Having problems with your E-Machines eMachines Desktop PC ?
Emachine tower won't turn on
\015 Hello,I have an Emachines desktop. I have checked that there is power to the case, reseated the cables, there is a small green led that is lit up on the motherboard (Its always on) so I'm assuming its not my power supply.the power supply fan and the case and cpu fans start then all the fans stop with in seconds of start up,I jumped the molex connector and the PS fan will stay on.I tried jumping /shorting the two pins on the MB where the power switch connects and nothing.But no matter what I do the computer will not turn on from the switch So do you have any Ideas?\015
Smps it is on cpu. where u connect power supplty cable it is 1 square box.it is on top[ of cpu back side.
Change your SMPS .it is faulty.
Repair Help & Product Troubleshooting for E-Machines eMachines Desktop PC
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Computer wont turn on
Hi\015\012Bad news. your motherboard has been fried. You could try refashing the BIOS but I've got $10 dollars to your one that it wont work. Best bet - keep the tower, keep all of the running gear but a new motherboard and prosessor are in ord ... E-Machines eMachines Desktop PC
Emachine t5026 on and right off
Hi maybe you could try these steps I'm always doing when I experience the same problem as yours. This is only according to my experience fixing desktop computers.1. Try to disconnect all the connection at the back of your computer tower t ... PC Desktops
My vostro 200 slim tower wont turn on PLZ READ FULL
There could be a hardware problem on the computer if the power button led light is "Orange/ or amber", if you can open the computer, try removing one memory card at a time and see if the power button will change. ... Dell Vostro 200 Mini Tower With 20" Flat Panel Monitor PC Desktop
My emachines wont turn on
Also in addition to the above, try reseating the ram chips..take them out individually and plug them back into their respective slots..might be the miracle cure..If the motherboard fan turns on, it might just be bad memory..replace RAM chips ... E-Machines eMachines Desktop PC
Emachines t2865 My monitor wont turn on, i have it pluged into the tower, but i dont see a power cord for it? does it have a seperate power cord ?
Most Monitors. Have A Seperate Power Cord.\015\012They vary in shape and size. 2 pin 3pin et,c.\015\012Have a good look at the back, and check. you should have a power connector socket inlet. And a cable out socket, to connect Monitor To ... E-Machines eMachines Desktop PC
The tower wont turn on - E-Machines eMachines Desktop PC
Check your power supply. Most common reason for your problem is that the psu has died. Also near your main psu connection on the motherboard should be a little led light. If your board is getting a proper power connection/supply that light should be ... E-Machines eMachines Desktop PC
I have a Emachine W3650 And it wont start up what do i need to do ?
If it's completely dead when you turn it on, you probably have a bad power supply. They're fairly easy to replace and not too expensive unless it's proprietary to your machine, some are. Most towers will take a universal type power supply. Als ... E-Machines eMachines Desktop PC
20 minutes ago my computer was fine, its a packard bell imedia 3051. i turned it off the usual and proper way and switched it off at the wall. i just switched it all back on and now it wont even turn on i press on the on switch and nothing, any suggestions would be great thanks.
I am giving you a step which you should try once and see if it makes any difference.Method (Power cycle)You\015\012need to unplug the power cord from the tower and also remove any other device connected to\015\012the computer ... Packard Bell PC Desktops
Tower won't turn on
Hi try to put the monitor lead in the tower, the leads are both the same, the fuse might be out in the tower lead. ... E-Machines eMachines Desktop PC
Tower wont power up
Check the switch which is putted on the outside of your SMPS. Check the switch/ I think the power connector is loose. Check it. ... E-Machines eMachines Desktop PC
Dell Dimension 2400 won't turn on
Replace the fuse ... Dell Dimension 2400 PC Desktop
It wont stay on
Tried cleaning the insides of the computer... pretty dusty cuz it was an old computer... hey it worked! my conputer is fine... just dont forget to plug everything in! and the code (1 3 3 1) it means theres a bad connection in the tower and the tower ... E-Machines T2642 PC Desktop
Emachine t3524 keep restarting - E-Machines eMachines Desktop PC
Suspect bad Electrolytic Capacitors, in the motherboard Voltage Regulator circuit, of the motherboard. eMachines motherboards are known for having bad 'Caps'. Low quality, due to poor quality of components used in the capacitor. ... E-Machines eMachines Desktop PC
Always says safe mode when I turn on monitor
... Dell UltraScan 1000HS 17 in.CRT Conventional Monitor
Emachines pc help plz
Besides MSN, what else can you not do? ... E-Machines eMachines Desktop PC
Computer wont turn on
It sounds like your power supply went bad as for the cost of one they are about $35 and you could do it your self its easy but if not your prolly lookin at another $20 for someone to put it in please rate me thanks ... Compaq Presario SR1810NX Sempron 3200+ 1.8 GHz Desktop PC ( Monitor Sold Separatley) (ER912AA)
Compaq presario sr1115cl wont power up
Dont u dare ever use 220 line on thes eon usa power u blow it ever time u turn it on at 220 v dont u dare do that not no reset switch erther u must now buy new power supllly ok ... Compaq Presario SR1120NX 2.66GHZ Tower w/ CD-RW (2018267632) PC Desktop
Emachine desktop The computer worked fine one day and the next day when we went to turn it on it would not power up. The monitor comes on and on the monitor screen it said monitor working fine check hard drive. Well I can't check anything because the tower has no power. The light around the button doesn't come on and you can't hear any kind of fan starting. Called emachines and the only thing they could tell me was to change outlets, did that, turn power off (no power) leave unplugged for 3 minu
I understand that your cpu is not turning on and the repairer confirmed that it is the issue with the mother board. I suggest you to please check the smps fan spinning or not. If its spinning then then the issue could be with the mother board. If not ... E-Machines eMachines Desktop PC
Wont go to normal start up screen!!!
The screen that you're seeing is the self-test of the monitor, as it's already stated. It's commonly caused by having no signal coming from the computer to the monitor. You were advised to check the monitor cable, if you have already done that, then ... E-Machines eView 17f3 17" Flat CRT Monitor
Monitor wont go on when the tower is on.
A few steps you can do to try to remedy this:1. Is the monitor on? Sounds simple, but it's happened to me before! 8)2. Try another monitor. If it works fine, then it is clearly your monitor that is the problem, and not the gra ... Microtek 710S 17" Flat Panel LCD Monitor
I purchased an emachine desktop at an estate sale that had a note on the tower saying it had a new had drive installed and never used. So I purchase it and brought it home, hooked it up and turned it on. Much to my disappointment, it would not make any sounds and no lights came on either. I've already contacted emachines and they referred me to you. Can you help?
Is the 'New hard drive installed, never used' bit relevant? Open the tower, get hard drive...\015\012PC bought at auction won't switch on ?? Anything is possible, from 'It's really an empty tower with a brick in it for weight' .. to any number ... Gateway PC Desktops
My emachine T1742 desktop will not turn on. When plugged in the power supply's fan turns on, cpu fan doesnt start, both hdd/power led's flicker and pressing power button doesnt power on/off system.
Disconnect all the devices from the computer(tower) including keyboard, mouse, monitor(everything)..even the power cable\015\012\015\012Now keep on holding down the power button on the computer tower for 15-30 seconds..\015\012 ... E-Machines eMachines Desktop PC
Computer dead my computer wont turn on, the only thing that works is the cooling fan on the cpu. the computer wont turn off when you reboot it.
Hi Guys\015\012\015\012Bad news. I have one dollar to your ten that your motherboard has been fried. You could try refashing the BIOS but I've got $10 dollars to your one that it wont work. Best bet - keep the tower, keep all of the runni ... Sunon (16-02-006) Fan Kit
When i turn on my emachines 420 at the mains, the led power light comes on, but it wont do anything else including turning on or off
Hello there,this sounds like a problem with your power supply unit inside the computer,emachines are always blowing there power supply because the one that comes with the computer just is not powerful enough.If you are confident enough around electri ... E-Machines eMachines Desktop PC
Gatweway lap top button light up, but wont turn on
I'm afraid this sounds suspiciously like a motherboard problem. It would help to know what model etc, as some Gateway & EMachine model laptops have had extended warranties due to motherboard issues, or just go to Gateway.com and research it yours ... PC Laptops