Having problems with your E-Machines eMachines Desktop PC ?

I have the emachine t1100, huge desktop monitor worked fine until I installed a new video card,, the ATI Radeo 7500 64MB PCI. Computer does not boot up but fan goes on. I also disconnectd the card to go back to original configuration, and now I still don't have a monitor or boot-up. I recently installed 2 new SDRAm 256 cards, sound card & dvd drive all at the same time. I can't intall any of the drivers due t6o not being able to see the monitor or access the operating system. It would be gre


Answers :

Try taking out all the newly installed components and see if this restores operation to your computer and monitor. You may have overloaded your system and either the power supply failed you or the motherboard.You might not have damaged anything yet, but you must take out all the new stuff and test. If the power supply failed, the unit will not start. You must check the units operation on start up. See if the fan is working. If not try replacing the power supply and test again to see if you get operation.If not you may have a problem with your motherboard. This should be tested in a service center where they can check the voltages to the motherboard from the voltage regulators. Hope this helps you with your problem.
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Trubleshoot Motherboard what is mother board prob and how can find n fix them....


More than 70% of all computer problems are related to cabling and connections. Ensure all cables are connected and connected firmly. IDE and floppy ribbon cables and power cables can often go loose. Ensure microprocessor, memory modules, and adapters ... PC Desktops

How do you get a computer out of preparing to run system set up? it stays stuck there


Before you start looking at reinstalling Windows you need to back up your important data – just in case anything goes horribly wrong. \015\012\015\012\015\012Reinstallation\015\012loadTOCNode(1, 'summary');\015\012\015\012\015\012\0 ... PC Desktops

New HDD Install Prob


Basic Troubleshooting Tips after Installing a New Hard DriveBased on Seagate IDE hard drives.If you have installed your drive and it does not function properly, perform the following basic checks:Additional Troubleshooting Tip ... PC Desktops

Dell xps m1530 formatted hdd now it wont boot


You might find part of this general trouble shooting process might help? Especially the part of changing you Primary Boot drive so you can load Windows.\012\012Assuming you are Windows based and not knowing your specific OS? \012 Your p ... Dell XPS M1530 Laptop

Dont get vidio at all see drives light up and can


Being able to open a cd or dvd drive only requires power to be going to that unit. The following assumes your monitor is working but is just not displaying anything.What you are describing sounds like you are having a hardware or BIOS iss ... HP Compaq Presario SR2013WM (RE468AA#ABA) PC Desktop

My gateway g7-500 fails to start properly. Whemn power on I get a long beep followed by 2 short ones and the monitor screen remains black.


Cause:This issue can be caused by any of the below situations.\015\012 \015\012\015\012New hardware conflicting with old hardware.\015\012Bad or failing hardware device.\015\012 ... PC Desktops

Computer will not fully boot


It is almost certainly a memory error. First off remove the power cord and the small battery on the motherboard. You may see a jumper near the battery with something like 'rst cmos' next to it. If so pull it off and short it over the other pin. Wait ... HP Pavilion dv8000z Notebook

I have the emachine t1100, huge desktop monitor worked fine until I installed a new video card,, the ATI Radeo 7500 64MB PCI. Computer does not boot up but fan goes on. I also disconnectd the card to go back to original configuration, and now I still don't have a monitor or boot-up. I recently installed 2 new SDRAm 256 cards, sound card & dvd drive all at the same time. I can't intall any of the drivers due t6o not being able to see the monitor or access the operating system. It would be gre


Try taking out all the newly installed components and see if this restores operation to your computer and monitor. You may have overloaded your system and either the power supply failed you or the motherboard.You might not have damaged anything yet, ... E-Machines eMachines Desktop PC

Installation of a 2nd hard drive steps & tips


Step 1: Back up and scout around\015\012 First,\015\012back up your critical files (don't forget your Outlook .PST archive) to\015\012optical discs, an external drive, or online storage. Then check whether\015\012a CD comes with t ... HP Pavilion a1410n (ER890AA) PC Desktop

My compaq desktop computer wont start up it keeps saying NTLDR missing


Hi i have made lil resaerch for this problem so every user who suffurs from this problem can Fixt it on Fixya.com i wish this well helps everyone when u finish rate me plz cuz that was a day and half reasaerch took me a serious hard time but t(his i ... Compaq PC Desktops

Can't set up network w linksys modem


Video card:Your computer has an integrated video card but has a "PCI Express" expansion slot for an upgrade. After the upgrade you will be able to play most games without the choppy frame rate...depending on what card you buy. Since ... PC Desktops

My HP Pavilion a6300f powers up but no signal to the monitor


It could be the motherboard, try resetting the the bios first by either taking the lithium cmos battery out and then replacing after 30 secs or finding the the cmos jumber and unshort it for 30 secs, and reboot the mechine.If the same and ... HP Pavilion Desktop a6300f Intel Pentium Dual-Core E2180 Desktop, Refurbished

COMPAQ SPS-BD 1394 Motherboard - replacing microprocessor / cannibalizing into a Compaq Presario S5010NX, Prod. # DN032A-ABA, with a 2.5GHz Celeron w/ virtual memory problem. Details below


Hi dearwhy not make aconnection with another pc to other pc with crossing cable, you can sharing anything there, file ,printer...and allokecropp ... Compaq Presario 5000 PC Desktop

COMPAQ SPS-BD 1394 Motherboard - replacing microprocessor and memory


I normally ask for more information when people post problems but I can't even be bothered to go through all this driver to get to the root of your problem. Cut out the c**p and give the necessary.\015\012\015\012As a former tech, you should know wha ... Compaq Presario 5000 PC Desktop

My monitor goes to sleep mode at startup & can't access safe mode


Turn the computer off, open the case and remove the RAM. Does the computer beep when you turn it on with no RAM? If not, your motherboard is dead. If your computer beeps, turn it off again and try putting one stick of RAM in. If the co ... E-Machines eMachines Desktop PC

Dell Precision 380 won't boot


I had a similar situation with a work computer; the power supply always tested good. A wiser and more experienced computer guru ordered a new power supply. He gave it to me told me to install it, I did and was laughing the whole time. Well it in fact ... Dell Precision 380 P4 Dual Core 3 GHz (99382) PC Desktop

Monitor says Hi When power on - CPU fan works, graphic card fan works,PSU fan works,. DVD RW opens. Mouse & keyboard transmiter not working,DVD ROM not openning and i cannot hear hard drive working. Monitor is ok, cable ok, I replaced 350W PSU whith 300W in working order then reconnected every possible connetions in the box incl.reseated RAMS, CPU and replaced AGP graphic card with new one, but no luck. OS Windows XP SP2, Processor-3gH Intel Pentium 4, 8Kb primary memory cache,512Kb secondary ca


OK then I would basically do what was posted above except I have seen some motherboards that say to not power up the computer when you try to reset the bios. If it has a jumper to reset it, set the jumper to reset and leave it like that for a few min ... PC Desktops

Blank screen after boot up


This issue may occur if one of the following conditions is true: \015\012Cause 1\015\012\015\012 loadTOCNode(3, 'cause');\015\012 \015\012This issue may occur if you have a CD, a DVD or a floppy disk in your CD, DVD, or floppy drive ... Dell Dimension 3000 PC Desktop

Gibberish + won't finish loading Windows


Remove the new memory first. if that does not help you may have some a virus, indicated by safe mode workng fine. One other thing i found would do that is a damaged Hard drive, not to likely here because safe mode works. ... Dell Dimension E521 PC Desktop

XP won't recognize 2nd SATA drive and shows 1st SATA drive as drive F:


To get Windows to recognize the 2nd HDD, you have to initialize it in disk management.\015\012\015\012http://www.sim ... Dell Dimension 5100 (D51L1) PC Desktop

Installed a new Optical Drive and require assistance in the wiring


What kind of optical drive? Is this a CD, DVD?, Blue ray,or an opto-ferro-magnetic floppy?Generally:1) External drive: ============ a) just power it up and connect it to the PC using an USB or ... PC Desktops

Cannot get new Motherboard to boot up in Normal Mode


What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

Massive series of problems with IBM Thinkpad


Probably itz either minor case of software corruption/improper ground/cpu fan..or major case of faulty or defective main board/ram/addon/daughter cards....plz do check the following as in order:..the Hardwa ... IBM ThinkPad R40 2897 Notebook

How to install windows OS on Samsung N128 netbook


My Windows XP installation has reached its half-life. (You do\015\012know that Windows has a half-life, don’t you? Every installation of\015\012Windows naturally degrades along a logarithmic curve until it becomes\015\012annoying, then ... Samsung N120-12GBK Netbook

It will boot up to the windows screen and freezes.


If your computer was able to boot up but unable to load the Windows, the most common cause would be the recently intstalled software or Windows update.\015\012\015\012To remove this, follow these steps. Skip Step 1 if it is not rel ... HP Compaq Presario SR2011WM PC Desktop
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3459 seconds