up


Check all the leads to the hard drive and check that the fan starts spinning when you switch it on if it dont start then the problem is the switch these do often go and can be easily replaced and they are not expensive i had the same problem and foun ... E-Machines T2682 (000002965) PC Desktop

I accedentally knocked the power wires off inside the big box i cant think of the name on my emachine w3507 how do i put back together


Power On switch, (Button), wires from the front panel that go to the motherboard? I could really use the name of the motherboard, to try to get you this information. I don't have an eMachines W3057 sitting in front of me, at the mom ... eMachines W3507 PC Desktop

When I turn it on, only the fans run. I cannot hear the hard drive run and the hard drive light on the bezel is solid yellow


EMachines were designed to be Budget computers. As such the company used cheap Power Supply's. Cheap components within the power supply have failed. The power supply only has enough power to light, lights, and spin fans.Solution is to rep ... E-Machines T6216 (827103077834) PC Desktop

Need to know what parts compatable to ATX-1523D for an emachines T-1090


It's a Small Form Factor power supply. 4.9 inches Wide, 2.5 inches Tall, and 3.9 inches Long.Put's out a maximum of 150 watts, (Supposedly)Has the following power cables;A) (1) 20-pin ATX main power cable: ... E-Machines T1090 PC Desktop

Emachine 5210 had this machine a few years now , but it has gone off only the fans are running and a yellow light on the front , and no other response or screen coming up , the only way to stop the fan is to pull the plug out , got any sugestions please


Emachines used to use a poor quality power supply made by Bestec, I believe the quality is supposed to have improved in the last few years but inconsidering the number of dead Emachines that wind up in my workshop I doubt it.\015\012The problem ... E-Machines eMachines Desktop PC

Emachine D2880 no power clarification


Your getting power to your PSU, via the green light on your mobo. \015\012verify the PSU has a green light(most emachines do) \015\012it sort of sounds stupid but, check the connection of the cable coming from the front of the case(the wi ... E-Machines eMachines Desktop PC

Not turning on, has power and everything


Do any of the fans spin at all, as though it's attempting to boot up? If not, then double check your power supply to see if it has a switch on it and if it does then make sure it's switched into the ON position. If so, then I would recheck the power ... eMachines T3604 PC Desktop

Emachine with XP home edition doesn't start


Hi hearalso, down to the basic's. Replace power cord. \015\012No help there than, remove the case's side panel to expose the motherboard. (Normally it is the left side panel while facing the front of the PC.)\015\012Look closely for a sma ... E-Machines eMachines Desktop PC

[Emachine C2684] Systems appears to be getting power, but won't boot.


Track down the motherboard manual, the motherboards of branded machines are usually made for them by PCChips or Foxconn or someone similar.\015\012In the manual identify wich connectors on the motherbaord is the front power switch. Disconnect t ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4684 seconds