Having problems with your E-Machines eMachines Desktop PC ?

I have a Emachines w4682 and the monitor was showing no signal when I turned computer on. I hooked up a different monitor and that one worked so I re connected the original monitor and it worked I then got the computer working except that the USB ports quite working. Stupid me I shut the computer down and when I went to start it up it turned on and back off after less than a minute and now the computer wont turn on at all. Is it the motherboard, the power supply? Any help would be appreciated


Answers :

Possible reasons are bad power switch, bad power supply, bad motherboard, bad memory , device card is not seated properly. Suggest replace power cord to see if still no power, also you may want to remove cover and make sure all your memory and device cards are seated corrrectly. If you get a amber light at the power button, bad motherboard is likely cause
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

MAG innovision LT917s problems


K I just fixed mine! I hope you still have your screen dude. Its easy. Take the screen apart, and take the monitor part off, open up the part thats attached to the back, and remove the big silicon peace thats attached with the golden bolts. Look at t ... Mag Innovision LT976S 19" Flat Panel LCD Monitor

PF790 monitor picture issue


Was it dropped? If so, it could be a board crack or damage to the CRT.\015\012\015\012Was it stored in an unheated garage, shed, or attic, etc.?\015\012\015\012Damp air or widely changing temperatures can cause condensation on the circuit boards.\015 ... ViewSonic PF790 19" CRT Monitor

When i turn on my computer all it tells me is sva no signal input please check video signal


No Signal. No signal coming from the computer.The monitor is working, but there isn't any video signal coming from the computer.1.Could be a bad video cable. The one from the monitor to the computer. Do you have another ... SVA-USA VR 17S 17" Flat Panel LCD Monitor

Monitor displays slowly after the computer starts.


Try to turn off you screen saver just turn off power monitor to see monitor easy wake up after long time.if ok means windows screen saver have problem if still same look like is you monitor something wrong need to check ... Dell Dimension 2400 PC Desktop

I have a Emachines w4682 and the monitor was showing no signal when I turned computer on. I hooked up a different monitor and that one worked so I re connected the original monitor and it worked I then got the computer working except that the USB ports quite working. Stupid me I shut the computer down and when I went to start it up it turned on and back off after less than a minute and now the computer wont turn on at all. Is it the motherboard, the power supply? Any help would be appreciated


Possible reasons are bad power switch, bad power supply, bad motherboard, bad memory , device card is not seated properly. Suggest replace power cord to see if still no power, also you may want to remove cover and make sure all your memory and device ... E-Machines eMachines Desktop PC

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

The monitor turns black immediately after power cycle


I think it can be the capacitor problem, open monitor an look for swollen capacitors. if you will find them swollen or\015\012\015\012\015\012mso ... LG 22" FLATRON LCD Monitor

Hello, I have a Gateway model GT5662, stock setup - Will not boot


Usually, if it's a motherboard that has a failed component on it, you will see failed Electrolytic Capacitors. The small aluminum 'Cans' on the motherboard.Note*The Electrolytic Capacitors that surround the Processor, should have sp ... Gateway GT5662 Desktop PC

No connection from cpu to screen.


By working fine, I assume you mean the monitor goes into its test/diagnostic displays. If that is the case, most likely your roommate has hit upon more or less the correct deduction. Two possibilites should be attempted before assuming to much ... Compaq Presario 7594 PC Desktop

My monitor AOC 912Sw-4 does not turn on. Power button's led is flashing all the time.At the beginning I waited some minutes and I could use it normally, but right now it is impossible see any image on it.


Only choice is to give the monitor for service.\015\012anyway read this, this help you.\015\012is your CPU working properly? if that the case, your monitor is in need of a service.reasons for why a monitor goes blank?Reason ... AOC 912SW-4 Monitor

Dell SP2208WFP Flat Panel Monitor goes straight to power save mode


If the monitor is not turning blue that means it isn't picking up on the signal that is coming to it.\015\012Pushing the power button on the monitor should make the monitor work and give you a no signal note if it isn't getting signal.\01 ... Computer Monitors

Monitor reads: PC entering power saving mode then shuts off;PC on


First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

I have the same problem!


Hi Robert,\015\012\015\012The monitor is on protect mode because an internal fault had been detected.\015\012\015\012To start unplug monitor from power and from computer and test computer with different monitor to find out if it is ... Microtek C893 18.1" Flat Panel LCD Monitor

Massive series of problems with IBM Thinkpad


Probably itz either minor case of software corruption/improper ground/cpu fan..or major case of faulty or defective main board/ram/addon/daughter cards....plz do check the following as in order:..the Hardwa ... IBM ThinkPad R40 2897 Notebook

Hp pavilion dv2000 black screen


This sollution is if your lcd portion of your screen isnt working but you can tell by taking the laptop into a dark room that the backlight is working, you should see a small glow fron the screen.\015\012the nx5000 has a notorious problem for t ... HP Compaq nx5000 Notebook

Loss of light on screen Dell Inspiron E1705


There is a power inverter controlling power to the display, in the monitor of unit, it could be this part needs to be replaced typical repair us$15 part us$45 labor if it changes by moving the monitor it could be the cable that passes through at the ... Dell Inspiron E1705, Intel Core 2 Duo T5300 , 17" WSXGA+ LCD, 1GB DDR2 SDRAM, 256MB ATI V... PC Notebook

Monitor has no picture


Yes! :)Your monitor is not the problem. Check all the connections from the back of the monitor, to the computer."No Signal Analog" means your monitor is working perfectly, however is not receiving signal from the computer. ... ViewSonic VX922 19" Monitor Flat Panel

Desktop monitor port not working. processor, keyboard, mouse all powered on & working, you can hear it boot up. I use this with other computers, it works fine. monitor has power but goes to sleep. Is there another way to connect monitor with a different adapter, as usb port or to serial port?


Ha, no kidding! I just had a HP Pavilion a705w come in for repair at my shop!Small world.Okay, let's go with your theory that the power supply is okay, and the Processor is indeed operating.Your theory is that the ... PC Desktops

Won't shut off, buttons won't work, blue square in top left corner


Unplug the power cord for the monitor for a few minutes ... Microsoft HannsG HU171D 17" LCD Monitor

System Restore... I have tried to run system restore on my computer.It satart to proceed as normal but when the computer restarts its says it couldnt restore to that date and no changes were made.ive tried doing system restore for muerous dates and the same thing happens. Any one know what to do? Help will be very appreciated. Reply Soon


System Restore is a valuable tool Microsoft released with Windows Me and substantially enhanced with Windows XP. (Windows 98 users can only gain this functionality with a third-party program.) Although it is not a backup utility per se, it performs a ... PC Desktops

Power outage,monitor wont power up,hope its not fried


I may or may not make your day. (But I wish you to know that I want to! lol!)I believe it's not your monitor, I believe it's your computer. (Oh, that helped, huh!) However, don't freak out yet, it maybe a simple fix.Let's test ... Gateway FPD2275W LCD Monitor

Does not power up


It's a dreadful way to start a day - you press the power button on your computer and nothing happens. Do not fear because all may not be lost! Follow these simple steps to determine why your computer won't turn on. Note: It is very import ... IBM ThinkPad T22 2647 Notebook

How to repair the monitor of the compaqnx5000 model


The nx5000 has a notorious problem for the monitor going out, sometimes it flickers and sometimes it just doesn't show anything at all. the problem is often easily fixable in less then 20 minutes.\015\012the cable that connects the computer to ... HP Compaq nx5000 Notebook

Screen goes black


This problem is fixable with no parts.\015\012the ribbon cable inside the back of the monitor most likely is loose.\015\012if when the screen goes black you can tell that the back light is still on inside the screen then this fix is definitely ... HP Compaq nx5000 Notebook

DV8309 power up problem: blue lights on for few seconds then off


The inverter inside the lcd panel is most likely your problem. Try removing the whole lcd screen from the laptop if you are capable and run it with the external screen to confirm. leave the lcd switch off (this lcd switch above the power button turns ... HP PC Laptops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.2514 seconds